www.wacom.com DTU-710 Interactive Pen Display Installation Guide & User's Manual Wacom DTU-710 Interactive Pen Display Installation Guide & User's Manual for Windows® & Macintosh® English version 1.0, August 30, 2004 Copyright WACOM Company, Limited, 2004 All rights reserved. No part of this manual may be reproduced except for your express personal use. Wacom reserves the right to revise this publication without obligation to provide notification of such changes. Wacom does its best to provide current and accurate information in this manual. However, Wacom reserves the right to change any specifications and product configurations at its discretion, without prior notice and without obligation to include such changes in this manual. Penabled and DuoSwitch are trademarks, and Wacom is a registered trademark of WACOM Company, Limited. Photoshop is either a registered trademark or a trademark of Adobe Systems Incorporated in the United States and/or other countries. Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Apple, the Apple logo, and Macintosh are registered trademarks of Apple Computer, Inc., registered in the U.S. and other countries. Any additional company and product names mentioned in this documentation may be trademarked and/or registered as trademarks. Mention of third-party products is for informational purposes only and constitutes neither an endorsement nor a recommendation. Wacom assumes no responsibility with regard to the performance or use of these products. INTRODUCTION AND OVERVIEW The Wacom® DTU-710 Interactive Pen Display combines an LCD monitor with a Wacom pen tablet. This gives you a direct point-and-draw-on-screen interface that can be used with a Personal Computer (PC) or Macintosh® computer. The basic components of the DTU-710 include a Wacom pen tablet internally mounted behind a 17.0" diagonal TFT color LCD monitor, and a cordless, battery-free Wacom pen. This combined manual for Windows and Macintosh users describes how to install the DTU-710 hardware and software. It also describes how to use the DTU-710 and pen. Please follow all instructions carefully. The information is common to both platforms and Windows screen captures are shown, unless otherwise noted. Note that the computer treats the DTU-710 as two separate pieces of hardware (the LCD monitor and the pen tablet). Therefore, the installation process is completed in two stages: · First install the LCD monitor portion of the DTU-710. · Then install the DTU-710's pen tablet functionality. Both stages require hardware and software installations and adjustments. Please follow all instructions carefully. The following kinds of information are not included with this product: information about your specific computer hardware or operating system, or information about your application software. Your best source for this information is the set of manuals and disks that came with your hardware, operating system, or application. Refer to Unpacking the DTU-710 on page 5 when removing the DTU-710 from the box. For information on using the Tablet control panel for customizing your pen display tablet and pen settings, see Customizing on page 17. To use the pressure-sensitivity of the pen with your favorite drawing application, refer to instructions in that application's manuals. INTRODUCTION AND OVERVIEW Page 1 PRECAUTIONS ON USE AND HANDLING Be sure to follow all instructions, cautions, and warnings found within this manual. Failure to do so could cause the loss of data or damage to your computer. Failure to do so could also void your warranty, in which case Wacom shall have no responsibility to repair or replace the product. PHYSICAL LOCATION WARNING Do not use the DTU-710 Interactive Pen Display in a facility control system that requires extremely high reliability; it may cause other electronic devices to malfunction, or other devices may cause the pen display tablet to malfunction. Where use is prohibited, power off the DTU-710 to prevent the possibility of it causing other electronic devices to malfunction. Wacom does not accept any liability for direct or consequential damages. For details, please refer to your Warranty located at the end of this manual. ENVIRONMENT Temperature and Humidity · Operating temperature and humidity: 5° to 35°C, 20 to 80% RH · Storage temperature and humidity: -10° to 60°C, 20 to 90% RH CAUTION Do not use or store the DTU-710 where: · Temperature changes are severe or exceed specifications (e.g., outdoors or inside a vehicle). · The DTU-710 and pen are exposed to direct sunlight or heat from an appliance. · The DTU-710 and pen are exposed to water or any other kind of liquid. Do not use the DTU-710 in a dusty environment; this may damage the unit. CAUTION USAGE WARNING Only use the power adaptor that came with the DTU-710. If a different type of power adaptor is used, the DTU-710 will not work properly or may be damaged. Using a different type of power adaptor also has the potential to result in fire. Use of a different power adaptor will void your warranty. Be sure to use a grounded power source when applying power to the DTU-710. Do not connect or disconnect the video cable or power cables while the DTU-710 or your computer are turned on; this may damage the LCD monitor or computer video card. In this case, Wacom shall have no responsibility to repair or replace the product. This product is for use with a DVI or VGA video card; using an inappropriate video card may damage the DTU-710. Do not block the rear panel ventilation holes; this may overheat and damage the unit. When not using the DTU-710 for long periods of time, unplug the power adaptor from the AC outlet. CAUTION CAUTION CAUTION CAUTION PRECAUTIONS ON USE AND HANDLING Page 2 HANDLING WARNING High