(DECLARATION OF CONFORMITY PROCEDURE) Responsible Party: Address: Telephone: Fax: Type of Equipment: Model Name: Yamaha Electronics Corporation, USA. 6660 Orangethorpe Avenue Buena Park, CA 90620 714-522-9105 714-670-0108 CD Recordable/Rewritable Drive CRW3200IX This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference to radio reception is suspected. FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA. 3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the product "OFF" and "ON", please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Electronics Corporation, USA. 6660 Orangethorpe Avenue, Buena Park, CA 90620 U.S.A. Laser Product Class: Class 1 Laser Diode Properties Wavelength: 780 ­ 787 nm Pulse Durations and Max. Output at the lens of the Laser Pickup Unit Read Mode: 0.85 mW (Continuous) Write Mode: Max. 48 mW (for 212 ns, Min. Cycle 57.9 ns) Laserprodukt-Klasse: Klasse 1 Eigenschaften der Laserdiode Wellenlänge: 780 ­ 787 nm Impulsdauer und max. Ausgang an der Linse der Laser-Abtasteinheit Lesemodus: 0,85 mW (kontinuierlich) Schreibmodus: Max. 48 mW (für 212 ns, Zyklusmin. 57,9 ns) Classe du produit laser: Classe 1 Caractéristiques de la diode laser Longueur d'onde: 780 ­ 787 nm Durée des impulsions et sortie maximum depuis la lentille du bloc capteur optique Mode de lecture: 0,85 mW (continue) Mode de gravure: max. 48 mW (pour 212 ns, cycle min. 57,9 ns) Clase de producto láser: Clase 1 Propiedades del diodo láser Longitud de onda: 780 ­ 787 nm Duración del pulso y potencia de salida máxima en el objetivo de la unidad captora láser Modo de lectura: 0,85 mW (continua) Modo de escritura: máx. 48 mW (para 212 ns, ciclo mínimo 57,9 ns) CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. ACHTUNG Halten Sie sich beim Bedienen und Einstellen der Bedienungselemente sowie bei der Bedienungsabfolge an die Anleitung, da sonst gefährliche Strahlen austreten können. ATTENTION L'emploi de commandes, de réglages ou un choix de procédures différents des spécifications de cette brochure peut entraîner une exposition à d'éventuelles radiations pouvant être dangereuses. PRECAUCION El usar los controles o ajustar o realizar procedimientos diferentes a los especificados aquí resultará en peligrosas exposiciones a la radiación. VARO! AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTINA NÄKYMÄTTÖMÄLLE LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN. VARNING! OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD OCH SPÄRREN ÄR URKOPPLAD. BETRAKTA EJ STRÅLEN. STRÅLEN ÄR FARLIG. - VISIBLE AND / OR INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO BEAM. - SYNLIG OCH / ELLER OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD. STRÅLEN ÄR FARLIG. VARO ! AVATTAESSA OLET ALTTIINA NÄKYVÄLLE JA / TAI NÄKYMÄTÖMÄLLE LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN. VARNING - SYNLIG OCH / ELLER OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD. BETRAKTA EJ STRÅLEN. VORSICHT ! SICHTBARE UND / ODER UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET. NICHT DEM STRAHL AUSSETZEN. ATTENTION - RADIATION VISIBLE ET / OU INVISIBLE LORSQUE L'APPAREIL EST OUVERT. EVITEZ TOUTE EXPOSITION AU FAISCEAU. VARNING CAUTION DANGER - VISIBLE AND / OR INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO BEAM. CLASS 1 LASER PRODUCT LASER KLASSE 1 PRODUKT LUOKAN 1 LASERLAITE KLASS 1 LASER APPARAT PRODUIT LASER DE CLASSE 1 COMPLIES WITH 21 CFR CHAPTER 1, SUBCHAPTER J. OWNER'S MANUAL English i SAFETY PRECAUTIONS PLEASE READ THE FOLLOWING WARNINGS AND CAUTIONS CAREFULLY TO PREVENT PERSONAL INJURY AND DAMAGE TO THE DEVICE. These precautions explain how to use the device properly and safely, thereby preventing injury to yourself and others. This section has been sub-divided into a WARNING section and a CAUTION section, according to the likelihood and nature of any potential injuries or damage inflicted. They relate to your personal safety, and also help you prevent the risk of damage to the device. Please read these sections carefully prior to proceeding. WARNING Always follow these basic precautions to avoid short-circuit, damage, fire, or other hazards, and to avoid serious injury or fatal accident from electrical shock. q Do not attempt to open or disassemble the device to avoid the risk of electrical shock, fire, or malfunction. q Do not look directly at the laser source to avoid the risk of eye damage or blindness. q Do not insert fingers or foreign objects into the device to avoid the risk of electrical shock, fire, malfunction, or personal injury. q Do not expose the device to high humidity or place liquid containers such as a flower vase on the device to avoid the risk of electrical shock, fire, or malfunction. q Do not expose the device to temperature outside the range 5 ­ 35 °C (41 ­ 95 °F) to avoid the risk of fire, deformation of the device panel, or malfunction. q Do not expose the device to dusty place to avoid the risk of fire or malfunction. q Always follow the owner's manual to set up or connect the devices properly to avoid the risk of electrical shock, fire, malfunction, or personal injury. q If unusual smells, sounds or smoke come from the device, or if foreign objects such as liquid get into the device, turn off and unplug the computer immediately to avoid the risk of electrical shock, fire, or malfunction. Contact the store of purchase or your nearest Yamaha