LCD Digital Colour TV Operating Instructions KDL-32S55xx KDL-26S55xx KDL-22S55xx KDL-19S55xx © 2009 Sony Corporation 4-127-735-12(1) NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced with the same rating of fuse approved by ASTA or BSI to BS 1362 (i.e., marked with or ) must be used. When an alternative type of plug is used it should be fitted with the same rating of fuse, otherwise the circuit should be protected by a 10 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 1080075 Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. Trademark information · is a registered trademark of the DVB Project · HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. About the model name in this manual The "xx" that appears on the model name, corresponds to two numeric digits related to design or colour variation. FUSE FUSE How to replace the fuse Open the fuse compartment with a blade screwdriver, and replace the fuse. Please refer to the illustration that actually equipped with the product. Introduction Thank you for choosing this Sony product. Before operating the TV, please read this manual thoroughly and retain it for future reference. Notice for Digital TV function · Any functions related to Digital TV ( ) will only work in countries or areas where DVB-T (MPEG2) digital terrestrial signals are broadcasted. Please confirm with your local dealer if you can receive a DVB-T signal where you live. · Although this TV set follows DVB-T specifications, compatibility with future DVB-T digital terrestrial broadcasts cannot be guaranteed. · Some Digital TV functions may not be available in some countries. 2 GB Table of Contents Start-up Guide 4 Safety information.............................................................................................................9 Precautions......................................................................................................................11 Overview of the remote ..................................................................................................12 Overview of the TV buttons and indicators ..................................................................13 Watching TV Watching TV ....................................................................................................................14 Using the Digital Electronic Programme Guide (EPG) .......................................16 Using the Digital Favourite list .............................................................................17 Using Optional Equipment Connecting optional equipment ....................................................................................18 Viewing pictures from connected equipment ..............................................................20 Playing Back Photo/Music via USB...............................................................................21 Using control for HDMI ...................................................................................................22 Using MENU Functions Navigating through menus.............................................................................................23 Settings ............................................................................................................................24 Additional Information Installing the Accessories (Wall-Mount Bracket) .........................................................31 Specifications..................................................................................................................34 Troubleshooting..............................................................................................................36 : for digital channels only 3 GB Start-up Guide KDL-32S55xx/KDL-26S55xx 1: Checking the accessories Remote RM-ED017 (1) Size AA batteries (R6 type) (2) Stand (1) Screws for stand (KDL-32S55xx/KDL-26S55xx (4), KDL-22S55xx/KDL-19S55xx (3)) Accessory bag Screws To insert batteries into the remote Push and slide to open. Table-Top Stand TV unit KDL-22S55xx/KDL-19S55xx Accessory bag ~ · Observe the correct polarity when inserting batteries. · Do not use different types of batteries together or mix old and new batteries. · Dispose of batteries in an environmentally friendly way. Certain regions may regulate disposal of batteries. Please consult your local authority. · Handle the remote with care. Do not drop or step on it, or spill liquid of any kind onto it. · Do not place the remote in a location near a heat source, a place subject to direct sunlight, or a damp room. Screws Table-Top Stand TV unit 2: Attaching the stand Follow the assembling steps required to place on a TV stand. 2 Gently slide the TV unit onto the neck of the Table-Top Stand and align the screws holes. 1 Take out the Table-Top Stand and screws from the carton. The screws are found in the accessory bag. KDL-32S55xx/KDL-26S55xx Rear of TV 4 GB KDL-22S55xx/KDL-19S55xx Rear of TV 3: Connecting an aerial/VCR/DVD recorder ~ · This product has been tested and found to compliant with the limits set out in the EMC Directive for using connection cables not longer than 3 meters (9.8 feet). Start-up Guide ~ · When you carry the TV, place your hand as illustrated and hold it securely, see page 9. Do not put stress on the LCD panel and the frame around the screen. · Be careful not to pinch your hands or the mains lead when you install the TV to the Table-Top Stand. Connecting an aerial only 3 Use the supplied screws to attach the TV unit to the Table-Top Stand. Coaxial cable KDL-32S55xx/KDL-26S55xx Connecting an aerial/VCR/DVD recorder with SCART Screws KDL-22S55xx/KDL-19S55xx AV1 AV2 Screws ~ · If an electric screw driver is used, set the torque to tighten at approximately 1.5 N·m {15 kgf·cm}. Coaxial cable Scart lead Coaxial cable VCR/DVD recorder ~ · AV1 outputs available only for analogue TV. · AV2 outputs to the current screen (except PC, HDMI, Component 1080i). Continued 5 GB Connecting an aerial/VCR/DVD recorder with HDMI KDL-32S55xx/KDL-26S55xx 4: Preventing the TV from toppling over IN 1 Coaxial cable 2 HDMI cable Coaxial cable 3 2 1 1 Install a wood screw (4 mm in diameter, not supplied) in the TV stand. Install a machine screw (M4 × 14 mm, not supplied) and a nut (M4, not supplied) from the bottom of the Table-Top Stand into the screw hole of the TV. Adjust a strong cord line weight accordingly, to secure the machine screw and nut. ~ · Be sure to secure a machine screw and a nut. VCR/DVD recorder 2 KDL-22S55xx/KDL-19S55xx 3 IN 1 Tie the wood screw and the machine screw with a strong cord. Coaxial cable z · An optional Sony support belt kit is used to secure the TV. Contact your nearest Sony Service Centre to purchase a kit. Have your TV model name ready for reference. 