REFRIGERATORFREEZER ZA 98/3 W © Electrolux plc 2002 INSTRUCTION BOOKLET 2222 183-71 IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety. You MUST read it carefully before installing or using the appliance. Door reversal directions 1. Disconnect from the electricity supply. 2. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing; 3. Remove the ventilation grill (D). 4. remove the bottom hinge (E) by unscrewing its three fixing screws; 5. Remove the freezer door by releasing it from the middle hinge (H). 6. Unscrew the middle hinge. 7. Remove the fridge door by releasing it from the top hinge pin (G). 8. Remove the pin then mount these on the side, after having removed the small plugs which should then be fitted on the opposite side. 9. using a 10 mm spanner, unscrew the hinge pin (E) and reassemble it on the opposite side of the hinge; 10.Refit the fridge door and replace the middle hinge to the left hand side. 11. reassemble the lower hinge (E) on the opposite side, using the screws previously removed. Slide the hole cover (F) out of the ventilation grille (D) by pushing it in the direction of the arrow and reassemble it on the opposite side; 12.reassemble the door; 13.refit the ventilation grille (D), clipping it into place; The doors can be aligned by adjusting the middle hinge. The middle hinge can be adjusted horizontally, after having slackened the two screws with a screwdriver. G H E E F F F D F PR18 Installation · · · This appliance is heavy. Care should be taken when moving it. It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Parts which heat up should not be exposed. Whenever possible, the back of the appliance should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigerant to settle. · · · Frozen food must NOT be re-frozen once it has thawed out. Do not place carbonated or fizzy drinks in the freezer. Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns. Ice lollies can cause `frost/freezer burns' if consumed straight from the freezer. Manufacturers' storage recommendations should be strictly adhered to. Refer to relevant instructions. The cooling plate or refrigerated freezer shelves in this appliance contain channels through which the refrigerant passes. If these are punctured this will cause substantial damage to the appliance and result in food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Under NO circumstances should solid ice be forced off the lining or shelves. Solid ice should be allowed to thaw, when defrosting the appliance. See Defrost Instructions. · · · · · · Child Safety · · Do not allow children to tamper with the controls or play with the product. Keep all packaging well away from children. · Maintenance and Cleaning Switch off and unplug the appliance before carrying out any cleaning or maintenance work. General Safety · This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to cookers, radiators or boilers. Avoid prolonged exposure of the appliance to direct sunlight. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. Servicing · This product should be serviced by an authorised engineer and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Refer to your local Service Force Centre and always insist on genuine spare parts. Important After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. · · D419 · · · At the end of the Appliance Life · · When disposing of your appliance, use an authorised disposal site. Remove the plug and ensure that any locks or catches are removed, to prevent young children being trapped inside. During Use · This appliance is designed for domestic use only, specifically for the storage of edible foodstuffs. Printed on recycled paper 2 19 Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home. Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Blue Brown - Earth - Neutral - Live The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre. This appliance complies with the E.E.C. Directive No. 87/308 of 2.6.87 relative to radio interference suppression. This appliance complies with the following E.E.C. Directives: 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. CONTENTS Instructions for the User Important Safety Information Description of the Appliance Operation Before using Control panel Start your appliance Temperature control Freezing fresh food Frozen food storage Thawing Making ice cubes Cold accumulators Fresh food refrigeration Movable shelves Positioning the door shelves Drawer Cool Check Guide Freezing calendar 2 4 5 5 5 5 5 6 6 7 7 7 6 8 8 8 9 9 10 11 11 11 11 11 12 13 14 14 15 Instructions for the Installer Technical Specification Installation Positioning Rear Spacers 16 17 17 17 18 19 Electrical Connection Door Reversal Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug, proceed as follows: GREEN & YELLOW 13 AMP. FUSE Hints and Tips Maintenance and Cleaning Internal cleaning External cleaning When the appliance is not in use 13 AMP BROWN BLUE D207 Changing the light bulb Defrosting CORD CLAMP Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol yellow. or coloured green and Something Not Working Service and Spare Parts Customer Care Guarantee Conditions Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black. Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red. 18 2222 183-71 3 DESCRIPTION OF THE APPLIANCE INSTALLATION Important IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on "Door reversal". Important It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. L K J I H G A B C D E F Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: SN N ST T +10°C to + 32°C +16°C to + 32°C +18°C to + 38°C +18°C to + 43°C A 10 mm 100 mm B 10 mm It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly. You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4") distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B). NP002 A- Control panel B- Interior light C- Dairy compartment D- Movable shelf E- Can storage shelf F- Bottle storage shelf G- Compartments for frozen food storage H- Compartment for freezing fresh food and frozen food storage I - Drawer J - Glass shelf K- Cool Check Temperature Guide L - Storage shelves There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation. Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers. D200 Rear spacers In the bag with the documentation, there are two spacers which must be fitted as shown in the figure. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. D594 4 17 TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth 185 60 62,5 cm cm cm OPERATION Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Control panel POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY * GROSS CAPACITY Fridge Freezer 220-240 V / 50 Hz 180 W 0.64 kWh A BC D 222 l 86 l ABCDFridge Freezer 221 l 82 l EAlarm light - Red Fast freeze light - Amber Fast freeze switch Freezer Pilot light - Green Freezer Thermostat control knob E FG- F G Fridge Pilot light - Green Fridge Thermostat control knob NET CAPACITY Control Panel STAR RATING A. Alarm light If the alarm light (A) illuminates, it indicates that the temperature within the freezer has reached a level where safe food storage is no longer ensured. When the freezer is first switched on, the alarm light will stay on until the temperature has dropped to a safe level for the storage of frozen food. Start your appliance Allow the appliance to stand for 2 hours after installation. Insert the plug into the wall socket. The pilot light (D) will illuminate to show that the appliance is on. Turn the thermostat control (G) to a midway setting. The pilot light (F) will illuminate. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside. To switch off the appliance turn the thermostat control to position "O" . * This figure is based on standard test results in accordance with European Standard EN 153. Actual consumption will depend on how the appliance is used and where it is located. B. Fast freeze light The fast freeze ...