User manual TORNADO BOSS B4205

ifu_4205.qxd 2003.07.08. 10:07 Page 1 Electrolux Group Floorcare Helpline 08706 055 055 4501 02 02 01 ifu_4205.qxd 2003.07.08. 10:07 Page 2 B4205 ifu_4205.qxd 2003.07.08. 10:07 Page 3 B4205 ifu_4205.qxd 2003.07.08. 10:07 Page 4 B4205 ELECTRICAL SUPPLY INSTRUCTIONS Before you start ...check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. If is not, do not use the cleaner but refer back to your dealer. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13AASTA approved BS1362 fuse and the fuse cover mustbe replaced before the plus is used again. In the event ofloss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electricity Board and must be of the same colour as indicated by the coloured insert on the base plug. If difficulty is experienced in obtaining a replacement, contact your nearest Electrolux Service Centre. (Please see the separate Electrolux Service Organisation leaflet). The wire which is coloured blue must be connected to the terminal which marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth-connection is necessary.] It is in you interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot In no circumstances must be plug be used with- regard the repair of faults on the plug connection as a out a correct fuse cover fitted. service that can be given free of charge under the If the plug that is fitted to your appliance is not suitable terms of guarantee. for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off As a general guide to fitting any plug. plug. The cutoff plug should then be disposed of to · Ensure the lengths of wire inside the plug are preprevent hazard of shocks in case it should be plugged pared correctly. into a 13 Amp socket in another part of your home · Connection should be firmly made after all conductor stands are entered into the terminal posts. The wires in the mains cable of this appliance are · When preparing the cable ends take care not to coloured in accordance with the following code: damage the outer seal, or insulation surrounding the Blue: Neutral. inner conductors. Browm: Live. · Tighten all screws. · Replace the top cover of the plug and secure. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: ifu_4205.qxd 2003.07.08. 10:07 Page 5 B4205 When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: · Do not use out doors or on wet surfaces. · Do not leave vacuum cleaner when plugged in. · Do not allow to be used as a toy. Close attention is necessary when used near children. Do not allow children to operate this appliance. · Use only as described in this manual. Use only manufacturer's recommended attachments. · Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. · Do not pull or carry by cord, use cord as a handle, close door on cord. Keep cord away from heated surfaces. · Do not use extension cords or outlets with inadequate current carrying capacity. · Turn off all controls before unplugging. · Do not unplug by pulling on cord. To unplug, grasp the plug not the cord. · Do not handle plug or vacuum cleaner with wet hands. · Do not put any object into openings. Do not use with any opening block, keep free of dust, lint, hair and anything that may reduce air flow. · Do not use to pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. · Do not use without dust bag in place. · Use extra care when cleaning on stairs. · Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. · Store your cleaner indoors in a cool, dry area. · Keep your work area well lighted. · Unplug electrical appliances before vacuuming them. SAVE THESE INSTRUCTIONS ifu_4205.qxd 2003.07.08. 10:07 Page 6 B4205 GUARANTEE This guarantee is in addition to your statutory and other legal rights. BOSS products are carefully designed, manufactured, tested and inspected and in consequence, we undertake to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original purchaser, free of charge. You may be required to take the product to your nearest service provider if the product requries attention during the first year. There are certain conditions which may invalidate this guarantee: a. It is dependent upon the appliance being correctly installed and used in accordance with the Company's instructions under normal domestic conditions within the United Kingdom or the Republic of Ireland. b. Service at all times must be carried out by an Electrolux Service Representative or authorised agent. c. The guarantee may be invalidated by unauthorised repair or modification of the appliance. d. You may be changed by the Electrolux Group if you call for an engineer to resolve a problem that we believe is covered in the instruction booklet. The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as filters, brushes and dust bags as the life of these depends upon the amount and nature of use. Proof of the date of purchase will be required before service under guarantee is provided. For futher assistance call the Electrolux Group Floorcare Helpline on 08706 055 055. Important: For future reference we suggest you record the following details here, and keep the receipt with this booklet as proof or purchase. Purchased from: ____________________________________________________ Date purchased _______________Model No _____________________________ The Electrolux Group, 101 Oakley Road, LUTON, BEDFORDSHIRE, LU4 9QQ Featrues of the BOSS vacuum cleaner and accessories with it are protected in Great Britain and abroad by Patents of Registered Designs. This appliance conforms with the requirements of the amended E.E.C. directive No. 89/336/EEC relating to electromagnetic compatibility (EMC) CE. The Electrolux Group may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteretion without notice. ifu_4205.qxd 2003.07.08. 