2-684-953-11(1) U LCD Digital Colour TV Operating Instructions Before operating the TV, please read the "Safety information" section of this manual. Retain this manual for future reference. KDL-46S2000 KDL-40S2000 KDL-32S2000 KDL-32S2020 KDL-26S2010 KDL-46S2010 KDL-40S2010 KDL-32S2010 KDL-26S2000 KDL-26S2020 For useful information about Sony products © 2006 Sony Corporation NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 13 AMP fuse approved by ASTA or BSI to BS 1362 (i.e., marked with or ) must be used. When an alternative type of plug is used it should be fitted with a 13 AMP FUSE, otherwise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. Introduction Thank you for choosing this Sony product. Before operating the TV, please read this manual thoroughly and retain it for future reference. Trademark information · is a registered trademark of the DVB Project · Manufactured under license from BBE Sound, Inc. Licensed by BBE Sound, Inc. under one or more of the following US patents: 5510752, 5736897. BBE and BBE symbol are registered trademarks of BBE Sound, Inc. · TruSurround XT, SRS and (z) symbol are trademarks of SRS Labs, Inc. TruSurround XT technology is incorporated under license from SRS Labs, Inc. · HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing, LLC. · The illustrations used in this manual are of the KDL32S2000/KDL-32S2010/KDL-32S2020 unless otherwise state. FUSE How to replace the fuse Open the fuse compartment with a blade screwdriver, and replace the fuse. WARNING · To prevent the risk of electric shock, if the mains lead or plug is damaged, do not insert the plug into the mains socket outlet. This plug cannot be used and should be destroyed. · To prevent the risk of fire or electric shock, do not expose the TV set to rain or moisture. · Dangerously high voltages are present inside the TV set. Do not open the cabinet. Refer servicing to qualified personnel only. Notice for Digital TV function · Any functions related to Digital TV ( ) will only work in countries or areas where DVB-T (MPEG2) digital terrestrial signals are broadcasted. Please confirm with your local dealer if you can receive a DVB-T signal where you live. · Although this TV set follows DVB-T specifications, compatibility with future DVB-T digital terrestrial broadcasts cannot be guaranteed. · Some Digital TV functions may not be available in some countries. 2 GB Table of Contents Start-up Guide 4 Safety information .....................................................................................................................7 Precautions .............................................................................................................................10 Overview of the remote ........................................................................................................11 Overview of the TV buttons and indicators ........................................................................12 Watching TV Watching TV............................................................................................................................13 Checking the Digital Electronic Programme Guide (EPG) .............................................16 Using the Favourite list ..................................................................................................18 Viewing pictures from connected equipment ..........................................................................19 Using MENU Functions Navigating through menus ......................................................................................................20 Picture menu ...........................................................................................................................21 Sound menu............................................................................................................................23 Screen menu...........................................................................................................................25 Set-up menu............................................................................................................................26 PC Settings menu ...................................................................................................................28 Analogue Set-up menu (Analogue mode only) .......................................................................29 Digital Set-up menu .......................................................................................................31 Using Optional Equipment Connecting optional equipment...............................................................................................33 Additional Information Specifications ..........................................................................................................................36 Troubleshooting ......................................................................................................................38 Index .......................................................................................................................................40 : for digital channels only 3 GB Start-up Guide 1: Checking the accessories Remote RM-ED005 (1) Size AA batteries (R6 type) (2) Mains lead (Type BF) (1) 2: Connecting an aerial/ VCR Connecting an aerial only Coaxial cable (supplied) Coaxial cable (1) Cable holder (1) Mains lead (supplied) Connecting an aerial and VCR Support belt (1) and screws (2) To insert batteries into the remote Mains lead (supplied) RF lead (not supplied) Notes · Observe the correct polarity when inserting batteries. · Dispose of batteries in an environmentally friendly way. Certain regions may regulate disposal of the battery. Please consult your local authority. · Do not use different types of batteries together or mix old and new batteries. · Handle the remote with care. Do not drop or step on it, or spill liquid of any kind onto it. · Do not place the remote in a location near a heat source, or in a place subject to direct sunlight, or in a damp room. Scart lead (not supplied) VCR 4 GB 3: Bundling the cables 5: Selecting the language and country/ region 2 1 Start-up Guide 2 4: Preventing the TV from toppling over 1 2 3,4 3,4 Connect the TV to your mains socket (220240V AC, 50Hz). Press 1 on the TV (top side). When you switch on the TV for the first time, the Language menu appears on the screen. When the TV is in standby mode (the 1 (standby) indicator on the TV (front) is red), press "/1 on the remote to switch on the TV. 2 3 1 Continued 5 GB 3 Press F/f to select the language displayed on the menu screens, then press . 