User manual TORNADO TO1150P

Français 2 English 4 Español 6 Português 8 Please keep both flaps open when reading these operating instructions. Getting Started · Check the dust bag is in place · Insert the hose until the catches click to engage. (Press catches inwards to release). · Attach tubes (some models) or telescopic tube (some models) to the hose handle and floor nozzle by pushing together. (Pull apart to dismantle). · Extend the cable and connect to mains. The 4x4 is fitted with cable rewind, ensure cable is not twisted before use. (Press foot pedal to rewind. Note: Please hold the plug to prevent it striking you or the machine). · Press the On/Off foot pedal to activate the cleaner · To reduce suction, gradually open the aperture on the hose handle. (some models) slide the electronic suction control between `+' and `-'. A Tools for your Quatro Dust bags Extension tubes (x2) (some models) Telescopic tube (some models) Swivel hose and handle with manual suction control Combination carpet/hard floor nozzle Narrow crevice nozzle Upholstery nozzle Dusting brush (some models) Small tool holder (some models) tool holder (some models) B C D E G H I J KLarge Ensuring your safety The 4x4 is for domestic use only and has been designed to ensure maximum safety and performance. Please follow these simple precautions: A B C D E F G H I J K L M N X Your 4x4 features Mains cable Cable rewind pedal Power outlet (for the use of power driven tools) (some models) Electronic suction control (some models) Mechanical dust bag indicator Hose connection Dust bag security device ­ prevents lid closing without a dust bag in place Carrying handle Cover release catch for dust bag compartment On/off switch Storage slot for floor nozzle and extension tubes when in use Storage slot for floor nozzle and extension tubes when not in use Tool holder (for attachment to hose handle or extension tube) with slot for wall mounting (some models) holder (for attachment to hose handle) (some models) L M N O P Q R S T U W The 4x4 is double-insulated so it must not be earthed. The 4x4 is only to be used by adults Always store in a dry place Do not use to pick up liquids Avoid sharp objects Do not pick up hot cinders or lighted cigarette ends Do not use near flammable gases Avoid tugging on the mains cable and check cable regularly for damage Note: Do not use your cleaner with a damaged cable. If damaged the cable should be replaced at an authorised service centre The Plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised service staff Y c t d e f g h i j k J KTool 4 n Getting the best results Carpets: Use the floor nozzle with the lever in this position. Hard floors: Use the floor nozzle with the lever in this position. Loose rugs/curtains/lightweight fabrics: Reduce the suction power. Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. Lamps, pictures and bookshelves: (some models) Use the dusting brush. Confined areas: Use the crevice nozzle for crevices, corners and radiators. Dust bag indicator and changing the dust bag For peak performance the dust bag must be changed when full. If the dust bag breaks in the cleaner, the 4x4 must be taken to an Authorised Service Centre for cleaning. The dust bag indicator window will gradually turn red when filling and completely red when full. To check the dust bag, the cleaner must be switched on, with all attachments connected and off the floor. The dust bag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. If this occurs change the dust bag even if it is not full. To change the dust bag: A Release catch and swing back lid before removing the dust bag, bend the tab into the hole to prevent dust escaping B Remove the dust bag C Insert new dust bag by fitting the bag slots over holders. We recommend the dust bag is changed: * after using a carpet cleaning powder * if there is a bad smell from the cleaner, when you should also change the filter. Note: Use only original dust bags and filters Dust bag safety device To avoid damaging the cleaner do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Do not attempt to force cover shut. Changing the filters These should be changed every fifth dust bag. Never use the cleaner without the motor protection filter. To change filters: a) Lift lid, remove dust bag and filter b) Insert new filter, replace dust bag and close. There is also an exhaust filter. To change it: a) Lift rear grill and remove filter b) Insert new filter and replace grill. o p q r Troubleshooting 1. Power: If the electric power does not come on, disconnect from mains and check plugs, cable and fuses where appropriate. 2. Blockages/dirty filters: The cleaner may switch itself off in the event of a severe blockage or excessively dirty filter(s). In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or replace filter(s) and restart. The clearing of blocked hoses is not covered by the guarantee. To avoid blockages and maintain suction efficiency, the floor nozzles should be cleaned regularly using the hose handle. 3. Water: If water is sucked into the cleaner the motor must be changed at an Authorised Service Centre.