SH-S183L(TS-H653L)ENG RUS 1904.1.23 8:53 AM Page 1 DVD Writer SH-S183L(TS-H653L) Safety Precautions The following are basic precautions to ensure user safety and reduce the risk of property damage. Warning/Caution Warning: Caution: To warn the user that failure to comply with the instructions may result in serious injury or death. To caution the user that failure to comply with the instructions may result in damage to property. Introduction · Design and specifications are subject to change without prior notice. Connecting the Cables to the DVD Writer Connecting the Cables Eject Button User's Guide - ENGLISH FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be deter-mined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Re-orient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. When you install the drive Place the drive on a level surface. · Failure to do so may cause the device to fall onto a hard surface, resulting in damage or malfunction. Disc compartment · Do not place the drive in direct sunlight. · Avoid low- or high-temperature environments. · Avoid high-humidity environments. Front S-ATA Data cable S-ATA Power cable Emergency eject hole LED While operating Handle with caution to prevent damage from external shock. Do not drop the drive, and protect it fromsevere shocks. · It can damage the drive or cause it to malfunction. Do not move the drive while in operation and do not attempt to open the disc tray byforce. Make sure to close all working programs before attempting to open the tray and always use the open/close button. If the compartment does not open when you press the Eject button, CAUTION Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user 's authority to operate the equipment. IEC 60825-1 :1993 +A1 :1997 +A2 :2001 Do not use cracked, distorted or damaged discs. power off the computer, insert a pin or unfolded paper clip in the hole and push firmlhy) 1 2 Connecting the power cable · The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal the rear of the DVD Writer drive. LASER STANDARD WEEE Correct Disposal of This Product (Waste Electrical &Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature,indicates that it should not be disposed with other household wastes at the end of its working life.To prevent possible harm to the environment or human health from uncontrolled waste disposal,please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product,or their local government office,for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract.This product should not be mixed with other commercial wastes for disposal. · Samsung Eco-mark The Samsung's own Eco mark helps consumers to easily understand that Samsung develops eco-friendly products. This mark represents Samsung's continuous effort to develop eco-friendly products. Do not insert a pin into the emergency opening while in operation. In particular, a disc with a crack on the inner tracks may break while in use. S-ATA Power cable S-ATA Data cable Connecting the S-ATA cable S-ATA Data cable S-ATA Power cable Other · Never allow food particles or foreign substances to enter the drive casing. Rear · To protect against the risk of fire, do ot spill such liquids as alcohol and benzene on the drive. Do not disassemble, attempt to repair or modify the device without express approval as directed in the manual. 1. Check to see that the disc does not have a crack before use. If the disc has a crack (especially around the center hole), it is recommended that you make a copy immediately and use the copy instead. When a cracked disc is used continuously,the size of the crack is likely to grow and it will eventually result in irreparable damage to the disc. 2. Do not use low quality discs (i.e., illegal products, scratched or damaged discs). · To reduce the risk of damage, electric shock, and fire. Accessories Application software & User manual CD , S-ATA Power Cable 1ea , S-ATA Data Cable 1ea, Setup Guide , Screw 4ea · RoHS (Restriction of the use of certain hazardous substances in electrical and electronic equipment) The RoHS, the environment regulation announced by European Union, restricts the use of lead, mercury, cadmium, hexavalent chromium, PBB, and PBDE in products put on the market in The European Union after July 1, 2006. BG68-01306A REV.01 · Any change or modification not expressly approved by designated qualified personnel could void your authority to operate this device. Important to read and understand at all times Do not disassemble Design and specifications are subject to change without prior notice. - http://www.samsung-ODD.com - http://www.samsung.com 1 2 3 4 Installing the Drive When using one S-ATA cable Drive Using the Drive/Storing and Cleaning Your Discs Using the DVD Writer Solving Technical Problems · The friction noise generated during SPIN-UP and STOP is caused by the Technical Specifications Category SH-S183L(TS-H653L) DVD Writer DVD : DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM, DVD-Video, DVD+R(DUAL) , DVD-R(DUAL), LightScribe DVD±R, DVD-RAM System Requirements S-ATA supported PC (The compatible motherboard list can be found from the website) 256Mbytes or above Windows 2000/XP/Vista Automatic Ball Balancing System(ABS) and is not a malfunction. The tray won't open. Installing the DVD Writer How to install the DVD Writer on your PC. First, remove the cover; connect the cable to the DVD