® Inox 1000 R VA P O R E L L A I N O X 1 0 0 0 ENGLISH 1) 2) 3) 4) 5) 6) 7) 8) 9) Iron temperature adjustment Water heater ON/OFF illuminated switch Steam button Iron on/off illuminated switch Patented safety cap Iron rest Power cable Monotube (cable + steam tube) Filler funnel 1 2 3 4 5 6 7 8 Polti S.p.A. reserves the right to change equipment or accessory specification without prior notice. PLEASE READ THE FOLLOWING BEFORE USE · · Before using your Vaporella carefully read these usage instructions. Before connecting Vaporella to the mains make sure that the current is the same as indicated for the machine and that the plug is an earthed plug. Do not put any detergent or chemical substance in the tank. Water by its nature contains magnesium, mineral salts and other deposits which in hard water areas can contribute to limescale build up in the tank. To avoid these problems, it is necessary to swill out with tapwater and empty the generator tank after every 3 or 4 uses.In very hard water areas we recommend the use of our KALSTOP FP 2003, a special natural-base decalcifier which inhibits and breaks down limescale, making it easy to remove just by swilling out the tank with a little tapwater. This is a preventive against scale build-up and protects the metal walls of the steam generator tank. KALSTOP is available from Polti dealers or by mailorder from your Polti Service Centre. · · · · · · Do not refill the tank while it is still hot, allow it to cool down for a few minutes before refilling. During filling and refilling we recommend you to disconnect the appliance from the mains supply. Never empty Vaporella when the water inside the generator tank is still hot. Do not place the appliance in water or in any other liquids. Do not touch the appliance with wet hands or feet whilst the appliance is connected to the mains. Never leave the appliance unattended whilst it is connected to the mains. 2 Fig. 4 9 · Fig. 1 Fig. 2 Fig. 3 ENGLISH VA P O R E L L A I N O X 1 0 0 0 · Do not allow Vaporella to be used by children or by people who are not familiar with the usage instructions. We recommend that the appliance is disconnected from the mains whenever it is not in use. When REfilling the generator tank, use HOT rather than cold water, pour in gently at first and keep your face away. Otherwise the still hot tank walls can spit drops of very hot water or steam spray. Do not leave the appliance exposed to wind or rain. Do not lay the hot appliance on surfaces sensitive to heat. Do not use electric extension leads that are not authorized by the manufacturer, as they may cause damage or fire. In case of breakdown or malfunction switch off the appliance and never attempt to disassemble it, but refer to an authorized service center. In case of accidental fall of the appliance it is necessary to have it checked by an authorized service center as the internal safety features may have been affected. Never direct the jet of steam towards small particles of debris without first protecting the user's eyes. steam position (fig. 3), by turning the knob (1). All types of fabric can be ironed at this temperature. 2b. Wait for the heater illuminated a switch (2) and the steam button (3) to go out. Push button (3) on the iron to release bursts of steam from the holes on the soleplate. Release the button and the steam will stop (fig. 4). If the heater illuminated switch (3) comes on during use, continue ironing as it is quite normal. NOTE: during initial operation of the iron, a few drops of water mixed with steam may come out of the soleplate until the temperature stabilises. It is advisable to direct the first jets of steam onto an old cloth until a uniform stable jet of steam is obtained. DRY IRONING 1c. For dry ironing, connect the supply cable to the mains, push the iron on/off switch (4), regulate the temperature of the iron by turning the knob (1) to the required temperature for the fabric shown on the knob itself. · · · · · · · · PAT E N T E D S A F E T Y C A P / " WAT E R O U T " All Polti machines are equipped with the unique Polti patented safety cap, which prevents opening of the generator tank as long as there is any pressure remaining inside the tank. This is an important and indispensable safety device, and it is necessary to follow certain procedures when re-filling the tank. When you have used up all the water in the tank, do as follows: 1a. Switch off the heater on/off switch (2). 2a. Press the steam request button on the iron (3) so as to fully exhaust the steam supply from the tank. 3a. Disconnect the power supply cable from the mains. 4a. Unscrew anti-clockwise the patented safety cap (5). 