1 Before you start auto-tuning the TV, insert a pre-recorded tape into the VCR connected to the TV (page 4) and start play back. The video channel will be located and stored on the TV during auto-tuning. If no VCR is connected to the TV, this procedure is not required. Go to step 2. 2 Select "OK", then press . 4 Press F/f to select the country/region in which you will operate the TV, then press . The TV starts searching for all available digital channels, followed by all available analogue channels. This may take some time, please be patient and do not press any buttons on the TV or remote. If a message appears for you to confirm the aerial connections No digital or analogue channels were found. Check all the aerial connections and press to start auto-tuning again. 3 When the Programme Sorting menu appears on the screen, follow the steps of "Programme Sorting" (page 29). If you do not wish to change the order in which the analogue channels are stored on the TV, go to step 4. If the country/region in which you want to use the TV does not appear in the list, select "-" instead of a country/region. The message confirming the TV start auto-tuning appears on the screen, then go to "6: Auto-tuning the TV". 4 Press MENU to exit. The TV has now tuned in all the available channels. 6: Auto-tuning the TV The TV will now search for and store all available TV channels. 2 4 6 GB Safety information Mains lead · Unplug the mains lead when moving the TV set. Do not move the TV set with the mains lead plugged in. It may damage the mains lead and result in fire or electric shock. · If you damage the mains lead, it may result in fire or electric shock. ­ Do not pinch, bend, or twist the mains lead excessively. The core conductors may be exposed or broken, causing a short-circuit, which may cause fire or electric shock. ­ Do not modify or damage the mains lead. ­ Do not put anything heavy on the mains lead. Do not pull the mains lead. ­ Keep the mains lead away from heat sources. ­ Be sure to grasp the plug when disconnecting the mains lead. · If the mains lead is damaged, stop using it and ask your dealer or Sony service centre to exchange it. · Do not use the supplied mains lead on any other equipment. · Use only an original Sony mains lead, not other brands. · It is strongly recommended that you use Sony accessories for safety reasons: ­ KDL-46S2000/KDL-46S2010/KDL-40S2000/ KDL-40S2010: Wall-mount bracket SU-WL51 ­ KDL-32S2000/KDL-32S2010/KDL-32S2020/ KDL-26S2000/KDL-26S2010/KDL-26S2020: Wall-mount bracket SU-WL31 · It is strongly recommended that you use the official Sony wall-mount bracket to allow adequate air circulation and to avoid dust build up around the TV, wall and ceiling. · Secure the TV set properly, following the instructions supplied with your wall-mount bracket when installing the TV set. Installation · If the TV set is to be installed on a wall, have the installation carried out by qualified service men. Improper installation may render the TV set unsafe. · The TV should be installed near an easily accessible mains socket. Medical institutions Do not place this TV set in a place where medical equipment is in use. It may cause malfunction of medical instruments. Carrying · Before carrying the TV set, disconnect all the cables from the TV set. · When you carry the TV set by hand, hold the TV set as illustrated on the right. If you do not do so, the TV set may fall and be damaged or cause serious injury. If the TV set has been dropped or damaged, have it checked immediately by qualified service personnel. · When transporting it, do not subject the TV set to jolts or excessive vibration. The TV set may fall and be damaged or cause serious injury. · When you carry the TV set in for repair or when you move it, pack it using the original carton and packing material. · Carrying the TV set requires two or more people. Mains lead/cable protection Pull out the mains lead/cable by the plug. Do not pull on the mains lead/cable itself. Mains Do not use a poor fitting mains socket. Insert the plug fully into the mains socket. A poor fit may cause arcing and result in fire. Contact your electrician to have the mains socket changed. For the TV set with a three-wire grounding type AC mains plug This TV set must be connected to an AC mains socket with a protective earthing connection. Ventilation · Never cover the ventilation holes in the cabinet. It may cause overheating and result in fire. · Unless proper ventilation is provided, the TV set may gather dust and get dirty. For proper ventilation, observe the following: ­ Do not install the TV set turned backwards or sideways. ­ Do not install the TV set turned over or upside down. ­ Do not install the TV set on a shelf or in a closet. ­ Do not place the TV set on a rug or bed. ­ Do not cover the TV set with cloth, such as curtains, or items such as newspapers, etc. Optional accessories Observe the following when installing the TV set using a wall-mount bracket. If you do not do so, the TV set may fall and cause serious injury. Continued 7 GB · Leave some space around the TV set. Otherwise, aircirculation may be inadequate and cause overheating, which may cause fire or damage to the TV set. · Do not touch the mains lead and the TV set with wet hands. Doing so may cause electric shock or damage to the TV set. 30 cm 10 cm 10 cm 15 cm Moisture and flammable objects · Do not let this TV set get wet. Never spill liquid of any kind on the TV set. If any liquid or solid object does fall through openings in the cabinet, do not operate the TV set. It may result in electric shock or damage to the TV set. Have it checked immediately by qualified service personnel. · To prevent fire, keep flammable objects ( ...