User manual UFREE SCOOTER SCOOTER ELETTRICO FS-E12

UFREE SCOOTER www.scooter-manufacturer.com INSTRUCTION MANUAL ELECTRIC SCOOTER FS-E12 UFREE SCOOTER www.scooter-manufacturer.com INTRODUCTION CONGRATULATIONS! The electrical scooter is a kind of new fashion motorized vehicle. It can be replaced as walking. It is energy saving, entertain able, and is environment protection sport vehicle. Our electric scooter is small, long riding time, easy for carry, and easy for repair. Please let our product. Tiger sting Ray Electric Scooter stay with you throughout your day. Before using the scooter, please read all the instructions consist inside the manual. In order for us to better serve you, let us know how our product works. THANK YOU FOR SELECTING OUR ELECTRIC SCOOOTER, WE HOPE YOUR WILL ENJOY THE EXCITING RIDING. UFREE SCOOTER www.scooter-manufacturer.com KNOWING YOUR SCOOTER The scooter will be as the following: Speed throttle control Brake handle Seat saddle Battery indicator Front light Folding accessories Seat collar clamp Brake light Front wheel Back wheel Fuse socket Plastic cover Charger socket Stand Rear brake Fig1. Scooter with full assembly showing name for each part Also, you should have the following with your scooter Fig2. The changer and how it connects. Also, for your convenience, the following access or are provided. 1 UFREE SCOOTER www.scooter-manufacturer.com Fig 3 tools set Here is the specification for your scooter: Weight (including Battery): 30kgs Load Capacity: 85kg Brake system: hand front, rear brake Full Charge Mileage: 20km Max Speed: 20km/hr System Voltage: 24V Motor Power: 300W Charge Voltage: 100-230V Battery: 12V 12AH*2pcs Charge time: 4-6 hours Tyres: Rubber pneumatic tyres 2 UFREE SCOOTER www.scooter-manufacturer.com ASSEMBLY INSTRUCTION 1. Pick out all the things from the carton box; you will have all the following things Scooter and its accessories ¡Á ¡Á 1set 1set tools set ¡Á ¡Á ¡Á 1set 1set 1piece Basket charger instruction manual 3 UFREE SCOOTER www.scooter-manufacturer.com 3. To finish the assembly, you need to put the fuse into the fuse socket. Remove the cover of the fuse socket and put the fuse on the cover, then re-close the cover. WARNING: when putting on the fuse, please make sure the power key switch turns to OFF. · how to install the fuse 4. Check all the locks and bolts, make sure all the locks and bolts tighten, you have finished assembly the scooter. 4 UFREE SCOOTER www.scooter-manufacturer.com RECHARGING INSTRUCTION & BATTERY CARING Each scooter has one "T" mark adaptor. To recharge of the battery, please read the following instruction: 1. Connect the charger as the picture show. 2. Use the recharging adaptor provided, plug against the electric wall slot while the other cord connect to the scooter (charging socket located at the side of the deck.) 3. Complete recharging time takes 12 hours. 4£® If the scooter is shelved for a long time, the battery must recharge once per month. 5. Unplug the charger and put the charger in safety places. CAUTION: the PES mark charge have the function of auto stop charging process, in order to proceed the charging, you must connect the plug to the scooter first and then connect with AC supply. The charger must keep in good condition which should not be contact with heat or fire. Those broken charger cannot be used anymore. Please contact with your dealers if happened. Warning: Use only the charger as per attached for this scooter, other chargers may cause accident when charging. How to keep the battery in long life: The completely charging time for a battery is around 12 hours. For first time charging, it is recommended to charge at least 16 hours. Charge the battery every time after using. Recharging process must be complete once the process is started. This helps to extend the battery life. Does not use the scooter while the battery showing low energy. If it is over used, the battery will reduce its life. 5 UFREE SCOOTER www.scooter-manufacturer.com SAFETY INSTRUCTIONS Before riding the electric scooter, please read the following instruction carefully. DO: 1. This Electric Scooter should be used by people aged over 14 or under the supervision of an adult. 2. For people weight more than 200 lbs should not use this Electric Scooter. 3. Do read the whole manual and follow all the safety and maintenance recommendations made there. 4. Do check the electric scooter thoroughly before used. Make sure all the part and install correctly and tightly. 5. Do switch off the key to turn off the power after used every time. 6. Do keep the body part away from the moving part of the scooter. 7. Do avoid use the scooter on gravel, sand, grass, mud, water and rough surface area. 8. Do wear a safety helmet when riding. 9. Do getting alert to any contingent accident. DON'T 1. Don't use this electric scooter in the rain to prevent short circuit. 2. Don't place the battery near the fire or heat to prevent exploded. 3. Don't explode the charger to moisture or water. 4. Don't allow the child under 14 years of age to handle the scooter without the supervision of an adult 5. Don't ride the scooter with more than a person at the same time. 6. Don't riding the scooter after drinking alcohol. 7 UFREE SCOOTER www.scooter-manufacturer.com OPERATING THE SCOOTER After assembly and charging your scooter, your scooter is ready to ride. Put the key into the power key switch; turn to "ON" status. Test all the electric functions before riding on the road, including direction light, front light, horn and brake light. It is suggested user should have a short test for the scooter before riding on the road. To start the running, turn the accelerator anti clockwise to start movement and increase the speed. You can adjust the speed by turning the accelerator. The speed for the scooter can rise up to 25 km/hr. The actual speed is depended on the user weight, the road, tyre pressure and other factors. To stop the scooter, you can release the accelerator by turning clockwise. Doing this, your scooter will slow down and stop. Moreover, a rear brake system has been installed to your scooter. When your pull the brake, it will automatically cut off the power supply to the motor and slow down. Then the rear brake on the back tyre will stop the scooter. CAUSION: For safety reason, your brake system won't stop the scooter once it is applied immediately. Do be aware whenever you are driving the scooter. After riding the scooter, you must turn the key power to "OFF" status, to avoid unexpected accident and save energy. Also, do charge the battery after each usage. 