User manual PYRAMID 401EP

® HIGH PERFORMANCE CAR AUDIO MODEL 401EP IN-DASH 4 BAND PARAMETRIC EQUALIZER www.pyramidcaraudio.com FEATURES: 1. 3.5MM DVD INPUT JACK 2. FADER CONTROL 3. DVD/AUX INPUT SELECTOR SWITCH 4. BI-COLOR LIGHT ILLUMINATION WITH SELECTOR 5. VOLUME CONTROL 6. SUB BAND EQUALIZER CONTROL 7. LOW BAND EQUALIZER CONTROL 8. MID BAND EQUALIZER CONTROL 9. HIGH BAND EQUALIZER CONTROL 10. SUB CROSSOVER FREQUENCY 30-250 HZ ADJUSTABLE 11. SUB OUTPUT VOLUME CONTROL 12. DVD INPUT PORT 13. AUX INPUT PORT 14. SUB OUTPUT PORT 15. FRONT OUTPUT PORT 16. REAR OUTPUT PORT 17. AUX INPUT GAIN ADJUSTMENT 18. DVD INPUT GAIN ADJUSTMENT CONTROLS: 1 OPERATION: 1. 3.5MM DVD INPUT JACK Connects to the DVD source with 3.5mm plug cable. 2. FADER CONTROL This control adjust the volume between the front and rear speakers in a 4 speaker system. 3. DVD/AUX INPUT SELECTOR SWITCH This switch selectors the DVD or AUX input. 4. ILLUMINATION SELECTOR SWITCH This switch allows to select the color of light illumination. 5. VOLUME CONTROL This control adjusts the output level. 6-9. 4 BAND PARAMETRIC EQUALIZER CONTROLS This four-band equalizer gives you to control over the output levels at various frequency. 10. SUB CROSSOVER FREQUENCY 30-250 HZ ADJUSTABLE Lets you adjust the subwoofer crossover frequency from 30 to 250 Hz. 11. SUB OUTPUT VOLUME CONTROL This control adjusts output level of subwoofer RCA jack. 12. DVD INPUT PORT Connects the RCA cable to the output of DVD player. 13. AUX INPUT PORT Connects the RCA cable to the output of auxiliary source. 14. SUB OUTPUT PORT Connects the RCA cable to the subwoofer channel amplifier input. 15. FRONT OUTPUT PORT Connects the RCA cable to the front channel amplifier input. 16. REAR OUTPUT PORT Connects the RCA cable to the rear channel amplifier input. 17. AUX INPUT GAIN ADJUSTMENT Allows you to adjust the left and right channel input sensitivity level separately to match the output level for AUX source input. 18. DVD INPUT GAIN ADJUSTMENT Allows you to adjust the left and right channel input sensitivity level separately to match the output level for DVD source input. 2 MOUNTING INSTRUCTION : 4 x 6 mm machine screw (4) dashboard Signal Processor enclosure Mounting Bracket 4 x 12 mm self-tapping screw (2) 4 mm spring washer (2) 4 mm plain washer (2) 3 ELECTRICAL WIRING DIRECTIONS 4 SPECIFICATIONS: 4 Band Parametric . . . . . . . . . .Sub 50Hz, Low 210Hz, Mid 1KHz, Hi 20KHz Boost/ Cut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18dB Crossover Frequency . . . . . . . . . . .Continuously variable from 40 to 400 Hz Frequency Response . . . . . . . . . . . . . . . .20-20,000 Hz ( at ±3dB, 400mV) Input Level, Front/Rear (for 400 mV Output) . . . . . . . . . . . . . . . . . . .200mV Total Harmonic Distortion . . . . . . . . . .Less than 0.025% (at 400mV Output) Output Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.2K Ohm Single-to-Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .85 dB Separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60 dB Control Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±12 dB Current Drain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .200mA Maximum Power Supply Voltage . . . . . . . . . . . . . . . .DC, 10-16 Volt Negative Ground Dimensions (WDH) . . . . . . . . . . . . . . . . . . . . . . . . . . . .178 x 113 x 25 mm 5 NOTES