7" WIDE SCREEN 16:9 TFT-LCD MONITOR PLVSHR77 1. Table of Contents------------------------------------- 1 2. Warning ----------------------------------------------- 1 3. Installation -------------------------------------------- 2 4. Features ----------------------------------------------- 3 4.1 Features ------------------------------------------- 3 4.2 Remote Control Bar ------------------------------ 3 4.3 Function keys at front panel --------------------- 4 5. Installation for Monitor ------------------------------ 5 6. Accessories ------------------------------------------- 7 7. Specifications ---------------------------------------- 7 1 3. INSTALLATION 1. Rotate the locking knob on the neck of the mounting stand clockwise. 2. Slide the engagement head on the mounting stand into the slide bracket slot on the rear of the monitor housing. 3. Rotate the locking knob counterclockwise until it is hand-tight and the monitor is securely fastened to the neck of the mounting stand. 4. Locate a desirable spot in your vehicle for the monitor. Hold it place there, with the mounting plate resting in approximately the right location and have a friend sit in the seat from which you intend viewing of this monitor to take place to confirm the location of the monitor. If necessary, loosen the angle adjustment knob and rotate the monitor to a more ideal angle and retighten., 5. Once you have confirmed the location of the monitor, remove the adhesive backing from the underside of the mounting plate and firmly press all the "petals" of the mounting plate down to the car surface. Temporarily remove the monitor by loosening the locking knob, and use three screws in the locations indicated in the drawing below to further secure the monitor mounting plate. If necessary, drill pilot holes to assist in inserting the screws. 6. Reinstall the monitor onto the neck of the mounting stand and tighten the locking knob. Adjust the monitor angle again as required, being sure to tighten the angle adjustment knob when you are done. 2 4. Function: 4.1 Features 8 10 RED 11 YELLOW 12 RED 13 BLACK 9 1. Headphone Jack 2. Power 3. UP key 4. IR Sensor 5. Down key 6. Menu 7. AV-IN Jack 8. Interface cable 9. System Cable 10. Audio in (Red RCA Jack) 11. Video in ( Yellow RCA Jack) 12. Power Wire (Red) 13. Grounding Wire (Black) 4.2 Remote Control Bar TV/CATV TV/AV MUTE POWER 1234 5678 90 FM/AM Monitor POWER MUTE SETUP + VOL CH DN UP FUNC - MODE FUNC UP MODE DOWN To adjust functions of Monitor, use only 5keys: Power: Press the Power button for ON/OFF Mute: To shutdown Audio output Function: Press the Function button to access On Screen Display Menu of: CONTRAST / BRIGHTNESS / COLOR / SHARPNESS / SOURCE IN / VOLUME / MODE / LEFT RIGHT / RECALL / EXIT UP+: To Adjust Volume Up DN-: To Adjust Volume Down MODE: Selection button for AV1 / A V2 3 4.3 FUNCTION KEYS AT FRONT PANEL 1. MENU FUNCTIONS CONTRAST: BRIGHTNESS: COLOR: SHARPNESS: SOURCE IN: VOLUME: MODE: LEFT / RIGHT: RECALL: EXIT: Press or to adjust Contrast. Press or to adjust Brightness. Press or to adjust Color. Press or to adjust Sharpness. Selection button for AV1 / AV2 Press or to adjust Volume. 16:9 / 4:3 Left/Right Revolving The Display will Return to The Original by Factory. Exit Menu Mode. 1. POWER Press the POWER button once it will be power ON. Press it again. The will be power OFF. 2. UP / DOWN Press "UP+" or "DN--"directly is to adjust volume. Using MENU button together can adjust the other functions. 4 5. Installation for Monitor Note It is recommended that the fitting is carried out at a specialist workshop. 5 8 Release Key 6 6. ACCESSORIES (1) Monitor Stand x 1 (2) System Cable x 1 (3) Operation Manual x1 (4) Release Key x1 (5) Remote Controller x 1 (6) Warranty Card x 1 7. Specifications 1. Supply voltage 2. Power consumption: 3. Operating temperature: 4. Storage temperature: 5. Monitor screen size 6. Operating system 7. Resolution 8. Monitor overall dimension: 9. Monitor weight: 10. System 11. Viewing angle (L/R; T/D): 12. Video input range: 13. Audio input range: 14. Audio output power: 12Vdc 10% 1A 10% 0 C ~+ 60 C -25 C ~ +70 C 7" ( 16: 9) TFT active matrix. 1440 x 234 dots. 190(W) x 126.8(H) x 36(D) mm. 450 20 g NTSC / PAL Dual System View Area L/R:45/45 :Top/down :30/60 degrees 0.5~1.25Vp-p/75 Ohms composite signal. 0~1.5Vp-p/620 Ohms 50Hz ~ 20K Hz. 0.5W(Max.) The specifications are subject to change without prior notice. 7 ...