E-Series Networked Display Installation Manual Document Number: 87043_2 Date: March 2006 Trademarks and registered trademarks Autohelm, HSB, Raymarine, RayTech, RayTech Navigator, Sail Pilot, SeaTalk and Sportpilot are registered trademarks of Raymarine Limited. Apelco is a registered trademark of Raymarine Holdings Limited (registered in all major marketing territories). AST, Autoadapt, Auto GST, Autoseastate, Autotrim, Bidata, Marine Intelligence, Maxiview, On Board, Raychart, Raynav, Raypilot, Raystar, ST40, ST60, Seaclutter, Smart Route, Tridata and Waypoint Navigation are trademarks of Raymarine Limited. Navionics is a registered trademark of Navionics Company, Italy. All other product names are trademarks or registered trademarks of their respective owners. Copyright: ©Raymarine 2006 Important Information i Important Information Intended use This handbook provides information and instructions to assist in planning and installing your Raymarine E-Series Networked Display, together with information that will be useful when you are connecting the E-Series Display to other equipment. In order to obtain the best results in operation and performance, please read this handbook thoroughly. Safety notices WARNING:Navigation aid This product is intended to be used as an aid to navigation. Its accuracy can be affected by many factors, including equipment failure or defect, environmental conditions and incorrect handling or use. It is the Users responsibility to exercise common prudence and navigational judgement. This device should not be relied upon as a substitute for such prudence and judgement. WARNING:Product installation This equipment must be installed in accordance with the instructions in this handbook. Failure to do so could result in poor product performance, personal injury and/or damage to the vessel. WARNING:Electrical safety Make sure the power supply is switched off before making any electrical connections. WARNING:Electromagnetic energy The radar scanner transmits electromagnetic energy. Ensure that the scanner has been installed according to the recommendations given in the relevant scanner handbook. WARNING:Fishfinder sounder module Removing the transducer cable from the fishfinder sounder module whilst it is switched on can cause sparks and may damage the unit. Only remove the transducer cable after power has been switched off. Ensure that the sounder module is mounted where it is well ventilated and in an area free from flammable vapors. ii E-Series Networked Display Installation Manual CAUTION: Radar Scanners, Cables & Installation Information on radar scanners, cables and their installation contained in this handbook supersedes that contained in the Pathfinder Radar Scanner Handbook, Document No. 81154_8, dated 12th January 2005. CAUTION: Front cover clip-on installation After installing the front cover clip-on, check that all buttons and soft keys have passed through completely and are free to operate correctly. CAUTION: Global Positioning System Antenna Do not connect or disconnect the GPS antenna from the display unit whilst power is switched on. Doing this may result in irreparable damage CAUTION: Water Ingress To prevent the ingress of water and damage to the display: · Ensure that the chart card door is firmly closed. This can be confirmed by an audible click. · Do not remove the SeaTalk High Speed blanking plug from the rear of the display until such time as you are ready to connect the cable. · Ensure that the SeaTalk High Speed cable is clicked into place AND then turned to lock it. CAUTION: Connections into display Ensure power is switched off prior to connecting or removing any cables into the rear of the display. Failure to do so can cause irreparable damage. CAUTION: CompactFlash Card Installation When installing CompactFlash cards ensure that the card is being fitted the correct way round. DO NOT try and force the card into position as this may result in irreparable damage to the card. CAUTION: CompactFlash Cards Removing the CompactFlash card whilst information is being written to it may cause damage to the card and loss of all data. A warning on the display indicates when writing is in progress. CAUTION: Chart and CompactFlash card damage DO NOT use a metallic instrument such as a screwdriver or pliers to help you remove a card, as doing this can cause irreparable damage to the card and/or display unit. Important Information iii EMC Conformance All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. The design and manufacture of Raymarine equipment and accessories conform to the appropriate Electromagnetic Compatibility (EMC) standards, but correct installation is required to ensure that performance is not compromised. Handbook information To the best of our knowledge, the information in this handbook was correct when it went to press. However, Raymarine cannot accept liability for an inaccuracies or omissions it may contain. In addition, our policy of continuous product improvement may change specifications without notice. Therefore Raymarine cannot accept liability for any differences between the product and the handbook. Disposal Waste Electrical and Electronic Equipment (WEEE) Directive The WEEE Directive requires the recycling of waste electrical and electronic equipment. Whilst the WEEE Directive does not apply to some of Raymarine's products, we support its requirements as part of our environmental policy and we ask you to be aware of how you should dispose of this product. The crossed-out wheelie bin symbol found on our products signifies that it should not be disposed of in general waste or landfill. Please contact your local dealer, national distributor or Raymarine Technical Services for information on product disposal. iv E-Series Networked Display Installation Manual 1 Contents Chapter 1: Preparation for installation ..................................................................3 1.1 General information ............................................................................................. 3 Contents of this pack ....................................................................................... 3 Dimensions ..................................................................................................... 4 Accessories and spares ................................................................................... 