8 UFREE SCOOTER www.scooter-manufacturer.com TROUBLESHOOTING GUID Problem Power does not on Possible causes 1. The fuse does not install / not function 2. Power key switch do not turns to "ON" status 3. Battery is not connected 4. Battery is drained 5. Electric fault Motor does not work even the power is on 1. The accelerator handle bar is broken. 2. Brake is too tight 3. Motor problems occurs 4. The connection of electric for the accelerator is broken. 5. Circuit breaker tripped 6. The brake pulled firmly Action 1. Replace the fuse 2. Turn on the Power key and try again 3. Connect the battery by open the cover 4. Charge the battery 5. Check all the connections 1. Check the connection of the accelerator, or change one. 2. Adjust the brake system. 3. Contact to the technician 4. Check the connection 5. Turn off the power and wait for 5 second 6. Restore the brake Rear tyre not works normally I. The brake is too tight 2. The chains is too loose 1. Adjust the brake system 2. Adjust the chain system (note 1) Insufficient Range 1. Battery is not power enough 2. Low tyre pressure 3. Popping sound 1. Charge the battery 2. Pump the tyre. If you found can't pump the air in, please check the tyre. 3. The chains are too loose (note 1) Charging not proceed 1. Not power supply to the charger 2. Auto disconnect function of the charger occurs 3. The charger broken 1. Please make sure all the connection is correct 2. Please remove the charger totally. Connect the charger with the scooter first, and then connect to the AC power supply. 3. Please contact with dealer for a new charger. 8 UFREE SCOOTER www.scooter-manufacturer.com Note 1: drive chain adjustment Periodic adjustment of the drive chain will be necessary to maintain proper tension. If the chain is too loose, it will make a "popping" noise while accelerating, indicating the need for immediate adjustments. Before Adjusting the chain, please make sure to disconnect the battery power to prevent accident starts or shocks. Lose the rear axle nuts until the tyre can be moved easily. Adjust the rear tyre position to change the tension by adjusting the back tyre adjusting screw. Check the tension by rotating the tyre by hand. Be sure that the tension of the chain should be proper only. To tight may cause easy broken and the axis of the tyre to be parallel to the motor. Tighten the axle nuts and recheck the tension. After Sales Service and repair of electrical scooter 1. If there are any problems with our products while being use, feel free to contact your retailer as soon as possible, The retailers will help you diagnose your product and have some kind of repair methods for you to repair your scooter. 2. If the battery, engine, charger, chain, and activator are damaged within the 3 month warranty . the retailer will be informing to replace or repair(if available).The valid date of warranty starts on the date of the invoice that you had purchased the scooter. 3. For the first 30 days everything on the scooter is cover by the warranty. After that, only major electrical components listed in number two statement are cover. Everything else is considering accessor. 9 UFREE SCOOTER www.scooter-manufacturer.com IMPORTANT BEFORE EACH USE PLEASE INFORMATION CHECK THE FOLLOWING: 1. All users read safety/operation information 2. Tyre condition and pressure 3. Brake condition and operation 4. Drive belt/chain condition and adjustment 5. Wires and cables. Condition/secure 6. Oil/grease bearings (DO NOT OIL OR GREASE DRIVE BELT) 7. Battery fully charged 8. All securing nuts, bolts and screws are tightened 9. When charging, always connect charger to scooter before turning power on 10.Over loading this unit may cause premature motor failure 11.Continuous use on steep gradients may cause motor to overheat. Please allow to cool periodically GUARANTEE This product is guaranteed for 90 days from the date of purchase against manufacturer defects. If a fault should occur within this time, we undertake to repair or replace the defective part/s free of charge. The faulty unit should be returned to the place of purchase or the address specified by your supplier for inspection, repair or replacement. 10 UFREE SCOOTER www.scooter-manufacturer.com PLEASE NOTE: Tyres, tubes, drive belts; faults due to accidental damage, misuse, wear and tear or modification of the standard product are not covered under this warranty. You must report any faults as soon as it is noticed. Unauthorized tampering with this product may invalidate the warranty. Invalid claims will be returned in the condition received (upon receipt of postage/ packaging charges). To validate warranty please complete and return form below within 14 days of purchase to unlimited Tech, 3677 san Gabriel River Parkway Pico Rivera CA 90660. Tel: 562-695-4229 Name: Address: Supplier Name & Address/Stamp Post Code: Tel. No.: Date of Purchase Product code/ Description: Serial Number: 11 UFREE SCOOTER www.scooter-manufacturer.com CERTIFICATE OF WARRANTY (only valid in conjunction with sales receipt) Name: Supplier Name & Address/Stamp Address: Please include proof of purchase Post Code: Tel. No.: Date of Purchase Product code/ Description: Serial Number: Detailed Description of Defect: 12 UFREE SCOOTER www.scooter-manufacturer.com In the event of a claim the unit should be returned, together with warranty certificate and sales receipt, to the place of purchase or the address specified by your supplier for inspection, repair or replacement. Postage &packaging cost arc the responsibility of the purchaser and excluded from warranty. P1EASE NOTE: Tyres, tubes, drive belts; faults due to accidental damage, misuse, wear and tear or modification of the standard product are not covered under this warranty. You must report any faults as soon as it is noticed. Unauthorised tampering with this product may invalidate the warranty. Invalid claims will be returned in the condition received (upon receipt of postage/ packaging charges). Sign: Print: Date: 13