SPECIAL MESSAGE SECTION (U.S.A.) This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. This product should be used only with the components supplied or; a cart, rack, or stand that is recommended by Yamaha. If a cart, etc., is used, please observe all safety markings and instructions that accompany the accessory product. SPECIFICATIONS SUBJECT TO CHANGE: The information contained in this manual is believed to be correct at the time of printing. However, Yamaha reserves the right to change or modify any of the specifications without notice or obligation to update existing units. This product, either alone or in combination with an amplifier and headphones or speaker/s, may be capable of producing sound levels that could cause permanent hearing loss. DO NOT operate for long periods of time at a high volume level or at a level that is uncomfortable. If you experience any hearing loss or ringing in the ears, you should consult an audiologist. IMPORTANT: The louder the sound, the shorter the time period before damage occurs. NOTICE: Service charges incurred due to lack of knowledge relating to how a function or effect works (when the unit is operating as designed) are not covered by the manufacturer's warranty, and are therefore the owners responsibility. Please study this manual carefully and consult your dealer before requesting service. ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely believe that our products and the production methods used to produce them, meet these goals. In keeping with both the letter and the spirit of the law, we want you to be aware of the following: Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. This product may also use "household" type batteries. Some of these may be rechargeable. Make sure that the battery being charged is a rechargeable type and that the charger is intended for the battery being charged. When installing batteries, do not mix old batteries with new, or with batteries of a different type. Batteries MUST be installed correctly. Mismatches or incorrect installation may result in overheating and battery case rupture. Warning: Do not attempt to disassemble, or incinerate any battery. Keep all batteries away from children. Dispose of used batteries promptly and as regulated by the laws in your area. Note: Check with any retailer of household type batteries in your area for battery disposal information. Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end, please observe all local, state, and federal regulations that relate to the disposal of products that contain lead, batteries, plastics, etc. If your dealer is unable to assist you, please contact Yamaha directly. NAME PLATE LOCATION: The name plate is located on the bottom of the product. The model number, serial number, power requirements, etc., are located on this plate. You should record the model number, serial number, and the date of purchase in the spaces provided below and retain this manual as a permanent record of your purchase. Model Serial No. Purchase Date CBX-K2 92-BP PLEASE KEEP THIS MANUAL 2 PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep these precautions in a safe place for future reference. WARNING Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions include, but are not limited to, the following: · Do not open the instrument or attempt to disassemble the internal parts or modify them in any way. The instrument contains no user-serviceable parts. If it should appear to be malfunctioning, discontinue use immediately and have it inspected by qualified Yamaha service personnel. · Do not expose the instrument to rain, use it near water or in damp or wet conditions, or place containers on it containing liquids which might spill into any openings. · If the AC adaptor cord or plug becomes frayed or damaged, or if there is a sudden loss of sound during use of the instrument, or if any unusual smells or smoke should appear to be caused by it, immediately turn off the power switch, disconnect the adaptor plug from the outlet, and have the instrument inspected by qualified Yamaha service personnel. · Use the specified adaptor (PA-1D or an equivalent recommended by Yamaha) only. Using the wrong adaptor can result in damage to the instrument or overheating. · Before cleaning the instrument, always remove the electric plug from the outlet. Never insert or remove an electric plug with wet hands. · Check the electric plug periodically and remove any dirt or dust which may have accumulated on it. CAUTION Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the instrument or other property. These precautions include, but are not limited to, the following: · Do not place the AC adaptor cord near heat sources such as heaters or radiators, and do not excessively bend or otherwise damage the cord, place heavy objects on it, or place it in a position where anyone could walk on, trip over, or roll anything over it. · When removing the electric plug from the instrument or an outlet, always hold the plug itself and not the cord. · Do not connect the instrument to an electrical outlet using a multipleconnector. Doing so can result in lower sound quality, or possibly cause overheating in the outlet. · Unplug the AC power adaptor when not using the instrument, or during electrical storms. · Always make sure all batteries are inserted in conformity with the +/polarity markings. Failure to do so might result in overheating, fire, or battery fluid leakage. · Always replace all batteries at the same time. Do not use new batteries together with old ones. Also, do not mix battery types, such as alkaline batteries with manganese batteries, or batteries from different makers, or different types of batteries from the same maker, since this can cause overheating, fire, or battery fluid leakage. · Do not dispose of batteries in fire. · Do not attempt to recharge batteries that are not intended to be charged. · If the instrument is not to be in use for a long time, remove the batteries from it, in order to prevent possible fluid leakage from the battery. · Keep batteries