dealer (listed at the back of this manual). q Be sure that the computer is electrically grounded to avoid the risk of electrical shock. q Prior to cleaning the drive, always unplug the computer or do not handle the plug with wet hands to avoid the risk of electrical shock. q Use the included AC adapter to avoid the risk of fire or malfunction. ii q Clean the AC power plug regularly to avoid the risk of fire due to insulation failure such as humidity. q Do not unplug the AC adapter by pulling the cable, and do not place objects on the cable to avoid the risk of electrical shock, fire, or malfunction. q Plug in the AC adapter fully to avoid the risk of electrical shock or fire. q Do not connect many devices to an electrical outlet. Maintain the rated power of the outlet to avoid the risk of fire due to overheating. CAUTION Always follow these basic precautions to avoid physical injury to yourself or others, and damage to the device or other property. q Always unplug the computer if it will not be used for a prolonged period or if there is a possibility of lightning, to avoid the risk of electrical shock, fire, or short-circuit. q Do not use the device near other electrical appliances such as televisions, radios, or speakers to avoid the risk of interferences between each other. q Do not place the device unstably to avoid the risk of malfunction or personal injury by its falling down. q Do not place the device with a possibility of excessive vibration to avoid the risk of damage to written data or malfunction. q Place the device horizontally to avoid the risk of damage to written data. q Prior to transporting the device, remove the disc from the disc tray to avoid the risk of damage to written data. q Use soft, dry cloths to wipe the device. Do not use benzene, paint thinner, detergents, or chemically treated wiped cloths, and do not place vinyl, plastic, or rubber objects on the device to avoid the risk of malfunction or damage to the surface of the device. q Do not rest your weight on or place heavy objects on the device, and do not apply excessive force to the buttons, switches, or connectors to avoid the risk of damage to the device or personal injury. q Be careful not to short-circuit the AC power plug with metal objects to avoid the risk of malfunction. q Do not wrap the power cable around the AC adapter to avoid the risk of breaking the wire or malfunction. iii q Do not listen to audio with headphones at high volume for prolonged period to avoid auditory disorder. q Prior to turning on the computer, always minimize the volume to avoid auditory disorder by a sudden burst of sound at high volume. q Do not place the device near magnets or anything magnetized such as a display to avoid the risk of interferences between each other. q Have the device serviced regularly to avoid internal dust buildup that can cause malfunction, damage or fire. For service information and service charges, contact the store of purchase or your nearest Yamaha dealer (listed at the back of this manual). WARRANTY YAMAHA AND ITS SUPPLIERS ACCEPT NO LIABILITY FOR ANY PROBLEMS THAT OCCUR AS A RESULT OF ANY OPERATIONS CARRIED OUT OTHER THAN THOSE STATED IN THE MANUAL THAT COMES WITH THIS PRODUCT, OR THE LOSS OR THE DAMAGE OF ANY DATA CAUSED AS A RESULT OF USING THIS PRODUCT. Precautions for Transportation Transporting the device unfixed may damage its internal mechanism or circuits. · Remove the disc from the disc tray of the device. · Put the device in the original box. Refer to the original box to check that the complete accessories are included prior to installation. · ©2001 YAMAHA CORPORATION. All Rights Reserved. · This document may not, in whole or in part, be copied, photocopied, reproduced, translated, transmitted, or reduced to any electronic medium of machine readable form without prior consent in writing from Yamaha. · Windows is a registered trademark of Microsoft Corporation. · Apple, Macintosh, Mac OS, and FireWire are registered trademarks of Apple Computer, Inc. · i.LINK is a trademark of Sony Corporation. · SafeBurnTM is a trademark of Yamaha Corporation. · All other trademarks are the property of their respective companies. TM and ® marks are not specified in this manual. iv Table of Contents Features of the CRW3200IX Drive ................................................ 1 Names and Functions of Parts ..................................................... 3 Front Panel...............................................................................................3 Rear Panel................................................................................................4 Precautions on Use.................................................................. 5 Handling Discs ........................................................................................5 Copyright .................................................................................................5 Disclaimer of Indemnity..........................................................................5 Compatible Discs.....................................................................................6 System Requirements ..............................................................................7 Preparing the CRW3200IX Drive .................................................10 Serial Number.......................................... ...