5 1.2 Planning the installation ....................................................................................... 6 EMC Installation Guidelines ............................................................................ 6 Locating the display ........................................................................................ 7 EMC Conformance .......................................................................................... 7 Chapter 2: System Integration .................................................................................9 2.1 What is System Integration? ................................................................................. 9 What is SeaTalk? ............................................................................................. 9 What is NMEA? .............................................................................................10 2.2 Compatibility ......................................................................................................11 Radar Scanners .............................................................................................11 Digital Sounder Module ................................................................................11 Engines .........................................................................................................11 Media storage cards ......................................................................................12 2.3 Functionality .......................................................................................................12 Data or equipment required for applications/functions .................................13 2.4 Integrating an E-Series display ............................................................................14 Single display system ....................................................................................15 Networking E-Series Displays ........................................................................16 A typical two node system incorporating two displays ..................................17 An example of a three (or more) node system ...............................................18 Connecting your E-Series display to a SeaTalk2 Keyboard .............................19 Chapter 3: Installation .............................................................................................21 3.1 Mounting the display ..........................................................................................21 Trunnion mount ............................................................................................21 Flush mount ..................................................................................................23 Attaching the front cover clip-on ...................................................................24 Removing the front cover clip-on ..................................................................25 2 E-Series Installation Manual 3.2 Cables .................................................................................................................26 Siting and securing cables .............................................................................26 Connecting cables .........................................................................................26 Cable types ...................................................................................................28 Chapter 4: Commissioning the system .................................................................37 4.1 Introduction ........................................................................................................37 4.2 Pre-start checks ..................................................................................................37 4.3 Initial power on procedure ..................................................................................38 4.4 Testing and checks ..............................................................................................39 Radar checks and alignment .........................................................................39 GPS checks ....................................................................................................41 Heading data checks .....................................................................................42 Chart application checks ...............................................................................42 Fishfinder application tests ...........................................................................43 Video tests ....................................................................................................43 SeaTalkhs network switch connection tests ..................................................44 Setting up the NMEA for AIS or Navtex .........................................................44 Instrument data tests ....................................................................................44 Running AIS ..................................................................................................45 Weather application tests .............................................................................45 4.5 Advanced Settings ..............................................................................................46 Adjusting the settings ...................................................................................46 Chapter 5: Troubleshooting ....................................................................................49 5.1 How can I troubleshoot my Display? ...................................................................49 5.2 How can I get Technical Support? .......................................................................50 World wide web ............................................................................................50 Help us to help you ........................................................................................50 How can I contact Raymarine in the US? .......................................................51 How can I contact Raymarine in Europe? ......................................................52 Chapter 1: Preparation for installation 3 Chapter 1: Preparation for installation 1.1 General information Contents of this pack The E- Series (E80 or E120) Networked Display pack contains the following items: Part no. E80 E02011 R58183 R58184 R89005 R08004 E55054 E55049 E55057 E120 E02013 R58194 R58195 Part name Networ ...