5a. Wait for a few minutes to allow the generator tank to cool down. 6a. When cool proceed to carefully refill the tank as described in paragraph 1a of the section "PREPARATION FOR USE" in the instructions. If refilling the generator when not completely cooled, we recommend that you carefully pour only very small quantities of water at each pouring into the tank, so as to avoid spitting from the tank. I M P O R TA N T Before leaving our factory all our products are rigorously tested. However, your VAPORELLA may contain some residual water in the boiler P R E PA R AT I O N F O R U S E 1a. Unscrew the patented safety cap (5) and fill the boiler with about 0.8 litres of water using the special funnel (9) making sure that it does not overflow (fig. 1). Normal tapwater can be used. However, as hard water by its nature contains limestone, which may cause a build-up of limescale in the tank, in hard water areas we recommend the use of our natural-base decalcifier KALSTOP FP 2003. 2a. Retighten the cap fully and carefully. 3a. Connect the power supply cable into an earthed power supply of the correct voltage. 4a. Switch on the boiler and iron by pressing the switches (2) and (4) (fig. 2). I M P O R TA N T · · Do not leave the iron unattended whilst connected to the mains. Iron only on heat resistant surfaces and on surfaces that allow the steam to escape e. g. mesh ironing boards. INSTRUCTIONS FOR USE STEAM IRONING 1b. Set the iron temperature to the "COTTON - LINEN" 3 ENGLISH VA P O R E L L A I N O X 1 0 0 0 · Ensure the patented safety cap is fully and correctly screwed on, otherwise you may experience steam escaping from around the cap. The steam botton (3) may go on and off from time to time during use of Vaporella. This indicates the machine maintaining the correct and constant pressure and is quite normal. If no steam is released from the iron, check the following: the steam botton (3) is lit up; there is water in the boiler. If repairs or replacement parts are required, and in particular the special safety cap, use only original Polti replacement parts. The appliance is fitted with a safety thermostat, which should only be replaced by an authorised technician. If it is necessary to replace the power supply cable, please refer to the nearest Polti authorised service centre, since the use of a special tool is necessary. In the case of breakdown or malfunction do not attempt to repair the appliance yourself but refer to your nearest authorised service centre. WARNING - This appliance must be earthed. This appliance may be fitted with a non rewirable plug, if it is necessary to change the fuse in a non rewirable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement, available from the appliance manufacturer, is obtained. It is important that the colour of the replacement fuse cover corresponds with the colour marking on the base of the plug. If the plug requires to be changed because it is not suitable for your socket, or becomes damaged, it should be cut off and an appropriate plug fitted following the wiring instruction (below). The plug removed must be disposed of safely as insertion into a 13A socket is likely to cause an electrical hazard. · · · · · · GREEN & YELLOW (Earth) FUSE (13 amp) C A R E O F Y O U R VA P O R E L L A · Before attempting any maintenance operation, be sure to always disconnect the appliance from the mains. Normal tapwater can be used. However, as hard water by its nature contains limestone, which may cause a build-up of limescale in the tank, in hard water areas we recommend the use of our natural-base decalcifier KALSTOP FP 2003. To clean the body of the appliance, simply use a moist cloth. Do not use solvents or detergents which may harm the body material. Polti declines liability for any damage or accident derived from any use of Vaporella which is not in conformity with the instructions contained in this booklet. BLUE (Neutral) BROWN (Live) · · · FOR YOUR OWN SAFETY READ FOLLOWING INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO CONNECT THIS UNIT TO THE MAINS. M A I N S ( A C ) O P E R AT I O N ( o n l y U . K . ) This unit is designed to operate on 240V, 50 Hz current only. Connecting it to other power sources may damage the unit. As the colours of the wires in the mains leads of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter "E" or by the earth symbol or green-andyellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter "N" or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter "L" or coloured red. 4 ENGLISH IMPORTANT This wires in this mains lead are coloured in accordance with the following code. · Green-and-yellow: Earth · Blue: Neutral · Brown: Live ...