Contents 1. 2. 3. 4. 5. 6. 7. 8. 9. INSTRUCTIONS PROPER USE __________________________________________ 28 SAFETY INSTRUCTION ________________________________________________ 29 KNOW YOUR OVEN ___________________________________________________ 30 BEFORE FIRST USE___________________________________________________ 30 ELECTRONIC ANALOGUE CLOCK (ONLY ON SOME MODELS) _______________ 31 ELECTRONIC PROGRAMMER (ONLY ON SOME MODELS) ___________________ 33 OVEN CAVITY ________________________________________________________ 35 AVAILABLE ACCESSORIES_____________________________________________ 36 DESCRIPTION OF CONTROL ___________________________________________ 37 10. COOKING FUNCTION__________________________________________________ 40 11. OVEN TEMPERATURE CONVERSION CHART _____________________________ 44 12. COOKING CHART_____________________________________________________ 45 13. CLEANING AND MAINTENANCE _________________________________________ 46 14. SOMETHING WRONG? ________________________________________________ 49 15. INSTALLATION _______________________________________________________ 50 INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. 27 Instructions for proper use 1. INSTRUCTIONS PROPER USE ELECTRICAL CONNECTION: PLEASE REFER TO INSTALLATION INSTRUCTION FOR THE GAS & ELECTRICAL SAFETY REGULATIONS AND THE VENTILATION REQUIREMENTS. IN YOUR OWN INTEREST, AND THAT OF SAFETY, IT IS THE LAW THAT ALL GAS APPLIANCES BE INSTALLED AND SERVICED BY COMPETENT PERSONS, WHO WILL COMPLY WITH THE RELEVANT STANDARDS AND REGULATIONS. CORGI REGISTERED INSTALLERS UNDERTAKE TO WORK TO SATISFACTORY STANDARDS. DISCONNECTION OF GAS AND ELECTRIC APPLIANCES SHOULD ALWAYS BE CARRIED OUT BY A COMPETENT PERSON. THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES ARE CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE. NEVER USE THIS APPLIANCE FOR HEATING ROOMS. DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE. THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT. DO NOT OBSTRUCT VENTILATION OPENINGS AND HEAT DISPERSAL SLITS. THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS POSITIONED VISIBLY ON THE OVEN DOOR FRAME. THE PLATE MUST NOT BE REMOVED. TO PREVENT ANY STEAM IN THE OVEN CREATING PROBLEMS, OPEN THE DOOR IN TWO STAGES: HALF OPEN (5 CM APPROX.) FOR 4-5 SECONDS AND THEN FULLY OPEN. TO ACCESS FOOD, ALWAYS LEAVE THE DOOR OPEN AS SHORT A TIME AS POSSIBLE TO PREVENT THE TEMPERATURE IN THE OVEN FROM FALLING AND RUINING THE FOOD. The manufacturer declines all responsibility for damage to persons or things caused by nonobservance of the above guidelines or by interference with any part of the appliance or by the use of non-original spares. 28 Safety instruction 2. SAFETY INSTRUCTION INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED TECHNICIAN WHO MUST INSTALL THE APPLIANCE, SET IT FUNCTIONING AND CARRY OUT AN INSPECTION TEST. DO NOT ATTEMP TO MOVE THE APPLIANCE BY PULLING ON THE DOOR HANDLES. OPEN THE DOOR AND GRASP THE FRAME OF THE OVEN TAKING CARE THAT THE DOOR DOES NOT SHUT ON YOUR FINGERS. IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE EARTHED ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES. WHEN LINKING UP TO MAINS BY HARD WIRING, CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS. THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN. ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE "ZERO" (OFF) POSITION WHEN YOU FINISH USING THE OVEN. NEVER PUT FLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE ACCIDENTALLY LIGHTED AND IGNITED CAUSE FIRE. PARTS OF THE APPLIANCE MAY BE HOT DURING OR IMMEDIATELY AFTER USE. CARE SHOULD BE TAKEN TO AVOID TOUCHING HEATING ELEMENTS INSIDE THE OVEN. ALLOW SUFFICIENT TIME FOR THE APPLIANCE TO COOL AFTER SWITCHING OFF. THE OVEN IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN TO GO NEAR OR PLAY WITH IT. THE APPLIANCE BECOMES VERY HOT DURING USE. SHOULD BE WORN FOR ALL OPERATIONS. SUITABLE HEAT-PROOF GLOVES DURING COOKING, DO NOT COVER THE BOTTOM OF THE OVEN WITH ALUMINIUM, TIN FOIL OR GREASEPROOF PAPER AND DO NOT PLACE PANS OR OVEN TRAYS ON IT AS THIS MAY DAMAGE THE ENAMEL COATING. BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED. IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE. NEVER ATTEMPT TO REPAIR THE APPLIANCE. ALL REPAIRS MUST BE CARRIED OUT BY AN AUTHORISED ENGINEER OR AT AN AUTHORISED SERVICE CENTRE. 29 Instructions for the user 3. KNOW YOUR OVEN FRONT CONTROL PANEL OVEN CAVITY OVEN FAN OVEN LIGHT OVEN DOOR DOOR HANDLE OVEN GUIDE FOR SHELF AND PAN COOLING SYSTEM The appliance is equipped with 2 cooling fans which come into operation when the oven is switched on. Operation of the fan generates a normal flow of air which comes out at the bottom, in the centre of the front of the oven, and may continue for a short time even after the oven is switched off. 4. BEFORE FIRST USE Do not leave the packing in the home environment. Separate the various waste materials and take them to the nearest special garbage collection centre. Before using the oven for the first time, pre-heat it to maximum temperature long enough to burn any manufacturing oily residues which could give the food a bad taste. HOW TO PROCEED Remove all the accessories from the inside of the oven. Remove all the removable label and any protective foils from the outside and the inside of the oven. To switch on the oven at first use or after a power black-out, simply press the programmer central key for 1 to 2 seconds to enable cooking in the large oven. The small oven does not require any specific switch-on procedures: simply turn the thermostat knob to any setting. and the thermostat knob to 250°C. For the small oven simply Set the function knobs on the symbol turn the thermostat knob on the symbol . 