AdvanceTrakTM Parts Instruction Sheet 12AR300 Snap Rivets Aluminum Rail Metal Clip V clip End Cap Instructions for assembly Note: Each graphic should already have predrilled holes for snap rivets. Step 1 Insert snap rivets into each predrilled hole. Snap together. Fig. 1. Step 2 Slide graphic into aluminum rails (top and bottom). Rails will conceal snap rivets. Fig. 2. Figure 1 Figure 2 Step 3 Insert metal clips into channel of top aluminum rail. Fig. 3. Slide into place. Step 4 Insert V clip through hole in metal clips. Fig. 4. Hang V clip from ceiling grid. Note: Repeat steps 1-4 for each of your graphics. Be sure to hang graphics close enough together so they can be joined. Figure 3 Figure 4 Step 5 Insert end caps onto rails. Fig. 5. Note: If you are using multiple panels, do not insert end caps. Jump to Step 6 on next page. Figure 5 Page 1 of 2 The AdvanceTrakTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #03INSAdvanceTrak 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays.com Incept-4.8.03 AdvanceTrakTM Parts Instruction Sheet 12AR300 Aluminum Rail Joiner Bar End Cap Instructions for connecting multiple panels Step 6 On one panel, insert one joiner bar into top channel of top aluminum rail and one joiner bar into bottom channel of bottom aluminum rail. Slide joiner bar into corresponding channels of connecting rails on second panel. Fig. 6. Slide rails together. Fig. 7. Figure 6 Repeat Step 6 for additional panels. Note: Apply tape to the back of graphic panels to secure seam. Figure 7 Step 7 Insert end caps onto rails. Fig. 8. Figure 8 Page 2 of 2 The AdvanceTrakTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #03INSAdvanceTrak 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays.com Incept-4.8.03 ...