Writer and then to the PC. Hard Drive MainBoard 1 2 3 4 Push the power button and boot the computer. After booting the computer, open the disc partment by pressing the Eject button. Insert the disc (CD) with the label on the disc facing upwards and close the disc compartment by pressing the Eject button. The indicator light comes on. Play the disc (CD). com- · See if the PC on. · Make sure the power cable within the PC is connected properly. · If the tray still won't open with the power on, turn the power off and insert a pin(paper clip) into the emergency hole to open. Usable Discs DISC The tray won't close. The PC is not working properly. · Make sure the disc has been inserted properly. · See if the jumper(s) is properly connected to the Master/Slave · Selection port. See if the drive is properly connected to the PC. See if the floppy disc remains in the PC. C D : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G) CD-MIDI, CD-TEXT, CD-ROM XA, Mixed Mode CD , CD-I, CD-I Bridge (Photo-CD, VideoCD), Multisession CD(Photo-CD, CD-EXTRA, Portforio), LightScribe CD-R Disc Diameter Interface Support Access time (Random) Setting 4.72 Inch or 3.15 Inch (120mm or 80mm) S-ATA S-ATA 1.5Gbps 110ms (Random) 130ms (Random) Titles and contents Less than 9 min Less than 7 min Less than 4 min Write CAV18X(MAX24.3MB/sec) Interface Port Burst Transfer Rate CD-ROM DVD-ROM Titles only Less than 4min Less than 3 min Less than 2 min 1 If necessary, attach a horizontal bracket to both sides of the drive. · You can purchase these accessories separately from your computer dealer. (Screws for use: M3 X 6 X 4) The drive is not working properly. No sound is heard from an audio CD. · See if the drive is connected properly to the PC. · See if the device drive program has been installed properly. · Check whether the audio cable is correctly connected to the · · · · sound output terminal on the drive and the sound card CD-IN terminal. Check that the sound card is operational. If the Digital CD Audio Output box is checked, no sound comes out of the analog audio outputterminal of the driver. Check the condition of the CD and wipe the surface of the CD clean before use. Playing CD-DA/Audio CDs · Run the CD player program supplied with the sound card or play the Windows Media Player. When you have one ODD and the other ODD products. Master Drive Slave Drive Disc Best Labeling Normal Time Draft The entire label area (including graphics) Less than 36 min Less than 28 min Less than 20 min Read CAV12X(MAX16.2MB/sec) Media type DVD+R DVD+RW DVD+R DUAL DVD-R DUAL Playing Video CDs · Follow the instructions provided with the disc. ZCLV 8X(MAX10.8MB/sec) CAV 8X(MAX10.8MB/sec) ZCLV 8X(MAX10.8MB/sec) CAV 8X(MAX10.8MB/sec) ZCLV 8X(MAX10.8MB/sec) CAV 8X(MAX10.8MB/sec) CAV18X(MAX24.3MB/sec) CAV12X(MAX16.2MB/sec) ZCLV 6X(MAX 8.1MB/sec) CAV 8X(MAX10.8MB/sec) CAV16X(MAX21.6MB/sec) CAV 8X(MAX10.8MB/sec) CAV48X(MAX 7.2MB/sec) 2 Hard Drive MainBoard · A video card or MPEG software and a sound card need to be installed to view video CDs. Remove the plate from a free expansion slot and install the DVD Writer , as shown in the illustration. · If you have no free expansion slot, install the drive in place of the diskette drive. · Make sure to use the standardized screws supplied (M3X6). - To use screws other than M3X6 may result in malfunction. · If the drive is vertically installed, you cannot use an 8 cm Mini Disc because the disc is movable. The Window OS can't detect the drive. The system won't read the disc. Storing Your Discs · Do not place a disc in direct sunlight. · Store a disc vertically in a well-ventilated and stable location. · Do not write or attach a label on a disc. · Do not drop a disc or place heavy objects on it. · See if the device drive program has been installed properly. · Can be an OS problem. Try reinstalling the Windows OS program. · See if the system detects the drive. · Make sure you use the types of discs that are supported · · · · · · by the drive. See if the on/off light turns into green. Make sure you inserted the disc with the label facing up. Make sure you are using the right program for disc playback. See if the disc is clean. See if any congealing has occurred. Make sure the region code of the drive matches the disc number. DVD-R Data Transfer Speed(MAX) DVD-RW DVD-ROM(Single) DVD-ROM(Dual) CD-ROM CD-R US-RW HS-RW CD-RW DVD-RAM CAV48X(MAX 7.2MB/sec) CAV40X(MAX 6MB/sec) ZCLV32X(MAX 4.8MB/sec) CAV40X(MAX 6MB/sec) CLV10X(MAX 1.5MB/sec) CLV 4X(MAX 0.6MB/sec) CAV12X(MAX16.2MB/sec) CAV40X(MAX 6MB/sec) CAV40X(MAX 6MB/sec) CAV12X(MAX16.2MB/sec) Cleaning Your Discs Plate DVD Writer Horizontal Bracket · Do not touch the surface of a disc; hold it by the edges. · To clean a disc, polish lightly from the inside of the disc to the outside with a soft cotton cloth. The drive is connected to the sound card but cannot seem to detect it. Buffer Memory Drive Installation Operating Environment Temperature Humidity 2MB Horizontal / vertical 41°F ~ 122°F (5°C ~ 45°C) 5 ~ 10% (RH) 5.34 X 1.65 X 6.69 Inch (148.2 X 42 X 170mm) 750 g · Your sound card is using AT BUS interface. · Connect the card to the S-ATA port or replace the card with a new card with the built-in S-ATA interface capacity. · The disc may not function properly if there are fingerprints, foreign substances or dust on the disc surface. Size(Width x Height x Length) Weight 5 6 7 8 9 ...