FXO GATEWAY User Manual (3802/04/06) STEPS IN CONFIGURATION 1. START UP 1.1 Introduction 1.2 Features and specification 1.3 Accessories and equipment 1.4 Appearance 1.4.1 3802 1.4.2 3804 1.4.3 3806 2. HOW TO SETUP AND CONNECT BASICALLY 2.1 System Requirement 2.2 IP Environment Setting 2.2.1 For Windows 2000/NT 2.3 Network configurations in your gateway 2.3.1 Static ip address 2.3.2 DHCP mode 2.3.3 PPPoE mode 2.4 Making a VoIP Call 2.4.1 Configure the gateway into the Peer-to-Peer mode 2.4.2 Configure the gateway into the GK routed mode 2.4.2.1 The type in GK routed mode 3. COMMAND LIST 3.1 Hyper Terminal Setting 3.2 Command List 3.2.1 [help] command 3.2.2 [quit] command 3.2.3 [debug] command 3.2.4 [reboot] command 2 3 3 3 4 5 5 6 7 9 9 10 10 12 14 16 17 18 19 21 22 24 24 27 27 27 28 28 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 3.2.5 [flash] command 3.2.6 [commit] command 3.2.7 [ifaddr] command 3.2.8 [time] command 3.2.9 [ping] command 3.2.10 [greetrd] command 3.2.11 [pbook] command 3.2.12 [pppoe] 3.2.13 [ddns] command 3.2.14 [sysconf] command 3.2.15 [h323] command 3.2.16 [voice] command 3.2.17 [tos] command 3.2.18 [tone] command 3.2.19 [support] command 3.2.20 [group] command 3.2.21 [bureau] command 3.2.22 [prefix] command 3.2.23 [rom] command 3.2.24 [passwd] command 29 29 30 32 32 33 35 38 38 40 44 46 48 49 50 51 53 54 55 57 1 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Steps in configuration STEP 1 Start Up To check out the peripheral equipments and understand the feature of this gateway. Please read this step very carefully before starting the configuring. Connecting the gateway and computer to start configuring by WEB GUI. STEP 2 How to Setup and Connect basically Setting the ip address for this gateway to make sure that it could connect with the internet. Setting the configurations of dialing, including the Peer-To-Peer, GK mode and how to set these tables to make calls by this gateway easily. The other configurations of make call will be discussed in this step. STEP 4 Command List To explain the meaning of the command in the command line interface and example the usage of the command. To get more usages or configuration in this step and study about the command line configuration. 2 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 1. Start Up 1.1 Introduction The WellGate FXO gateway provides voice/fax service over IP network with H.323 v3 protocol. By connecting to your existing ADSL or cable modem service, which allows the use of a single, network for voice and fax services with consequent saving in network infrastructure and greatly reduced telephone charges. Ideal solution for providing low cost communications between headquarters and branch offices in the world, as well as for SOHO and office telephony applications. WellGate FXO GateWay provides analog lines to connect local PSTN/PTT interface (FXO), and converts voice/fax signal onto IP network. The management feature is via RS-232C COM port and TELNET. 1.2 Features and specification Features - ITU-T H.323 v3 compliance - Automatically Gatekeeper Discovery - Peer-to-Peer mode (non-Gatekeeper) - Support auto-attendant (2nddial Tone / Voice greeting) - Dimensions : 221mm(W)*42mm(H)*217mm(L) - Line hunting - 2(3802)/4(3804)/6(3806) RJ-11 FXO ports - E.164 (Telephone Number Plan) - DTMF dialing - DTMF detection/generation - TFTP software upgrade - Remote configuration/reset via Telnet - LED indication for system status - LAN interface : One RJ-45 connector of 10Base-T - Microsoft Netmeeting v3.0 compatible - Support static IP and DHCP - QoS by ToS (Type Of Service) 3 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 - SNTP (Simple Network Time Protocol) Security: Password setting Audio feature Codec -- G.711 a/ law, G.723.1 (6.3K/bps), G.729A (Optional) VAD (Voice Activity Detection), CNG (Comfort Noise Generate) G.168/165-compliant adaptive echo cancellation Dynamic Jitter Buffer Bad Frame Interpolation Call Transfer (H.450.2) Call Forward (H.450.3) Call Hold (H.450.4) Gain Settings Provide Call Progress Tone: Dial tone, busy tone, call-holding tone and ring-back tone Management Features: Two easy ways for system configuration - Console port: RS-232C port - TELNET - HTTP Brower (e.g. Internet Explorer) 1.3 Accessories and equipment The voice gateway in 2/4/6 FXO ports models and only one RJ-45 connector (WAN). The AC adapter. The CD of user manual. The connection cable in RS-232 interface. 