Assembly Instructions for model: VMCT Thank you for choosing a Sanus Systems VisionMountTM VMCT. This product is designed to work with other VisionMountTM product to easily and safely contain and hide component cables, power cords and wires. Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified by Sanus Systems. Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call Sanus Systems before returning products to the point of purchase. Required Tools: Phillips screw driver Supplied Parts and Hardware: Some parts not shown as actual size* (2) Wall Plate - a* (2) Cover - b* (4) Lag Bolt - c (4) Anchor - d Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.12.05 Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com Step 1: Attach Wall Plate Make sure the Wall Plate is oriented so that the flat side is against the wall as shown in Diagram 1. Use the Wall Plate as a template to mark the two hole locations for the Lag Bolts (c) on the chosen stud. Drive each Lag Bolt through the Wall Plate and into the marked holes with a Phillips screw driver until tight. Diagram 1a c a Step 2: Wire Management and Cover Installation Make sure all wires and cables are in between the left and right edge of the Wall Plate (a) before installing the Cover (b). Press fit the Cover onto the Wall Plate so each tab on the Cover fits into each slot on the Wall Plate as shown in Diagram 2. Diagram 2 b tab slot a Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.12.05 Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com ...