Detailed instructions for use are in the User's Guide.
Model 5204 Fire Control/Communicator Panel Built-in Touchpad Operating Instructions
These instructions must be framed and displayed next to the Model 5204 panel in accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems.
Function System test Reset alarms (or smoke det.) Clear alarm memory Reset dialer Start download Alarm memory display Display troubles Silence troubles or alarms Disable/Enable Begin fire drill End fire drill
Enter (On Built-in Touchpad):
0 ENTER 1 ENTER + Code 0 or 1 2 ENTER 3 ENTER + Code 0 4 ENTER + Code 0 5 ENTER 6 ENTER SILENCE Zone #1-4 + DISABLE + Code 0 or 1 2 0 ENTER + Code 0 SILENCE
On 5230, also enter: + Code 0 or 1 Same + Code 0 or 1 Same Same + Code 0 or 1 + Code 0 or 1 + Code 0 or 1 Same + Code 0 or 1 + Code 0 or 1
Function Walk test Zone Troubleshooting mode Step Programming mode Clear (start over if you make a mistake) Set time
For example, to set the time of Wed., 4:30 p.m., enter: 310430
Enter (On Built-in Touchpad or 5230):
2 2 ENTER + Code 0 * 2 5 ENTER + Code 0 * 2 7 ENTER + Code 0 * CLEAR 9 ENTER + 6-digit date Use wdhhmm format for time, where: w = Day of week (0=Sun., 1=Mon., 2=Tue., 3=Wed., 4=Thu., 5=Fri., 6=Sat.) d = Time of day (0=AM, 1=PM) hh = Hour (enter leading 0 for 1-digit hrs.) mm = Minutes (enter leading 0 for 1-digit min.)
* To exit these modes with the 5230, press STEP STEP CLEAR CLEAR . With the built-in touchpad, press SILENCE SILENCE CLEAR CLEAR . For service call:
The system sounds an alarm and reports a fire test when you exit fire drill mode.
Form # 150643 6/95
...
