Assembly Instructions for Model: AFM2 II Thank you for choosing the Sanus Systems Model AFM2 II. Every effort has been made to ensure that your Sanus Systems furniture is perfect. If you have questions or feel that there is a problem of any kind, please contact us at 800-359-5520 or at www.sanus.com. We can quickly help with any issues regarding assembly or missing parts. Replacement parts for Sanus systems products purchased through authorized dealers will be shipped directly to you. Supplied Parts List: Short Pillar - A Qty. 4 Small Screw - C Qty. 2 Short Stud - D Qty. 4 Long Stud - E Qty. 4 Plastic Foot - F Qty. 4 Plastic CD Holder - G Qty. 1 Speaker Platform - H Qty. 1 Long Pillar - B Qty. 4 Equipment Platform - I Qty. 1 NOTE: You will assemble this product upside down. The Equipment Platform has threaded metal inserts in its bottom. Lay the Equipment Platform face down on a soft surface with the threaded inserts facing up and the square edge facing away from you. Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1.20.06 (100001) Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com Step 1 - Attach the Short pillars to the Equipment Platform NOTE: The Short Studs have a long and short end. Thread the short end of the Short Studs (D) into the inserts in the Equipment Platform (I) until snug. Thread a Short Pillar (A) onto each Short Stud (D) and firmly hand tighten. Diagram 1 A D I Step 2 - Attach the Plastic CD Holder to the Equipment Platform Locate the small pilot holes in the Equipment platform (I); then, using the two Small Screws (C), attach the Plastic CD Holder (G) to the Equipment Platform. Diagram 2 C G Front Edge Slot I noteNOTE: Slots in the Plastic CD Holder (G) must face toward front or rounded edge of the Equipment Platform (I). Step 3 - Attach the Speaker Platform Thread a Long Stud (E) four turns into the open end of each Short Pillar (A); then place the Speaker Platform (H) over the Short Pillars and Long Studs, making sure the beveled edge or the Speaker Platform faces the same way as the beveled edge of the Equipment Platform (I). Diagram 3 H H E Beveled Edges A I Step 4 - Attach the Long Pillars Thread a Long Pillar (B) onto each Long Stud (E) and firmly hand tighten. Diagram 4 B E Step 5 - Press Plastic Feet into the Long Pillars Press a Plastic Foot (F) into each of the four Long Pillars (B) until each Plastic Foot is fully seated. Diagram 5 F B Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1.20.06 (100001) Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com ...