away from children. · Before connecting the instrument to other electronic components, turn off the power for all components. Before turning the power on or off for all components, set all volume levels to minimum. Yamaha cannot be held responsible for damage caused by improper use or modifications to the instrument, or data that is lost or destroyed. · Do not expose the instrument to excessive dust or vibrations, or extreme cold or heat (such as in direct sunlight, near a heater, or in a car during the day) to prevent the possibility of panel disfiguration or damage to the internal components. · Do not use the instrument near other electrical products such as televisions, radios, or speakers, since this might cause interference which can affect proper operation of the other products. · Do not place the instrument in an unstable position where it might accidentally fall over. · Before moving the instrument, remove all connected adaptor and other cables. · When cleaning the instrument, use a soft, dry cloth. Do not use paint thinners, solvents, cleaning fluids, or chemical-impregnated wiping cloths. Also, do not place vinyl, plastic or rubber objects on the instrument, since this might discolor the panel or keyboard. · Do not rest your weight on, or place heavy objects on the instrument, and do not use excessive force on the buttons, switches or connectors. · Do not operate the instrument for a long period of time at a high or uncomfortable volume level, since this can cause permanent hearing loss. If you experience any hearing loss or ringing in the ears, consult a physician. Always turn the power off when the instrument is not in use. Make sure to discard used batteries according to local regulations. * The LED display and diagrams in this owner's manual are for instructional purposes only, and may be different from the ones on your instrument. (4)-2 3 Welcome to the CBX-K2 Congratulations and thank you for purchasing the Yamaha CBX-K2 MIDI Keyboard! The CBX-K2 is a sophisticated, yet compact MIDI keyboard controller, for use with computers and MIDI music systems. It allows you to play connected tone generators and rhythm machines, and enter performance data to sequencers and computers. It features a sophisticated touch-sensitive keyboard that can be adjusted to cover the full 128-note MIDI range. It also provides a wealth of MIDI controls that allow you to send virtually any MIDI message directly from the keyboard. Moreover, the CBX-K2 has three built-in assignable controllers: Assignable Wheel, Assignable Slider and Assignable Footswitch. The Assignable Wheel and Assignable Slider can be set to control virtually any parameter on your connected tone generator or sequencer in real time, while the Assignable Footswitch can be used for sustain, certain sequencer controls, or as an alternate SHIFT button. Because of its portable size, convenient battery/AC adaptor power supply, compatibility with General MIDI (GM) and XG, and extraordinarily powerful and comprehensive MIDI control functions, the CBX-K2 is an invaluable tool -- a MIDI Swiss army knife, of sorts -- for all MIDI musicians and performers. IMPORTANT s The CBX-K2 does not contain an internal tone generator. In order to play sounds from the CBX-K2, you need an external tone generator, such as the Yamaha MU series or TG series tone generators. NOTE s The many MIDI functions and features of the CBX-K2 may not be supported by your particular MIDI device. Be sure to refer to the owner's manual of your particular MIDI device when using it with the CBX-K2. 4 Contents The CBX-K2 -- What It Is and What It Can Do ............... 6 What It Is ................................................................. 6 What It Can Do ........................................................ 6 Assignable Wheel & Slider -- Controller Number List .............................................. 30 About MIDI ...................................................................... 31 How to Use This Manual ................................................. 7 Panel Controls and Terminals......................................... 8 s s Note Range of the CBX-K2 (with Octave Shift ) .... 9 Default Settings of the CBX-K2 ........................... 10 MIDI Messages Transmitted by the CBX-K2 .............. 31 CHANNEL MESSAGES ........................................... 31 SYSTEM MESSAGES ............................................. 33 MIDI Data Format ........................................................... 34 MIDI Reception ....................................................... 34 MIDI Transmission ................................................... 34 MIDI Implementation Chart ...................................... 36 Guided Tour Troubleshooting .............................................................. 37 Error Messages ............................................................... 38 Specifications ................................................................. 39 About RPN and NRPN ....................................................... 39 Power Supply .................................................................. 12 s Using a Power Adaptor ....................................... 12 s Using Batteries .................................................. 12 s When to Replace the Batteries ............................ 12 Setting Up Your CBX-K2 ................................................. 13 What You'll Need ..................................................... 13 Setup Examples ...................................................... 13 s With Computer and Tone Generator .................... 13 s With Sequencer ................................................. 14 s With Tone Generator ........................................... 14 s With Main Keyboard and Tone Generator ............ 15 Making the Connections .......................................... 15 Index ................................................................................ 40 Playing and Using Your CBX-K2 .................................... 16 Selecting and Pla ...