E3000 Quick Installation Guide STEP 1 Connect the e3000 e3000 Quick In Before you install the Bullet Router, please ask your DSL/Cable Modem Service Provider the following questions: · Do I have a PPPoE (where you must provide a user name and password to get connected), Dynamic IP, PPtP or a Fixed IP Account? · For PPPoE users, what are my user name and password? · For Fixed IP and PPtP Account Users, what are my IP Address, Subnet Mask, Default Gateway and Domain Name Servers? Step 1. Before you start, please turn off the power to the DSL/Cable Modem, Bullet Router and your PC. Step 2. Locate the network cable connecting your PC's network card to the DSL/Cable Modem. Step 3. Remove the cable coming from the PC to the DSL/Cable Modem and insert into the e3000's connector labeled "1" while remaining connected to the PC. Step 4. Using the cable shipped with the Bullet Router, connect the Bullet Router to the DSL or Cable Modem. Insert one end of the cable to the Bullet Router's connector labeled "WAN" and other end to the DSL/Cable Modem, from where you just remove a cable (Step 3.) Step 5. Make sure the Bullet Router and the DSL/Cable Modem are on, and then reboot your PC. STEP 2 Configure the e3000 1.Open a browser on your computer and enter http://192.168.1.1 in the Address. 2.Then login the Sharing Router system with no password (by default, there is no password). Basic Setup page is as follows: Press [Setup Wizard] button to setup A.Setup Time Zone 1.Set the time zone for the Sharing Router. This information is used for log entries and client filtering. 2.Press[Next]button to continue. B.Setup WAN Type Specify the WAN connection type required by your Internet Service Provider. Specify a Cable modem (Dynamic IP), Fixed-IP xDSL, PPPoE xDSL, or PPTP. C.Setup DNS 1.Domain Name Servers are used to map an IP address to the equivalent domain name. Your ISP should provide the IP address for one or more domain name servers. Enter those addresses on this screen. 2.Press[Finish]button . You've successfully configured the e3000. D.System Status 1. Click on Advanced Setup. 2. Click on System. 3. Click on Status. You can use the Status screen to see the connection status for the Sharing Router WAN/LAN interfaces, firmware and hardware version numbers, and the number of connected clients to your network. (If your WAN IP, Subnet Mask, and Gateway are 0.0.0.0 then see instructions to reset your router.) ...