User manual X10 AM466

Appliance Modules AM486 (2 pin) and AM466 (3 pin) Setting The Module's Code Using a small screwdriver, set the red House Code dial to the same letter as your Controllers. Set the Black Unit Code dial to any unused number. UNIT CODE DIAL Check Out our Web site at: http://www.x10.com HOUSE CODE DIAL Ratings The Appliance Module can be used to control an incandescent lamp rated up to 500W. It can also control other types of lamps such as fluorescent or energy saving lamps, low voltage lamps, or lamps that include a dimmer control. And of course it can be used to control appliances. Caution: Observe the ratings on the label on the back of the Appliance Module. For more information on X10 products and special promotional offers. X10 Wireless Technology, Inc. Limited One Year Warranty X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be free from defective material and workmanship for a period of one (1) year from the original date of purchase at retail. X10 agrees to repair or replace, at its sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase. If service is required under this warranty: Call 1-800-442-5065, visit www.x10.com, or e-mail support@x10.com. For help or more information on setup, please visit: http://www.x10.com/support AM486/AM466-11/02 1. Set the House Code and Unit Code. 2. Plug an appliance into the Module. 3. Testing The Module Plug the Module into the same wall outlet as your controller (see testing below). Make sure the appliance's switch is on. Plug the Module into the same wall outlet as your controller, press the On and Off buttons on the controller that correspond to the Unit Code setting on the Module. If the Module turns on and off you can unplug the Module or Controller and move it to its permanent location. If you can't control the module, visit http://www.x10.com/support for help.