INSTRUCTION BOOKLET INSTRUÇÕES DE UTILIZAÇÃO DISHWASHER MÁQUINA DE LAVAR LOIÇA DWS 6706 ATTENTION! The appliance which you have just bought is supplied not only with this instruction manual, but also with a Warranty Card Certificate, on the back of which are written the relative conditions. Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre relative to the area in which the appliance is to be installed, within twenty days of the date of purchase. (See list of Zanussi network centres). We congratulate you on your choice. Carefully read this instruction manual and follow attentively the recommendations it provides, and thus benefit from years of excellent service. The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest Zanussi Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List or by looking in the telephone directory, under Zanussi. Our Zanussi Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. PGA01GB 2 CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Positioning, levelling, adjusting the worktop, installing and securing the machine under a kitchen unit . .page Water supply connections, water outlet connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page The electrical connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4 5 5 6 6 7 7 8 9 Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page The water softener, filling with salt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Use of rinse aid, use of detergent . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Loading the machine, use of the lower basket, use of the upper basket . . . . . . . . . . . . . . . . . . . . . . . . .page 10 Adjusting the height of the upper basket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 11 Helpful hints . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 11 Washing programmes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 12 Operating sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Maintenance and cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 14 Cleaning the central filters, cleaning the large filter, internal and external cleaning . . . . . . . . . . . . . . . . .page 14 Servicing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 15 TECHNICAL SPECIFICATIONS DIMENSIONS Width Height with worktop Height without worktop Max depth Max depth with door open cm 60 cm 85 cm 82 cm 61 cm 120 ELECTRICAL CONNECTION MOTOR RATING DURING WASHING POWER OF HEATING ELEMENT OVERALL POWER WATER SUPPLY PRESSURE Voltage 220 - 230 V/50Hz 200 W 2800 W 3000 W minimum maximum 5 N/cm2 80 N/cm2 12 CAPACITY (STANDARD IEC PLACE SETTINGS) CONSUMPTION: Water Electricity 20 lt 1,5 kW/h This appliance complies with the following E.E.C. Directives: - 73/23 of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. PID32GB 3 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. s s Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. This appliance should be serviced only by an authorised Zanussi Service Center. Before disposing of the appliance, disconnect the water hose, cut the electrical cable and ensure that the door cannot close. For proper disposal of the appliance, contact your local waste collection service. s s s If the appliance is supplied with obvious damage, consult the supplier before installing it. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance is designed to be operated by adults. Care must be taken to ensure that the appliance does not stand on the electrical supply cable or on the water inlet and drain hoses. Zanussi dishwashers are designed to be used for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in a dishwasher. Under no circumstances should you open the door whilst, the appliance is in operation. Always turn off the appliance before opening the door. However, the dishwasher features a special safety device which cuts off the water inlet, should the door be accidentally opened, thus avoiding water leaks. Never touch the heating element during or immediately after the end of the washing cycle. When finishing loading or unloading close the door, as an open door can be a hazard. It is dangerous to lean or to sit on the dishwasher door: the appliance could tip over. Built-in dishwashers only: the appliance must be secured to the underside of the worktop using the brackets provided. Failure to do this could result in an unstable appliance which may cause damage or injury. Unplug the appliance and turn off the water after use. s s s s s s s s s s s PAV01GB 4 INSTALLATION Remove all packaging before positioning the machine. Installing and Securing the Machine Under a Kitchen Unit (Sink-Worktop Unit) By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, if the dimensions of the recess correspond to those shown in the picture. Then proceed as follows: Remove the machine worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting the height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. 570÷ Positioning If possible, position the machine next to a water tap and a drain. The sides and the back of the dishwasher can rest against the adjacent furniture or the wall. The dishwasher features fill and drain hoses which can be turned either to the left or the right to suit the installation. Levelling Good levelling is essential for correct closure and sealing of the door. If the door does not close correctly, loosen or tighten the adjustable support feet, until the machine is perfectly level. 600 600 IN05 Caution IN01 Once the machine has been installed, ensure that it can be accessed easily for servicing. Adjusting the Worktop You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two front retaining screws, move the top to the required position and then retighten the screws. IN03 PIN01GB 5 820 Water Outlet Connection The end of the drain hose can be connected as follows: to the sink outlet siphon, securing it if necessary with a clip; to a wall outlet provided with vent-hole, minimum internal diameter 4 cm; hooked over the edge of the sink using the special curved plastic guide provided. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the floor. It makes no difference which way the drain hose faces, either to the right or left of the dishwasher. Avoid bending or kinking the hose as this could prevent or slow down the discharge of water. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connection to the waste outlet must be no smaller than the diameter of the drain hose. min 4 cm The problem is signalled by a red or yellow indicator which appears in window (B). If this happens, close the water tap and have the hose replaced. Warning: the retaining ring (A) must be properly fitted so as to avoid water leaks. A 2 B B A C 1 CA13 Note: Only for water supply hoses with lock-fast safety device to prevent inadvertent loosening. To detach the hose press yellow lever (C) and turn the retaining ring anti-clockwise . Note: the end of thehose connected to the machine can be positioned as required, by simply slackening the retaining ring. Re-tighten the ring securely to avoid water leaks. CA06 21 Ø Ø 18 Ø 21 Ø 18 max 100 cm min 30 cm max 100 cm + 2 m max CS01 Avoid bends or kinks in the hose, which could prevent or slow down the flow of water. If the machine is connected to new pipes or pipes which have not been used for a long time, you are advised to run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. Water Supply Connections This dishwasher may be fed with either hot (max. 60°C) or cold water. Nevertheless we advise you a cold water supply. A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes a lot. Feeding the appliance with a hot water supply (max. 60°C) will allow you to obtain considerably shorter programmes. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4 inch gas thread spout, or to a purpose-made quick-coupling tap such as the PressBlock. The water pressure must be within the limits given in the technical specifications, as it will not function correctly if pressure is outside these specifications. The water supply hose is fitted with a safety device, which prevents water from entering the machine should the inner hose split, due to wear. PIN19GB Electrical connection Before plugging the appliance into the wall socket, make sure that: 1. the mains voltage corresponds to the voltage given in the technical specifications; 2. the meter, fuses, mains power supply and wall socket can all take the maximum load required. Make sure that the socket and plug are compatible without having to use any type of adapter. If necessary, have the domestic wiring system socket replaced. Safety standards require the appliance to be earthed. The Manufacturer accepts no liability for failure to observe the above safety precautions. 6 USE Control panel A C 1 23 1. Pilot Light 4 5 67 6. Programme Marker 7. Programme Selector Dial 8 This comes on when the ON/OFF button is depressed, indicating that the machine is on. 2. ON/OFF Pushbutton ON By depressing this pushbutton the machine starts operating and, at the same time, the pilot light comes on. OFF When the washing programme has finished, the machine stops automatically and the pilot light (1) remains on. To switch the pilot light off or to stop the machine at any time, press the same button again. To select a programme, turn the Programme Selector Dial clockwise, making sure that the programme letter you wish to select corresponds with the programme marker (6) on the control panel. 8. Wash Programme Phase Indicator During the washing programme the Programme Selector Dial turns, indicating the functions being perfor ...