Voltage. Do not open or disassemble the DTU-710 Interactive Pen Display. There is a risk of electrical shock when the casing is open. This will also void your warranty and Wacom shall have no responsibility to repair or replace the product. If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking from it; this liquid is an irritant. In case of contact with skin, eyes, or mouth, rinse immediately with running water for at least 15 minutes or more. If contact is made with the eyes or mouth, also consult a physician. The Interactive Pen Display has a backlight which contains mercury (Hg). Be sure to manage any disposal of this unit in accordance with your local ordinances and laws. Prevent children from swallowing the pen tip or side switch. The pen tip or side switch may accidentally be pulled out if children are biting on them. Do not disassemble the pen. This may cause the device to malfunction. In this case, Wacom shall have no responsibility to repair or replace the product. Do not scratch the display screen. Avoid placing sharp objects on the display screen surface. When adjusting the tilt angle of the DTU-710, be careful to avoid catching your finger in the gap of the movable portion of the stand. Do not lift the DTU-710 by the stand; this may damage the stand mechanism. When lifting or moving the DTU-710, always do so by grasping the main body casing. Avoid intensive shock or vibration to the DTU-710 or pen. Hitting or dropping the DTU-710 may damage the display screen or other components. Do not put heavy articles on the pen display tablet or push against it with a strong force; this may damage the display screen or bend the stand. Do not place heavy articles on the DTU-710 cabling, repeatedly bend the cables sharply, or apply heavy stress to the cable connectors; this may damage the unit or cabling. If the pen tip becomes sharp or angular, it may damage the display screen. Please replace the pen tip if necessary. Do not use any organic solvent (e.g., alcohol) or even mild detergent to clean the display screen. Use of these cleaners can damage the screen. Please note that damage of this kind is not covered by the manufacturer's warranty. · To clean the display screen, use an anti-static cloth or a slightly damp cloth. When cleaning, apply only a light amount of pressure to the display screen and do not make the surface wet. · To clean the DTU-710 casing or pen, use a soft cloth with mild detergent (such as dish washing liquid) diluted with water. WARNING WARNING WARNING CAUTION CAUTION CAUTION CAUTION CAUTION CAUTION CAUTION CAUTION CAUTION PRECAUTIONS ON USE AND HANDLING Page 3 CONTENTS Introduction and Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Precautions on Use and Handling. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Physical Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Usage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Handling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Unpacking the DTU-710 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Interactive Pen Display Components. . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Front View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Rear view . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Pen Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 System Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Step 1: LCD Monitor Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Step 2: Pen Tablet Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Working with the DTU-710 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Setting Up Your Work Area . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Using the Pen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Customizing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Opening the Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Control Panel Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Control Panel Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Adjusting the LCD Monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Testing the DTU-710 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Testing the Pen Tablet and Pen. . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Display Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Troubleshooting Tables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 Technical Support Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 Obtaining Driver Downloads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Appendices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Caring for the DTU-710. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Using an Alternate Mount or Stand. . . . . . . . . . . . . . . . . . . . . . . . . 40 Uninstalling the DTU-710 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41 Product Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 Radio and Television Interference . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46 Warranty (Europe, Africa and Middle East). . . . . . . . . . . . . . . . . . . 48 CONTENTS Page 4 UNPACKING THE DTU-710 PACKAGE CONTENTS In your package you will find the following items: DTU-710 Interactive Pen Display, Main Unit Power Adaptor (POW-A090-00) and Power Cable (UL:SCD-A039-01 (A)) Pen (UP-911E-03A) and Pen Stand (PST-A026-08) Installation Guide & User's Manual (This manual.) USB Cable (STJ-A236) 10 DTU-7 Wacom Pen Tablet Driver CD (Contains the driver software.) DVI to VGA Cable (STJ-A207) DVI to DVI Cable (STJ-A206) Notes: Images are not shown to scale. Some package configurations may include additional CDs containing application software. To install these applications, review the instructions that came with those CDs. Retain the package box for use when ...