s 1 Display indicators Signal strength/GPRS/battery level. 2 LED Two LEDs for Dynamic light are located under lift cover. 3 Softkeys Press the softkey to call up the function that is displayed as §Text§ or icon on the grey fields above the key. 4 Plug socket For charger, headset. 5 A Call key Dial displayed phone number or name, accept calls. In standby mode: Display the last calls. 6 B On/Off/End key · Switching on/off: press and hold. · During a conversation or in an application: press briefly to finish. · In menus: press briefly to go back a level. Press and hold to return to standby mode. · In standby mode: Press and hold to switch off phone. 7 Navi-key In lists and menus: GScroll up and down. DFunction call. CBack a menu level. During a call: DOpen call menu. GAdjust volume. In standby mode: EVoice command (press and hold). FOpen Addressbook/Phonebook. DOpen menu. CNew SMS. Overview of the phone _ Service provider ª g 17.12.2005 New SMS 09:15 Menu 8 * Press and hold · In standby mode: switch on/off all signal tones (except alarm). · For incoming calls: only switch off ring tones. When Open clamshell is activated a call can be accepted by opening the clamshell. A call can be ended by simply closing the clamshell. This is a summarised version of the User Guide. The complete version in English and German can be found on the Internet: www.siemens.com/af51 AF51 s Safety precautions Information for parents Please read the operating instructions and safety precautions carefully before use. Explain the content and the hazards associated with using the phone to your children. Remember to comply with legal requirements and local restrictions when using the phone. For example in aeroplanes, petrol stations, hospitals or while driving. Mobile phones can interfere with the functioning of medical devices such as hearing aids or pacemakers. Keep at least 20 cm between phone and pacemaker. When using the mobile phone hold it to the ear which is further away from the pacemaker. For more information consult your doctor. Small parts such as the SIM card, sealing stop, lens ring and lens cap can be dismantled and swallowed by small children. The phone must therefore be stored out of the reach of small children. Permanent hearing loss may occur if you use ear- or headphones at high volume.You can adapt over time to a higher volume, which may sound normal but can be damaging to your hearing. Set your volume to a safe level. If you experience ringing in your ears, reduce the volume or discontinue use of your system. Only use original batteries (100 % mercury-free) and ­ charging devices. Otherwise you risk serious damage to health and property. The battery could explode, for instance. The mains voltage specified on the power supply unit (V) must not be exceeded. Otherwise the charging device may be destroyed. The power supply must be plugged into an easily accessible AC mains power socket when charging the battery. The only way to turn off the charging device after charging the battery is to unplug it. Do not place the phone near to electromagnetic data carriers such as credit cards and floppy disks. Information stored on them could be lost. Tones, music and handsfree talking are reproduced through the loudspeaker. Do not hold the phone to your ear when it rings or when you have switched on the handsfree function. Otherwise you risk serious permanent damage to your hearing. You may only open the phone to replace the battery (100 % mercuryfree) or SIM card. You must not open the battery under any circumstances. All other changes to this device are strictly prohibited and will invalidate the guarantee. Please dispose of unwanted batteries and phones as permitted by the laws in your country. The phone may cause interference in the vicinity of TV sets, radios and PCs. Use only original accessories. This will avoid potential risks to health or property and ensure compliance with all relevant regulations. Ref.No.: A31008-H2950-A1-3-7619 *A5B00075849581* Improper use will invalidate the guarantee! These safety instructions also apply to original accessories. Getting started Using the SIM card/battery Your phone's display is delivered with a protective film. Remove this film before getting started. The service provider supplies you with a SIM card on which all the important data for your account is stored. If the SIM card is credit card-sized, snap out the smaller segment and trim any rough edges. Always switch off phone before removing the battery! Only 3V and 1.8V SIM cards are supported. Please contact your service provider if you have an older card. Release and open battery cover Insert battery and close cover 8 9 Charge battery The battery is not fully charged when delivered. Plug charger cable into the bottom of the phone, plug power supply unit into a mains power socket and charge for at least two hours. The power supply unit heats up when used for long periods. This is normal and not dangerous. 1 2 Remove battery 3 Release and open SIM card holder, insert SIM card, and close holder 4 7 6 5 When charging is in progress h is displayed. Charging time An empty battery is fully charged after about 2 hours. Charging is only possible within a temperature range of +5 °C to +40 °C. If the temperature rises/ falls 5 °C above/below this, the charge symbol flashes a warning. The mains voltage specified on the power supply unit must not be exceeded (Operating time, p. 11). Charge level display during operation (empty - full): a d g. A beep sounds when the battery is nearly empty. The charge level of the battery is only displayed correctly after an uninterrupted charging/discharging cycle. You should therefore not remove the battery unnecessarily and where possible not terminate the charging process early. 