» CD-GT1 @# Portable CD Guitar Trainer This appliance has a serial number located on the rear panel. Please record the model number and serial number and retain them for your records. Model number _____________ Serial number _____________ OWNER'S MANUAL D00851000A Important Safety Precautions CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Y FOR U.S.A. TO THE USER This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following countermeasures. a) Reorient or relocate the receiving antenna b) Increase the separation between the equipment and receiver. c) Connect the equipment into an outlet on a circuit other from that to which the receiver is connected. d) Consult the dealer or an experienced radio/ TV technician for help. The lightning flash with arrowhead symbol, within an equilateral trinagle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. E WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. R CAUTION Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user's authority to operate this equipment. 2 -- TASCAM CD-GT1MKII Important Safety Instructions 1 Read these instructions. 2 Keep these instructions. 3 Heed all warnings. 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with dry cloth. 7 Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9 Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10 Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11 Only use attachments/accessories specified by the manufacturer. 12 Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13 Unplug this apparatus during lightning storms or when unused for long periods of time. 14 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. · Do not expose this apparatus to drips or splashes. · Do not place any objects filled with liquids, such as vases, on the apparatus. · Do not install this apparatus in a confined space such as a book case or similar unit. · The apparatus draws nominal non-operating power from the AC outlet with its POWER switch in the off position. TASCAM CD-GT1MKII -- 3 Important Safety Instructions Safety Information This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown here. CAUTION · DO NOT REMOVE THE PROTECTIVE HOUSING USING A SCREWDRIVER. · USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. · IF THIS PRODUCT DEVELOPS TROUBLE, CONTACT YOUR NEAREST QUALIFIED SERVICE PERSONNEL, AND DO NOT USE THE PRODUCT IN ITS DAMAGED STATE. Optical pickup: Type KSM-900AAA Manufacturer: SONY CORPORATION Laser output: <1 mW play on the objective lens Wavelength: 775--816 nm 4 -- TASCAM CD-GT1MKII Table of contents Handling of compact discs ............................................. 6 About the power supply ................................................. 7 Part names and functions ............................................... 9 Making connections ..................................................... 12 Using the menu system ................................................ 14 Using the CD player ...................................................... 16 Pitch and tempo changes ............................................. 17 Using CD effects ........................................................... 18 Using built-in effects .................................................... 19 Effect presets ............................................................... 21 Using the metronome ................................................... 22 Using the tuner ............................................................. 23 Changing your preferences for the CD-GT1MKII .......... 24 Facts and figures (specifications) ................................. 25 About this Manual: When we refer to a key or connector or control on the CD-GT1MKII, the typeface looks like this: PLAY. When we refer to items shown on the display, the typeface looks like this: MENU. TASCAM CD-GT1MKII -- 5 Handling of compact discs Observe the following: Always place compact discs in the tray with their label facing upward (compact discs can only be played on one side). To remove a disc from its storage case, press down on the center of the case, and lift the disc out, holding it carefully by the edges. disc. Small dust particles and light stains will have absolutely no effect on reproduction quality. Only use circular compact discs. Avoid using noncircular promotional, etc. discs. Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to clean compact discs. Such chemicals will do irreparable damage to the disc's plastic surface. Discs should be returned to their cases after use to avoid serious scratches that could cause the laser pickup to "skip". Don't expose discs to direct sunlight or high humidity and temperature for extended periods. Long exposure to high temperature can warp the disc. 6 -- TASCAM CD-GT1MKII Finger marks and dust should be carefully wiped off the disc's recorded surface with a soft cloth. Unlike conventional records, the compact disc has no grooves to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles. Wipe in a straight motion from the inside to the outside of the To keep the laser pickups clean, do not touch them. For the same reason, do not leave the disc tray open unnecessarily. The CD-GT1MKII cannot play unfinalized CD-R/RW discs. In addition, some finalized CD-R/ RW discs may be unplayable on the CD-GT1MKII. About the power supply Operation using batteries Take off the cover of the battery compartment at the back of the CDGT1MKII and insert four AA (SUM3) batteries (not supplied) following the + and ­ markings inside the battery compartment. CAUTION We strongly recommend the use of rechargeable Ni-MH batteries (alkaline batteries may also be used). Your CD-BT1MKII may not operate properly with batteries of other types. WARNING Misuse of batteries may cause leaks and explosions. Please carefully read and follow the instructions below: Make sure the batteries are inserted in the correct direction, according to the markings inside the battery compartment. Always use batteries of the same type, and replace all batteries together. Do not attempt to recharge batteries that are not rechargeable. If you are not going to use the CD-GT1MKII for longer than one month, remove the batteries. Do not throw batteries into water or fire. Do not disassemble batteries. If a battery leaks in the compartment, wipe the liquid away completely with a disposable cloth. Make certain no residue remains before inserting new batteries. as the battery symbol as follows: 3 parts are lit There is plenty of battery charge left. 2 parts are lit Battery charge is approximately half. 1 part is lit Not much battery charge is left. 3 parts blink Battery charge is nearly gone. Replace with fully charged batteries. Auto power-save While using battery power, the CD player and CD functions of the CDGT1MKII shut down automatically if any of the following conditions lasts more than 5 minutes: (the CD part of the display shows CD OFF). Being in Stop mode CD drive cover is open No CD is loaded To turn the CD player on, press the PLAY key. TASCAM CD-GT1MKII -- Notes on batteries When you are using the CDGT1MKII with batteries, unplug the AC adapter. Remaining battery charge level display When the CD-GT1MKII is running on batteries, a rough indication of the remaining battery charge is displayed as 7 About the power supply (Continued) CAUTION Because the CD-GT1MKII is equipped with special functions such as key change and effects, the battery life is shorter compared with standard portable CD players. The length of battery life in CD-GT1MKII is affected by both the environment and the number of functions in use. Factors that affect battery life include temperature, humidity, the number of special functions used, and so on. Under some circumstances, there may not be enough power in the batteries to power the CD-GT1MKII, despite the battery power indication on the display. If this happens, change the batteries, or use an AC adapter. Always dispose of used batteries as recommended by your local authorities. Operation using an AC adapter Connect a TASCAM PS-PS5 AC adapter (sold separately) to the DC IN jack at the back of the CD-GT1MKII. Insert the plug of the AC adapter into a domestic AC power outlet. Make sure that the voltage of the outlet corresponds to that marked on the adapter. PS-PS5 Wall outlet inside. If you plug in an AC adapter but have forgotten to take out the batteries, turn the power off using the POWER switch, and take out the batteries. Likewise, turn the power off before you change between using the batteries and using the AC adapter. Unplug the AC adapter from the domestic AC power outlet when you are not using the CD-GT1MKII. Settings may not be properly saved if you turn the power off immediately after inserting a CD or changing settings. If settings are not saved properly, the system may not start with the last settings and instead will start using the default values. DC plug Switching the unit on and off WARNING Use only a PS-PS5 AC adapter with your CDGT1MKII. Using another type of AC adapter may damage your CD-GT1MKII. Length of battery life Use the POWER switch to turn the power to the whole unit on and off. Ni-MH batteries: Approx. 4.5 hours Alkaline batteries: Approx. 1.5 hours CAUTION Remove the batteries before operating the CD-GT1MKII with an AC adapter. There is a possibility of slight noise if you use the unit with an AC adapter while the batteries are 8 -- TASCAM CD-GT1MKII Part names and functions When there are two different words above and below the same key (e.g. TUNER and SETUP), you use the key like this: To activate the function written above the key: Tap the key once To activate the function written below the key Press down the key and hold it For example, in the case of the TUNER/ SETUP key, the Tuner menu is activated when you tap the key lightly, and if you press and hold it down the key activates the Setup menu. TASCAM CD-GT1MKII -- 9 Part names and functions (Continued) 1) DC IN Jack Use this jack to connect the DC plug of a TASCAM PS-PS5 AC adapter (sold separately). modify the setting values while in menu mode (See Using the menu system). You can also ...