Wenger N.A. 15 Corporate Drive · Orangeburg, NY · 10962 · USA Tel: 800-431-2996, 845-365-3500 Fax: 845-425-4700 (General correspondence) 845-365-3743 (Orders only) Web:www.WengerNA.com Instruction Manual Maker of the Genuine Swiss Army KnifeTM 03/06 Maker of the Genuine Swiss Army KnifeTM Table of Contents Crafted for Life . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Watch Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General Features and Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Operating Instructions (all features not available on all watches) Standard Three-Hand Watches . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Automatic Watches. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Dual Sub-dial Watches . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11, 13 Flip-open Compass Watch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Swing-out Compass Watch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Dual Time Zone Feature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Watch with Alarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Additional Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Caring For Your Watch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Warranty Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 Warranty Service Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 Registration Form. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 1 Crafted For Life Delémont, Switzerland 1893 Over a century ago, Wenger built a factory in this tiny Swiss village and transformed it into production headquarters for the Genuine Swiss Army KnifeTM still used by the Swiss Army today. As it was 100 years ago, each tool, implement and knife manufactured by Wenger is crafted by hand in solid stainless steel and each individually inspected for quality and craftsmanship. This same attention to detail has been applied to genuine Wenger watches. Wenger watches are Swiss-designed, -engineered and -crafted with only the most accurate Swiss movement available. Each watch is constructed with form and function that last a lifetime. As with the genuine Swiss Army knife, Wenger watches are durable, high quality, and versatile enough for use on any occasion. Wenger watches are engineered to provide the same resourcefulness as the genuine Swiss Army knife, supplying functionality beyond the everyday. Wenger Watch Components Movements ­ Swiss quartz movements or 25-Jewel Swiss Automatic movement. Case Body ­ All stainless steel or titanium for quality and durability. Water-Resistant ­ To 50m (165') or 100m (330') for standard watches. To 200m (660') or 1000m (3300') for dive watches. Straps/Bracelets ­ Stainless steel and titanium bracelets feature dive buckles or deployant jewelry buckles. Straps are offered in genuine calfskin leather, specially treated rubberized leather, water-resistant rubber or nylon, or other high-quality materials. Luminous Markers ­ Hands, markers, and numerals may be overlaid with Super Luminova® which recharges in seconds when exposed to direct sunlight for extended nighttime visibility. Crystals ­ The crystal is the clear surface which covers the watch dial. 2 3 General Features and Components Bracelet or strap Hour, minute and second hands Crown protector Optional Features · Rotating bezel measures elapsed time · Tachymeter measures speed over a known distance · Date display window (may offer magnified display window or dual numeral "Big Date" window) · Day of the week display window · Screw-down crown for added water resistance · Dual time zone option to track time in two known time zones · Alarm · Compass (swing-out or flip-open) · Military time features printed 24-hour indicators · Push-button release clasp · Mother-of-Pearl dial · Automatic watches ­ these are wound and powered by the natural motion of your arm and wrist. Military time Crown (used to set date and time) Bezel ring Case 4 5 Position 1 Position 2 Position 3 1. Pull out the crown to Position 2 (one "click" out). Rotate crown counterclockwise until the date shows one day earlier than the date you want to set. 2. Pull out the crown to Position 3 (two "clicks" out). Rotate crown so the watch hands move clockwise until the current date shows. Then set the watch hands to the correct time. Turn the watch hands past 12 once if you're setting the watch for a P.M. time. Push the crown back to Position 1. Setting the Time and Date on Standard Watches (see Table of Contents on p.1 for other watches) Important note: If the crown of your watch does not pull directly out or if your watch is water-resistant to 200m, then you may have a watch with a screwdown crown. Rotate the crown counterclockwise until the crown moves away from the watch. This will set the crown in Position 1. Always screw down the crown after making any adjustments. This is very important as the screw-down crown assures water resistance. 3. For a watch with day and date display, pull out the crown of the watch to Position 2, turn it clockwise to change the day and counterclockwise to change the date. 4. Return the crown to the fully depressed Position 1, assuring the crown has been further screwed down on all 200m watches. For Watches Without a Date Display 1. To set the time for watch without date display, pull out the crown to Position 2. Turn the crown either clockwise or counterclockwise to set the correct time. 2. Return the crown to the fully depressed Position 1, assuring the crown has been screwed down on all 200m watches. 6 7 Position 1 Position 2 Position 3 3. For a watch with day and date display, pull out the crown of the watch to Position 2, turn it clockwise to change the day and counterclockwise to change the date. 4. Return the crown to the fully depressed Position 1, assuring the crown has been further screwed down on all 200m watches. Stopped Automatic Watches Setting the Time and Date on Automatic Watches (see Table of Contents on p.1 for other watches) 1. Pull out the crown to Position 2 (one "click" out). Rotate crown clockwise until the date shows one day earlier than the date you want to set. 2. Pull out the crown to Position 3 (two "clicks" out). Rotate crown so the watch hands move clockwise until the current date shows. Then set the watch hands to the correct time. Turn the watch hands past 12 once if you're setting the watch for a P.M. time. Push the crown back to Position 1. (continued next page) If the watch is not worn it will wind down and stop. We suggest the following procedure to start an automatic watch which has stopped. With the crown in Position 1, wind the crown clockwise for approximately 30 seconds, and the watch will start. 