AXON AX 100 MKII Firmware update To update the Firmware in your AX 100 MKII, please follow these steps: First install the latest version of the software editor and save your personal settings and presets to your computer. Press "PRESET" + "UTILITY" + "EDIT" buttons while switching on the AX 100 MKII. The display will show: TerraTec AXON Firmware update You can now release the buttons. Please wait until the display shows: Start editor and load update file Start the AXON AX 100 Editor Software on your computer. Make sure that a MIDI out port of your computer is connected to the AX 100 MKII. Select the correct PC MIDI out device in the Global page of the Editor Software. Press "Load" in the "SysEx File" box. A file open dialog will appear. Set the Filetype selector to "All Files (*.*)" Find the folder where your update file is located, select the update file (ending with .axu) and press "open". A Progress bar Window will open. The Axon display will show: Loading update - - - Wait until the upload has finished. The Axon display will show: Erasing Flash Wait until Erasing has finished. The Axon display will show: Programming Flash Finally the AXON will automatically restart and run the new firmware. If this doesn't happen please restart the AXON manually. Please wait until the progress bar is competed because otherwise it could be that the firmware-update has not been completed in the flash and this would cause a total crash of the device. TerraTec Electronic GmbH, Herrenpfad 38, 41334 Nettetal, Germany ...