4 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 1.4 Appearance 1.4.1 3802 Front panel: The LED light provides system message of WellGate3802. Power : Light on means WellGate3802 is power on. L1-L2 : Light on means the line is in use. Link : Light on means WellGate3802 is connected to the network correctly. Act : LED should be light on and in flash display when data is transmitting. Ready : 1. Light on and in slow flash means WellGate3802 is in operation mode. Status : 1. Light on means WellGate3802 successfully registered to Gatekeeper when it is set as Gatekeeper Mode. 2. LED flash means WellGate3802 is not registered to Gatekeeper when it is set as Gatekeeper Mode. 3. Or when WellGate3802 is in downloading mode, LED should be flash as well. 4. Light off means WellGate3802 is in Peer-to-Peer Mode. Back panel: 5 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 1.4.2 3804 Front panel: The LED light provides system message of WellGate FXO GateWay. Power : Light on means WellGate FXO GateWay is power on. L1-L4 : Light on means the line is in use. Link : Light on means WellGate FXO GateWay is connected to the network correctly. Act : LED should be light on and in flash display when data is transmitting. Ready : 1. Light on and in slow flash means WellGate FXO GateWay is in operation mode. Status : 1. Light on means WellGate FXO GateWay successfully registered to Gatekeeper when it is set as Gatekeeper Mode. 2. LED flash means WellGate FXO GateWay is not registered to Gatekeeper when it is set as Gatekeeper Mode. 3. Or when WellGate FXO GateWay is in downloading mode, LED should be flash as well. 4. Light off means WellGate FXO GateWay is in Peer-to-Peer Mode. Back panel: 6 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 1.4.3 3806 Front panel: The LED light provides system message of WellGate3806. Power : Light on means WellGate3806 is power on. L1-L6 : Light on means the line is in use. Link : Light on means WellGate3806 is connected to the network correctly. Act : LED should be light on and in flash display when data is transmitting. Ready : 1. Light on and in slow flash means WellGate3806 is in operation mode. Status : 1. Light on means WellGate3806 successfully registered to Gatekeeper when it is set as Gatekeeper Mode. 2. LED flash means WellGate3806 is not registered to Gatekeeper when it is set as Gatekeeper Mode. 3. Or when WellGate3806 is in downloading mode, LED should be flash as well. 4. Light off means WellGate3806 is in Peer-to-Peer Mode. Back panel: 7 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 1. Ethernet Port LAN/WAN: 10/100 Base-T; RJ-45 socket, complied with ETHERNET 10/100base-T. The pin-out is as following: PIN 1, 2: Transmit PIN 3, 6: Receive 2. COM: RS232 console port (DB-9pin male connector) Note: use straightforward cable to connect to your computer. PINOUTS Pin Name Dir 2 3 5 RXD TXD GND Description Receive Data Transmit Data System Ground 3. TEL: RJ-11 connector, FXS interface is for connecting the analog phone sets or trunk line of 8 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 PABX. 4. LINE: RJ-11 connector, FXO interface is for connecting the extension line of PABX or PSTN Line. 5. 12V DC: Input AC 100V~120V;output DC12V. 2. How to Setup and connect basically 2.1 System Requirement 1. One PC (a) Pentium 100 or above, 64 RAM, Windows 98 or above. (b) Ethernet card or COM port 2. One standard straightforward RS-232 cable (female connector to Gateway side). 3. PBX extension Lines or PSTN Lines. 4. Software tools (a) Hyper Terminal, TELNET, Web Browser. (b) Gatekeeper (optional). 9 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 2.2 IP Environment Setting User must prepare a valid IP address, complied with IP Network, for Gateway's proper operation. For testing the validation of chosen IP address, using the same IP configuration in other PC or Notebook, and then try to connect to Public Internet (go to well-known website, receive Internet mail, or ping a specific public IP address). If it works, use the same IP address and network configuration for Gateway. Please follow up the step for the configuration of your computer or notebook. 