INSTRUCTION MANUAL CWM-470 CD Portable AM/FM Stereo Radio Cassette Recorder 1AD6P1P1712-- CWM-470, Issue Number 1 English CWM-460/US 1 28/11/2002, 16:28 For assistance in obtaining repairs and operational information, please contact the following Toll Free Number: DIAL TOLL FREE: 1-800-813-3435 Weekdays: 7:30 AM - 4:00 PM Central Time Also, you may write to SANYO Manufacturing Corporation, 3333 Sanyo Road, Forrest City, Arkansas 72335. Limited Warranty LABOR 90 DAYS PARTS 1 YEAR CARRY-IN ONLY THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED FROM A WAL-MART STORE AND USED IN THE UNITED STATES OF AMERICA, EXCLUDING HAWAII AND ALL U.S. TERRITORIES AND PROTECTORATES. THIS WARRANTY APPLIES ONLY TO THE ORIGINAL RETAIL PURCHASER AND DOES NOT APPLY TO PRODUCTS USED FOR ANY INDUSTRIAL, PROFESSIONAL OR COMMERCIAL PURPOSE. Subject to the OBLIGATIONS and EXCLUSIONS below, SANYO Manufacturing Corporation. ("SANYO") warrants this SANYO product against defects in materials and workmanship for the periods of LABOR and PARTS specified above. SANYO will repair or replace (at its option) the product and any of its parts which fail to conform to this warranty with new or refurbished products or parts. The warranty period commences on the date the product was first purchased at retail from a Wal-Mart Store. OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from a Wal-Mart Store at the original retail purchaser's expense. The original dated bill of sale, or sales slip from a Wal-Mart Store must be submitted to a Wal-Mart Store at the time warranty service is requested. EXCLUSIONS 1. This warranty does not cover (A) the adjustment of customer-operated controls as explained in the appropriate model's instruction manual, or (B) the repair of any product whose serial number has been altered, defaced or removed. This warranty shall not apply to the cabinet or cosmetic parts, broken or damaged video heads, batteries or routine maintenance. This warranty does not apply to uncrating, setup, installation, removal of the product for repair or reinstallation of the product after repair. This warranty does not apply to repairs or replacements necessitated by any cause beyond the control of SANYO including, but not limited to, any malfunction, defect or failure caused by or resulting from unauthorized service or parts, improper maintenance, operation contrary to furnished instructions, shipping or transit accidents, modification or repair by user or any third party, abuse, misuse, neglect, accident, incorrect line voltage, fire, flood or other Acts of God, or normal wear and tear. 2. 3. 4. The foregoing is in lieu of all other express warranties and SANYO does not assume or authorize any party to assume for it any other obligation or liability. THE DURATION OF ANY WARRANTIES WHICH MAY BE IMPLIED BY LAW (INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS) IS LIMITED TO THE TERM OF THIS WARRANTY. IN NO EVENT SHALL SANYO OR THE MANUFACTURER OF THE PRODUCT BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM OWNERSHIP OR USE OF THIS PRODUCT, OR FOR ANY DELAY IN THE PERFORMANCE OF ITS OBLIGATIONS UNDER THIS WARRANTY DUE TO CAUSES BEYOND ITS CONTROL. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIAL LEGAL RIGHTS. YOU MAY HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. R97/10/20(M) For your protection in the event of theft or loss of this product, please keep the following information with a sales receipt in a safe place. Model No. Purchase Price Serial No. Where Purchased Date of Purchase SANYO Manufacturing Corporation -E1- CWM-460/US 2 28/11/2002, 16:28 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING: UNAUTHORIZED RECORDING OF COPYRIGHTED MATERIAL MAY VIOLATE APPLICABLE COPYRIGHT LAWS, THE MANUFACTURER ASSUMES NO RESPONSIBILITY FOR UNAUTHORIZED DUPLICATION, USE OR OTHER ACTS WHICH INFRINGE UPON THE RIGHT OF COPYRIGHT OWNERS. SAFETY CERTIFICATION This unit is made and tested to meet exacting safety standards. It meets UL, CSA and FCC requirements and complies with safety performance standards of the U.S. Department of Health and Human Services. CAUTION - USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL. C US LISTED 2H60 -E2- CWM-460/US 3 28/11/2002, 16:28 FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by Sanyo may void the user's authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FOR SAFE AND EFFICIENT OPERATION · · · · · · Do not damage the power cord. When not in use, disconnect the power cord from the outlet. Grasp the plug, not the cord, when disconnecting the unit. If water should enter the unit, electrical shock or a malfunction may result. Use in an area where there is low humidity and little dust. Do not disassemble or alter the unit in any way. Do not use the unit in areas where extremes in temperature occur (below 40°F or exceeding 95°F), or where it may be exposed to direct sunlight. Because of the CD player's extremely low noise and wide dynamic range, there is a tendency to turn the volume on the amplifier higher than necessary. Doing so may produce an excessively high output from the amplifier which can cause damage to your speakers. Please be careful in this regard. Sudden changes in the surrounding temperature can cause dew to form on the optical pickup lens inside the unit. Under this condition the unit may be unable to operate properly. If this should occur, remove the disc and allow the player to adjust to the surrounding temperature. · -E3- CWM-460/US 4 28/11/2002, 16:28 SPEAKER SYSTEM CONNECTIONS To detach the speaker enclosures To attach the speaker enclosures -E4- CWM-460/US 5 28/11/2002, 16:28 AC power operation Take out the cord and connect it. