User manual PLANTRONICS PULSAR 590A

TABLE OF CONTENTS Attention! PLEASE REVIEW THIS USER GUIDE CAREFULLY BEFORE USING YOUR PRODUCT. If you need further assistance please contact Plantronics at (866) 363-BLUE (2583). Troubleshooting information can be found on page 13 and also on the web at www.plantronics.com/support. Please do not return the product to the store where it was purchased. Register Your Product Online Visit www.plantronics.com/productregistration to register your product online so we can provide you with the best possible service and technical support. PACKAGE CONTENTS 2 FEATURES 3 FEATURES 4 CHARGING Note: Charge for 3 hours before first use. 1. Connect AC charger to desktop charging stand and universal adapter. 2. Lift and position earpieces inside headband so foam ear cushions face each other. 3. Place headset into desktop charging stand. Headset indicator light flashes when charging. 5 POWERING Slide power switch up for "on" and down for "off." To turn on, rotate dial counterclockwise so solid dots are aligned. To turn off, rotate dial clockwise until the open dot and solid dot are aligned. 6 PAIRING Pairing with Bluetooth® Device 1 2 Begin with headset turned off. 1. Press and hold the call control button. 2. Power headset on and when the indicator light flashes red and blue, release the call control button. While headset is flashing red and blue: 3. Use the phone menu to search for Bluetooth devices and select "590 Plantronics." 4. When prompted for passkey, enter 0000. Headset will flash blue when paired successfully. For set up and pairing instructions with Bluetooth devices other than mobile phones, please consult your Bluetooth device user guide. 7 PAIRING Pairing Headset with Universal Adapter NOTE: The Pulsar 590A headset is paired with the universal adapter at the factory. If adapter and headset continue to flash red rather than blue, connect or pair them again. To reconnect, press the adapter pairing/connect button. To pair again, follow directions below. 1 2 Begin with headset turned off. 1. Press and hold the call control button. 2. Power headset on and when the indicator light flashes red and blue, release the call control button. While headset is flashing red and blue: 3. Power adapter on. 4. Press and hold the adapter pairing/ connect button for 7-10 seconds. When adapter is flashing red and blue, release the button. Headset and adapter will flash blue when paired successfully. 8 ADJUSTING FIT Position headset so that telescoping voice tube is on right ear. Adjust headband if necessary. Point tip of telescoping voice tube toward mouth and extend for optimal voice transmission - may require two hands. 9 IN-FLIGHT AND WIRED USES In-flight cable can be used with any 3.5mm audio jack to convert your wireless headset into wired headphones. Headset will not operate when in-flight cable is connected and headset is powered on. 1. Power headset off. 2. Insert in-flight cable into 3.5mm jack on left earpiece. Note: Telescoping voice tube and all headset controls are disabled when in-flight cable is in use. To control volume, use the device connected to the in-flight cable, not the headset. 10 HEADSET CONTROLS 11 HEADSET CONTROLS 12 TROUBLESHOOTING 13 PRODUCT SPECIFICATIONS TECHNICAL ASSISTANCE REGULATORY NOTICES 14 © 2005 Plantronics, Inc. All rights reserved. Plantronics, the logo design, Pulsar and Sound Innovation are trademarks or registered trademarks of Plantronics, Inc. The Bluetooth name and the Bluetooth trademarks are owned by Bluetooth SIG, Inc, and are used by Plantronics, Inc. under license. Printed in USA. August 2005. Part #69828-07