2.2.1 For Windows 2000/NT Please make sure that the network interface of your computer is working fine and the cross over line (RJ-45) is connecting with the computer correctly or you could use a hub to connect with your computer and this gateway. Turn on your computer and configure the network parameter as follow: Go to the start menu and enter the setting area. Click control panel. Enter the network configuration. 10 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Figure 2.1: Network Configuration Select the Property of the LAN card. Setup the ip address, subnet mask and default gateway as below: Figure 2.2: Configure the network Click OK after you finished the network setup. 11 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 The default ip address, netmask and default gateway address of the gateway is 10.1.1.3, 255.255.0.0, 10.1.1.254. 2.3 Network configurations in your gateway Key in the ip address of the gateway (http://10.1.1.3) with the browser 12 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 After key in the ip address, you have to enter the user name and password to enter the WEB configuration. (Username: root ; No password) Figure 2.3: Login the username and password You will enter the main page of the configuration after key in the login name and password correctly: 13 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Figure 2.4: The main WEB configuration Press the Network Interface to configure the networking of your gateway: Figure 2.5: The Network Interface 2.3.1 Static ip address 14 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Please get the correct ip address, netmask and default gateway address from your ISP first. Press the OK button if you finished. Figure 2.5: Configure the static ip address Press the commit if you finish the configuration. Figure 2.6: Commit the data 15 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Press the reboot if you want the configuration executed. Figure 2.7: Reboot the system 2.3.2 DHCP mode Enable the DHCP if you are using the cable modem or DHCP server. 16 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Figure 2.8: Enable the DHCP function Please commit the data and reboot the machine after you enable the DHCP function. 2.3.3 PPPoE mode Press the PPPoE Configuration and put the info of the PPPoE account and password in the configuration table. 17 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Figure 2.9: Configure the PPPoE function Please commit the data and reboot the machine after you finished the configuration of PPPoE. 2.4 Making a VoIP Call There are two modes that you could configure the gateway for making VoIP calls. One is the Peer-to-Peer mode, another is GK routed mode. The configurations and functions are different. Please make sure about the mode you want and follow up the step to configure your gateway. 18 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 2.4.1 Configure the gateway into the Peer-to-Peer mode Enter the H323 Configuration table and change the mode to Peer-to-Peer. Figure 2.10: Configure the Peer-to-Peer mode Press the OK button which is on the buttom of this page to save the configuration. Enter the Phone Book configuration table and configure the name, ip address and phone number of the destination. 19 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 Figure 2.11: Phone Book Example Figure 2.12: The example of Phone Book configuration This is the first record of Phone Book. So the index is 1 The name of the destination: test 20 FXSO H.323 Gateway User Manual Document Ver.: 177A Release OCT., 2003 The E164 number (phone number) of the destination: 123 The ip address of the destination: 10.1.1.100 Press the "Add Data" button when you finished, and the new table will display on the first index if you press the Phone Book configuration button. Figure 2.13: To show the Phone Book record Please Commit it ...