POWERHORNTM Remote Siren, Model PH508 INSTALLATION AND OPERATING INSTRUCTIONS 1. Set the Housecode dial on the POWERHORN to the same letter as your security system (Model DS7000, or DC8700).* 2. If you want to control the POWERHORN from other types of X10 controllers, set the Unit Code dial on the POWERHORN to any unused number between 1 & 16.* 3. Plug the POWERHORN into an AC outlet (not one that is controlled by a wall switch, in case the switch accidentally gets turned off). 4. To test the POWERHORN, trip your alarm system. The POWERHORN will sound for as long as the alarm in the security system console sounds, and then shut off a few seconds after you disarm the alarm. WARNING: Set the Housecode to the same letter as your X10 Controllers and/ or Security System. A· O· C · · 15 · · 1· 3 5 · M · E · 13 11 · ·9· Set the Unit Code to any unused number (set to 13 if you have a DC8700 Security System). K I· G · 7 PowerhornTM X10 Wireless Technology, Inc. Limited One Year Warranty The POWERHORN is extremely loud. To avoid permanent hearing damage, do not stand too close to it when you trip the alarm. 5. To trip the POWERHORN from any X10 controller (if you hear a strange noise at night, for example): Press Unit Code-ON, then Unit Code-OFF, then Unit Code-ON, repeatedly. The POWERHORN will sound for as long as you keep pressing ON and OFF and will stop a few seconds after you stop pressing buttons. Or press All Lights On, then All Units Off, repeatedly. The POWERHORN will sound for as long as you keep pressing All Lights On, followed by All Units Off and will stop a few seconds after you stop pressing buttons. * Note: If you have a DC8700 security system it might be set to flash lights set to Unit Code 13. If that is the case set the POWERHORN to Unit Code 13. X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10 products to be free from defective material and workmanship for a period of one (1) year from the original date of purchase at retail. X10 agrees to repair or replace, at its sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase. If service is required under this warranty: Call 1-800-442-5065, visit www.x10.com, or e-mail support@x10.com. For help or more information on setup, please visit: http://www.x10.com/support PH508-04/03 ...