30 Instructions for the user 5. ELECTRONIC ANALOGUE CLOCK (ONLY ON SOME MODELS) The programmer user instructions are valid only for the large oven. LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC DURATION / AUTOMATIC STAR TIME BUTTON TIME SETTING AND RESET DECREASE TIME BUTTON INCREASE TIME BUTTON 5.1 Setting the time When the oven is used for the first time, or after a power failure, the display flashes on and off at regular intervals. Press the key for 1 to 2 seconds to stop the display flashing and start setting of the current time. Press the or keys to increase or decrease by one minute each time a key is pressed. Press one of the two value modification keys until the current time appears. The clock will start from the time set 6/7 seconds after the last key is pressed. At the end of each programmed cooking operation, an intermitant alarm will sound 3 to 4 times at intervals of about 1 and a half minutes. The beeps can be stopped at any moment by pressing any key. 5.2 - Minute-minder When the key is pressed the display illuminates, appearing as shown in figure 1; Press the or keys within 6 to 7 seconds to set the minute-minder. Whenever a key is pressed, 1 outside segment, representing 1 cooking minute will light up (figure 2 shows 10 cooking minutes). The countdown will start 6 to 7 seconds after the last key is pressed; at the end of it, you will hear the alarm. During cooking with countdown, the current time can be displayed by key once; press again to return to the minute-minder pressing the display. At the end of the countdown, the oven has to be switched off by hand, by turning the thermostat and the function selector to 0. This function does not stop cooking but just triggers the alarm. - 1 - 2 31 Instructions for the user 5.3 Programming Cooking duration time: the 2nd button can be used to set the cooking time. Before setting it, turn the thermostat to the cooking temperature of choice and the function selector knob to any setting. To set the cooking time, proceed as follows: key for 1 to 2 seconds; the pointer will move to 12 o'clock (Fig. Press the 1). Use the and keys to set the cooking time; whenever the key is pressed, 1 minute will be added to the cooking time, and every 12 minutes a new inside segment will light up (figure 2 shows a cooking time of 1 hour). 1 Once the required time has been set, cooking will start about 6 seconds or . key is pressed. after the last time the Once cooking has started, the display will show the current time, represented by the constantly on segments, and the minutes left until cooking finishes, represented by the flashing segments (every flashing segments indicates 12 minutes of cooking time left). When the end of the cooking time is reached, the timer will switch off the 2 oven heating elements, the alarm will start and the numbers on the dial will flash. The cooking time can also be reset by deleting the program set; pressing for 1 or 2 seconds will delete the time set and the oven the central key will have to be switched off by hand. Caution: cooking times of more than 6 hours cannot be set. Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours after the current time). To set the cooking start/end time, proceed as follows. Set the cooking duration time as described in the previous point. or keys are pressed, press the key to set Within 6 to 7 seconds after the last time the the cooking start time. The display will show the current time with the inside segments indicating the cooking end time illuminated. Use the and keys to set the cooking start time. 6 to 7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time. As soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking. When the end of the cooking time is reached, the timer will switch off the oven heating elements, the alarm will start and the numbers on the dial will flash. To reset the entire program, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand. - The image on the right shows an example of programming: the current time is 7.06 and cooking is programmed to start at 8 o'clock and finish at 9. - At 8 o'clock, the inside segments between 8 and 9 will start to flash and the hour pointer will remain still. Caution: for the oven to start cooking after the programming procedure just described, the thermostat and function selector must be properly set on the temperature and function required. 5.4 "DEMO" Function Models with analogue/digital programmer feature a "DEMO" function which deactivates the heating elements while leaving the other functions unchanged. To activate it, simply press the , and keys for 3/4 seconds. A confirmation beep will inform the user that the function is active. To deactivate it, simply repeat the same procedure. 32 Instructions for the user 6. ELECTRONIC PROGRAMMER (ONLY ON SOME MODELS) The programmer user instructions are valid only for the large oven. LIST OF FUNCTIONS MINUTE MINDER BUTTON COOKING DURATION BUTTON END-OF-COOKING BUTTON DECREASE TIME BUTTON INCREASE TIME BUTTON 6.1.0 Clock adjustment When using the oven for the first time, or after a power failure, the display flashes regularly and . Press the keys and at the same time the keys or : each single press indicates changes the time by 1 minute either up or down. Before setting the programmer activate the desired function and temperature. 6.1.1 Semi automatic cooking Use this setting f ...