3 Security Preventing accidental activation Even if PIN control is deactivated confirmation is required to switch on the phone. This prevents the phone from being switched on accidentally, e. g. when carried in a pocket or whilst you are on an aircraft. Press and hold the On/Off/End key B and confirm with §OK§. The phone switches on. ¢ Select function. The phone and SIM card are protected against misuse by several security codes. Keep these confidential numbers in a safe place where you can access them again if required. Codes PIN control You can stop the PIN prompt being activated when the phone is switched on, but you then risk unauthorised use of the phone. Press §Change§. Enter PIN and confirm with §OK§. §Menu§ ¢ m ¢ Security Calling Dialling with number keys The phone must be switched on (standby mode). Dial number (always with area code, if necessary with international dialling code). To dial international dialling code press and hold 0 until a "+" is displayed. Press §+List§ and select country. To dial press the Call key A. Change PIN You can change the PIN to any 4- to 8-digit number you find easier to remember. Change PIN2 (Display only if PIN2 is available). Proceed as with Change PIN. Accept call Chg.phonecode You define the phone code (4-8 digits) when you call up a protected function for the first time. It is then valid for all phonecode protected functions. If the phone code is entered incorrectly three times, access to the phone code and the functions that use it is denied. If this happens please contact the Service Centre. An incoming call will interrupt any other use of the phone. Press §Answer§ or A. When Open clamshell is activated a call can be answered by simply opening the clamshell. Please make sure you have accepted the call before holding the phone to your ear. This will avoid damage to your hearing from loud ring tones! Clear SIM card barring End call If the PIN is entered incorrectly three times, the SIM card is barred. Enter the PUK (MASTER PIN), provided by your service provider with the SIM card, according to instructions. If the PUK (MASTER PIN) has been lost, please contact your service provider. Press the End key B briefly or simply close the clamshell. Handsfree You can put the phone aside during a call. You can then hear the caller via the loudspeaker. Activate handsfree function with §Handsfr.§ and switch on with §Yes§. Adjust the volume with G. Pressing §Handsfr.§ switches off "handsfree talking". 4 Swapping between 2 calls Make a new connection during a call with §y menu§ ¢ Hold ¢ J(dial a new phone number). With §y menu§ ¢ Swap you can swap back and forth between both calls. If you are called during a phone call and you can hear the "call waiting tone", you can accept the waiting call with §Swap§, putting the current call on hold to do so. Swap back and forth between the calls see above or end the current call with B and accept the new call with §Answer§. b * 0 1 Direct call If this is active, only one number can be dialled. §Menu§ ¢ m ¢ Security ¢ Direct call Press D and enter phone code. The phone code (4- to 8-digits) is set by you and entered at the first security setting. Please note this code down (see also p. 4)! Confirm code input with §OK§. To dial, press and hold the right softkey. To switch direct call off, press and hold . Enter phone code and confirm with §OK§. Press §Change§ and Confirm Off with §OK§. Input menu Press briefly: Swap between abc, Abc, T9abc, T9Abc, T9ABC, 123. Status shown in top line of display. Press and hold: All inputvariants are displayed. Press briefly: Special characters are shown. Press and hold: Open input menu. Press once/repeatedly: .,?!'"0-()@/:_ Press and hold: Writes 0. Writes blank. Press twice = jumps a line. Press and hold * with text input. The input menu ist displayed: Text format (SMS only), Input language, Mark text, Copy/Add Text entry with T9 T9 deduces the correct word from the individual key entries by making comparisons with an extensive dictionary. Write a word and finish it without looking at the display. Simply press the keys where the relevant letter is located once. If several options are found in the dictionary the most probably is displayed first. For further options please press the right softkey. Text entry Text entry without T9 Press number key repeatedly until the required letter appears. After a brief interval the cursor will advance. Example: Press once briefly to type the let2 ter a, twice to type b, etc. Press and hold to write the number. Ä, ä, 1-9 Umlauts and numbers are displayed after the relevant letters. §Clear§ Press briefly to delete the letter before the cursor, press and hold to erase the whole word. H/G Move the cursor (forwards/ back). 5 T9® Text Input is licensed under one or more of the following: U.S. Pat. Nos. 5,187,480, 5,818,437, 5,945,928, 5,953,541, 6,011,554, 6,286,064, 6,307,548, 6,307,549, 6,636,162 and 6,646,573; Australian Pat. Nos. 727539, 746674 and 747901; Canadian Pat. Nos. 1,331,057, 2,302,595, and 2,227,904; Japan Pat. No. 3532780, 3492981; United Kingdom Pat. No. 2238414B; Hong Kong Standard Pat. No. HK1010924; Republic of Singapore Pat. No. 51383, 66959, and 71979; European Pat. Nos. 0 842 463 (96927260.8), 1 010 057 (98903671.0), 1 018 069 (98950708.2); Republic of Korea Pat. Nos. KR201211B1 and KR226206B1. People's Republic of China Pat. Application Nos. 98802801.8, 98809472.X and 96196739.0; Mexico Pat. No. 208141; Russian Federation Pat. No. 2206118; and additional patents are pending worldwide. Change entry F ¢ Select entry ¢ §View§ ¢ §Edit§ ¢ Make changes ¢ §Save§. Voice dialling Dial numbers by voice command. Record Open Addressbook (in standby mode). F ¢ Select entry (first letter and/or scroll) ¢ §Options§ ¢ Voice dialling ¢ (Select phone numbers if there are more than one) ¢ §Record§ ¢ §Start§. A short signal sounds. Now speak the name. After a second beep and message in the display, repeat the name. A beep now confirms the recording, which is saved automatically. Press and hold E (in standby mode). Now speak the name. The number is dialled. Addressbook The Addressbook can store up to 500 entries that are managed in the phone memory. Apply voice dialling If the Addressbook has been selected as standard: Open Addressbook (in standby mode) F ¢ D ¢ J (enter first and/or last name) ¢ Select entry field ¢ Make further entries ¢ §Save§. Group Entries can be organized by groups. Select with §Change§. Picture Press §Select§. Assign a picture to an Addressbook entry. Birthday After entering the date of birth, the "reminder box" can be activated. You can now enter the time for the reminder. All fields Press §Select§. Show all input fields if the display was previously reduced (§Options§, Field setup). SMS You can transmit and receive very long messages (up to 760 characters) on your phone. They are automatically composed of several "normal" SMS messages (note higher charges). Using special letters in some languages reduces the maximum possible length of an SMS. If you ...