10:07 Page 7 B4205 ifu_4205.qxd 2003.07.08. 10:07 Page 8 B4205 MAINTENANCE REPLACING THE DUSTBAG Always operate the cleaner with the dustbag installed. If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not close completely. After removing the flexible hose, open the front cover using the compartment open button. (fig. 20) Rotate the support of the bag to the vertical position. Remove the dustbag and insert a new one. (fig. 21) Close the cover by pressing down until it clicks. (fig. 20) The dustbag reference number is U62. BLOCKED AIRFLOW AND DIRTY FILTERS The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are blocked with dirt. Disconnect from mains and allow the cleaner to cool for 45-60 minutes. Remove blockage and/or clean filters. Restart the cleaner. REPLACING THE FILTERS The dustbag must be replaced if the window of the dustbag full indicator is illuminated when the cleaner is operating at maximum power and the nozzle is raised from the floor. Filters should be replaced at least twice a year or when they become visibly soiled. Always operate the cleaners with filters installed to avoid reduced suction. Disconnect from electrical outlet before cleaning filters. Replacing the motor filter Pull dustbag upward and remove the motor protection filter. (fig. 22) Put a new motor filter into the cleaner and close the front cover. Replacing the exhaust filter Open the filter grill to remove the exhaust filter with grill. (fig. 23-24) Take off the filters from the grill. (fig. 25) Put a new filter back on to the filter grill. (fig. 25) Put the filter with grill back into the cleaner. (fig. 24) Close the filter grill. (fig. 23) ifu_4205.qxd 2003.07.08. 10:07 Page 9 B4205 SERVICE Should you require service on your Boss cleaner, please telephone the Electrolux Group Floorcare Helpline on 08706 055 055. PROTECTING THE ENVIRONMENT Attempt to recycle packaging material and old appliances. The cardboard packaging can be placed in the waste paper collection. Deposit the plastic bag made of polyethylene (PE) at the PEcollection point for recycling. Recycling the appliance at the end of its life: The plastic components all carry a material identification marking so that, like the other materials, they can by recycled at the end of the life of the appliance. Please inquire with your local authority. ifu_4205.qxd 2003.07.08. 10:07 Page 10 B4205 DESCRIPTION OF PARTS 1. Suction inlet 2. Dustbag full indicator 3. Variable power control 4. On/off switch 5. Cable rewind button 6. Wheel 7. Dustbag compartment 8. Carrying handle 9. Compartment open button 10. Hose 11. Metal tubes 12. Dual purpose floor nozzle 13. Combination crevice nozzle/brush 14. Upholstery nozzle with plush plate 15. Dusting brush 16. Dustbag 17. Vertical parking 18. Horizontal parking 19. Tools on board IMPORTANT SAFEGUARDS Please read this instruction booklet carefully. Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate. Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug. Do not try to repair the appliance by yourself. For repairs or accessories, contact the Electrolux Group Floorcare Helpline on 08706 055 055. Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations. Never leave the appliance unattended when it is switched on. Keep the appliance out of reach of children. This appliance is for domestic use only. Use as described in this instruction booklet. Do not pull the appliance by the cord. Do not unplug by pulling on the cord. Do not use the appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts. Do not vacuum up any highly flammable or explosive substances or gases. Do not unplug the vacuum cleaner with wet hands. Do not operate or store the vacuum cleaner too close to heaters and radiators, stoves etc. Before you start using the vacuum cleaner, please remove large or sharp objects from the floor in order to prevent damage to the dustbag, textile bag and hose. INSTRUCTIONS FOR USE Before operating the vacuum cleaner, make certain that the filters are in the proper position. Unwind a sufficient length of cable and insert the plug into the power socket. A YELLOW mark on the power cable shows the ideal cable length. Do not extend the cable beyond the RED mark. Press the ON/OFF button to switch the appliance on. It is advisable to set the power control to MIN before switching on the appliance. To rewind the power cable, press the rewind button with your foot, and guide the cable with your hand to ensure that it does not whip causing damage. By moving the variable power control, the suction power can be adjusted to suit different types of flooring i.e. MIN setting for vacuuming light rugs. Always remove the hose from the vacuum cleaner when in storage.