5: Bundling the cables HDMI cable Coaxial cable You can bundle the connecting cables as illustrated below. 1 2 3 VCR/DVD recorder 6 GB ~ · Do not bundle the mains lead with other connecting cables. ~ 6: Adjusting the viewing angle of the TV KDL-22S55xx/KDL-19S55xx only This TV can be adjusted within the angle shown below. · When you turn on the TV, the power indicator light up in green. Start-up Guide 3 Press F/f to select the language displayed on the menu screens, then press . Auto Start-up Language Country Location English Nederlands Italiano Deutsch Adjust the angle back and forth (tilt) Right view 3° 8° Select: Confirm: 4 Front Press F/f to select the country/region in which you will operate the TV, then press . Auto Start-up 7: Selecting the language, country/region and location Language Country Location United Kingdom Ireland Nederland Luxembourg France Italia Back: Select: Confirm: If the country/region which you want to use on the TV does not appear in the list, select "-" instead of a country/region. 5 Press F/f to select the location type in which you will operate the TV, then press . Auto Start-up DIGITAL ANALOG SCENE AUDIO Language GUIDE Country Location Home Shop 3,4,5 RETURN TOOLS MENU Back: Select: Confirm: 1 2 Connect the TV to your mains socket (220-240V AC, 50Hz). Press 1 on the side of the TV. When you turn on the TV for the first time, the Language menu appears on the screen. In Shop mode, some settings will be periodically reset for Shop usage. This option selects the initial picture mode appropriate for the typical lighting condition in these environments. 7 GB 8: Auto-tuning the TV 1 Before you start auto-tuning the TV, insert a pre-recorded tape into the VCR connected to the TV (page 5) and start play back. The video channel will be located and stored on the TV during auto-tuning. If no VCR is connected to the TV, skip this step. 5 Press MENU to exit. The TV has now tuned in all the available channels. Detaching the TableTop Stand from the TV ~ · Do not remove the Table-Top Stand for any reason other than to wall-mount the TV. 2 Press Auto Tuning . KDL-32S55xx/KDL-26S55xx Do you want to start Auto Tuning? Back: Start: The TV starts searching for all available digital channels, followed by all available analogue channels. This may take some time, so do not press any buttons on the TV or remote while proceeding. If a message appears for you to confirm the aerial connection No digital or analogue channels were found. Check all the aerial connections and press to start auto-tuning again. Table-Top Stand KDL-22S55xx/KDL-19S55xx 3 When the Programme Sorting menu appears on the screen, follow the steps of "Programme Sorting" (page 27). If you do not change the order in which the analogue channels are stored on the TV, go to next step. Table-Top Stand 4 When the Eco Preset menu appears on the screen, if you press "Yes," the "Eco" settings are changed to recommended values to reduce power consumption. Eco Preset Do you want to use the Eco Preset? Choosing "YES" will reduce power consumption. Power Saving Idle TV Standby PC Power Management Yes Reduce 3h On No 8 GB Transporting Safety information Installation/Set-up Install and use the TV set in accordance with the instructions below in order to avoid any risk of fire, electrical shock or damage and/or injuries. Installation · The TV set should be installed near an easily accessible mains socket. · Place the TV set on a stable, level surface. · Only qualified service personnel should carry out wall installations. · For safety reasons, it is strongly recommended that you use Sony accessories, including: KDL-32S55xx: ­ Wall-mount bracket SU-WL500 KDL-26S55xx/KDL-22S55xx/KDL-19S55xx: ­ Wall-mount bracket SU-WL100 · Be sure to use the screws supplied with the Wall-mount bracket when attaching the mounting hooks to the TV set. The supplied screws are designed so that they are 8 mm to 12 mm in length when measured from the attaching surface of the mounting hook. The diameter and length of the screws differ depending on the Wall-mount bracket model. Use of screws other than those supplied may result in internal damage to the TV set or cause it to fall, etc. · Before transporting the TV set, disconnect all cables. · Two or more people are needed to transport a large TV set. · When transporting the TV set by hand, hold it as shown below. Do not put stress on the LCD panel and the frame around the screen. · When lifting or moving the TV set, hold it firmly from the bottom. · When transporting the TV set, do not subject it to jolts or excessive vibration. · When transporting the TV set for repairs or when moving, pack it using the original carton and packing material. KDL-32S55xx KDL-26S55xx/KDL-22S55xx/ KDL-19S55xx Ventilation · Never cover the ventilation holes or insert anything in the cabinet. · Leave space around the TV set as shown below. · It is strongly recommended that you use a Sony wallmount bracket in order to provide adequate aircirculation. 8 mm-12 mm Screw (supplied with the Wall-mount bracket) Mounting Hook Hook attachment on rear of TV set Installed on the wall 30 cm 10 cm 10 cm 10 cm Leave at least this space around the set. Installed with stand 30 cm 10 cm 10 cm 6 cm Leave at least this space around the set. Continued 9 GB · To ensure proper venti ...