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU AU FOND. 120V AC, 60Hz NOTE: · This unit is equipped with a polarized plug. If you have difficulty in inserting the plug, turn it over and reinsert it. · When the AC power cord is connected to the unit, the installed batteries will be automatically disconnected. -E5- CWM-460/US 6 28/11/2002, 16:28 POWER SUPPLY Battery power operation Install batteries. Observe + and ­ signs. 8 "D" size batteries (not supplied) CAUTION: WHEN INSTALLING THE BATTERIES To prevent leakage from the batteries, which is corrosive and can cause personal injury and damage to the unit, observe the following precautions: 1. The batteries must be installed correctly. Match the polarities (+ and ­ signs) on the batteries to the polarities shown on the back of the unit. 2. Do not mix new batteries with old or used batteries. 3. Only use batteries of the same type and brand. 4. If the unit will not be used for an extended period of time, remove the batteries and store them in a cool place. 5. C a r e f u l l y f o l l o w t h e b a t t e r y manufacturer's instructions for proper use and disposal. 6. DO NOT ALLOW YOUNG CHILDREN TO HANDLE BATTERIES. IMPORTANT NOTE: SPENT OR DISCHARGED BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY IN COMPLIANCE WITH ALL APPLICABLE LAWS. FOR DETAILED INFORMATION, CONTACT YOUR LOCAL COUNTY SOLID WASTE AUTHORITY. Replace lid. -E6- CWM-460/US 7 28/11/2002, 16:28 REMOTE CONTROL NOTE: The buttons on the remote control perform similar functions to similarly marked buttons on the front of the unit. Controls Inserting batteries 1. 1 8 7 6 2 3 4 5 2. Two "AA" batteries (not supplied) 1. Number buttons (1-9, 0) 2. Radio band button (BAND) 3. Repeat/FM mode button (REPEAT/FM MODE) 4. Tuning/Skip/Search buttons (e/TUNING +, f/TUNING ­) 5. Play/Pause button (i) 6. Stop/Clear button (n) 7. Memory button (MEMORY) 8. Preset button (PRESET) Number buttons (1-9, 0) If the function is "CD", the buttons select the track numbers on a disc. If the function is "TUNER", the buttons select preset radio stations. With any other function, the buttons will not function. · Two buttons must always be pressed. Example: To select No. 3, press 0, then 3. To select No. 10, press 1, then 0. To select No. 25, press 2, then 5. Remote control range Remote sensor (IR) Within approx. 20 feet -E7- CWM-460/US 8 28/11/2002, 16:28 GENERAL OPERATION Turning the power on and off 1. Set to the desired function, and the power turns on. WHAT TO DO IF ... If the operation of the unit or display is not normal, or you wish to clear the contents of the memory, disconnect the power cord from the AC outlet and remove all batteries, then press [RESET] (rear of the unit) for at least 20 seconds. 2. To turn the power off. Set [FUNCTION] to [OFF](TAPE). Adjusting the volume Bass expander system Press [BASSXPANDER] to enhance the bass sound. Using headphones Stereo headphone (not supplied) -E8- CWM-460/US 9 28/11/2002, 16:28 COMPACT DISC OPERATION CD PLAY 1 2 3 3 Press [PLAY/PAUSE]. 4 1 Set to [CD]. The current track number Playback indicator Elapsed time for the current track 2 Push down. 4 To control the sound. Press [STOP/CLEAR]. n Label facing up Push down. Set to [OFF] (TAPE). Total track number Total playing time -E9- CWM-460/US 10 28/11/2002, 16:28 NOTES: · If the disc is loaded with the label facing downward, or if a badly scratched disc is loaded, or if no disc is loaded, "Cd" appears. Compact discs · Both 3-inch and 5-inch discs can be played in this unit. NOTE: Place only one disc at a time in the CD compartment. · Only discs bearing the logo as shown can be played in this unit. · · If this occurs, load the disc correctly with the label facing upward, or replace the damaged disc. Opening the CD compartment lid while a CD is playing could scratch the disc. Always press [STOP/CLEAR] and wait for the disc to stop rotating before opening the CD compartment lid. · · · · · · Always place the compact disc in the CD compartment with the label facing up. Compact disc can be played on only one side. Fingerprints and dust should be carefully wiped from the disc's signal surface (opposite the label side) with a soft cloth. Gently wipe in a straight motion from the inside to the outside of the disc. Discs should be returned to their cases after use to avoid serious scratches which could cause the player to skip. Do not expose a disc to direct sunlight, high humidity, or high temperatures for extended periods of time to prevent warping the disc. Do not apply paper or write anything on either side of the disc. Sharp writing instruments, or the inks used in some felttip pens, may damage the surfaces of the disc. Do not use cleane ...