8 9 Day and Date Dual Sub-Dial Watch Bracelet or strap Setting the Time and Date of Dual Sub-dial Watches Set the Time 1. Pull out crown to position 2. 2. Rotate crown clockwise to set the time. 23 13 Crown, crown positions 14 3. Return crown to position 1. Day sub-dial 22 SAT SUN 11 10 MON T 1 3·25·2 Set the Date 1. Pull out crown to position 2. 1 15 7 ·29· 1·3·5 2 2 ·7·9 UE 21 2. Set time to 6:00 by rotating the crown. 3. Use left inset pusher* to set current day. ·11·13 16 8 20 19 Left inset pusher* 10 FRI Bezel ring 7 6 18 7·19·2 ·5·1 1·2 WED U TH 4 17 5 4. Use right inset pusher* to set current date. Date sub-dial 5. Rotate crown counter-clockwise to set current time. Turn the watch hands past 12 once if you're setting the watch for a P.M. time. 6. Return crown to position 1. *please use a blunt object, such as a pen tip, to operate the inset pushers. 11 Right inset pusher* 2nd Time Zone Dual Sub-Dial Watch Bracelet or strap Hour hand 60 Setting the Time and Date of 2nd Time Zone Dual Sub-Dial Watches Setting the Primary Date and Time (Large minute and hour hands) See pages 6-7 for complete instructions. Minute hand 55 05 Setting the 2nd Time Zone 1. Depress the 2nd time zone pusher for at least 2 seconds and release. The minute hand will automatically advance one minute. 9 10 2nd Time zone minute hand 45 50 11 12 9 6 3 1 10 60 45 15 30 Crown 15 2 2. Depress the pusher again and hold it down to advance the minute and hour hands. The longer the pusher is depressed, the faster the time will advance. 3. If you do not depress the pusher for 10 seconds your watch will automatically exit the setting mode. 34 8 20 40 07 30 Date 12 25 35 2nd Time zone hour hand 5 7 Second hand 2nd Time zone pusher 13 Operating Instructions For Flip-Open Compass Watch Note: For watches featuring a swing-out compass watch, see page 16. Your Wenger Swiss G3 Navigator Compass watch has two crown components (illustration below) and four crown positions (right): Component 1 ­ Inner security-screw crown used to lock down or open the case to reveal the compass. Component 2 ­ Outer crown used to adjust time and date. Inner security-screw crown need not be unscrewed to set time and date. Position 1 Position 2 Position 3 Position 4 Position 3 ­ Outer crown extended one "click" out for use in setting the date. Position 4 ­ Outer crown extended two "clicks" out for use in setting the time. Setting the Date and Time 1. Set the crown of the watch to Position 3 (pull outer crown one "click" out). 2. Turn the crown counter-clockwise until the date shows one day earlier than the date you want to set. 3. Pull out the crown to Position 4 (two "clicks" out). Turn the crown counterclockwise so the watch hands move clockwise until the current date shows. (continued on next page) 15 Position 1 ­ Both components fully depressed and screwed down for general use and wear. Position 2 ­ Inner crown unscrewed to flip open the dial and reveal the compass. 14 Then set the watch hands to the correct time. Turn the watch hands past 12 once if you're setting the watch for a P.M. time. 4. Push the outer crown back in to Position 1. 1 2,3 4 5,6 Setting the Time Only Pull out the outer crown to Position 4 (two "clicks" out) and set the time by turning the crown clockwise or counter-clockwise. Note: In order to ensure that your watch remains water-resistant, it is important that you make certain the crown is always returned to Position 1. 3. Lay the open watch on a flat surface, ensuring that the open case is at a 90 degree angle in relation to the compass, so that the compass is flat. 4. Your compass will adjust to accurately reflect orientation within 30 seconds; the arrow may undergo some movement during this period. 5. Once still, the red arrow will be pointing North. Gripping the coin-edge around the exterior of the compass window, simply rotate the compass face until the North indicator (red "N") is directly under the tip of the red arrow. Allow another 10 seconds for the arrow to adjust to the movement. 6. Your compass now accurately reflects your orientation. Operating the Compass One of the most useful and interesting features of your G3 Navigator is the patented flip-open case that reveals a compass. Operating the compass is very simple (see diagrams on page 15): 1. Unscrew inner crown by rotating in a counter-clockwise position until crown resists. 2. Once the inner crown is unscrewed, flip open the case by lifting the crown up. 16 17 Operating Instructions for Swing-Out Compass Watch Setting the Date 1. Pull out the crown to Position 2 (one "click" out). Rotate crown counterclockwise until the date shows one day earlier than the date you want to set. 2. Pull out the crown to Position 3 (two "clicks" out). Rotate crown so the watch hands move clockwise until the current date shows. Then set the watch hands to the correct time. Turn the watch hands past 12 once if you're setting the watch for a P.M. time. 3. Return the crown to the fully depressed Position 1. Position 1 Position 2 Position 3 Operating the Compass 1. Swing-out side of case to reveal compass. 2. Lay the compass on a flat surface for best results. 3. Your compass will adjust to accurately reflect orientation within 30 seconds, the arrow may undergo some movement during this period. Once still, the red arrow will be pointing North. 4. Your compass now accurately reflects your orientation. 1 2, 3, 4 18 19 Dual Time Zone Feature (2nd Time Zone Dual Sub-Dial, see page 12) Note: The second time zone is read in military time (1:00 p.m. = "13", 2:00 p.m. = "14", etc.). The military time hours appear either o ...