ELECTRIC OVENS FOURS ÉLECTRIQUES ZBM 770 ZBM 775 INSTRUCTION BOOKLET NOTICE D'UTILISATION 1 ENGLISH Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. This appliance has been designed to be operated by adults and children under supervision. Young children MUST NOT be allowed to tamper with the controls or play near or with the oven. This appliance has been designed for cooking edible foodstuff only and MUST NOT be used for any other purposes. It is dangerous to alter the specification in any way. For hygiene and safety reasons, this appliance should be kept clean at all times. A build-up of fats or other foodstuff could result in a fire. Accessible parts of this appliance may become hot when it is in use. Children should be KEPT AWAY until it has cooled. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Zanussi Service Centre. Always insist on genuine Zanussi spare parts. Ensure that all control knobs are in the OFF position when not in use. Should you connect any electrical tool to a plug near this cooking appliance, ensure that electric cables are not in contact with it and keep them far enough from the heated parts of this appliance. If the appliance is out of order, disconnect it from the electric supply. Do not leave untensils containing foodstuffs, e. g. fat or oil in or on the appliance. This could cause damage in case the appliance is inadvertently switched on. Always place the dripping pan in position to collect fat when using the grill or when cooking meat. Pour a little water into the dripping pan to avoid smoke and unpleasant smells. Always use oven gloves to remove pans from the oven. It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Some parts of the appliance are covered by a shockproof plastic film. Remove this film before using the oven. Once you removed all packaging from the appliance, ensure that it is not damaged and the electric cable is in perfect conditions. Otherwise, contact your dealer before proceeding with the installation. This appliance is meant to operate with a singlephased connection to 230V electrical supply. An eventual 400V poliphasic connection without earth wire will destroy the oven and the hob, if fitted. The manufacturer disclaims any responsability should all the safety measures not be carried out. Environmental Information After installation, please dispose of the packaging with due regard to safety and the environment. When disposing of an old appliance, make it unusable, by cutting off the cable. Guide to use the instructions The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions F Step by step instructions for an operation Hints and Tips Environmental Information OVEN DOOR PROTECTION DEVICE All our appliances comply with the European Safety Standards. Nevertheless, in order to ensure the highest safety level, and avoid little children to be exposed to the heat when the appliance is operated, it is possible to fit a special protection device to the oven door. This device can be purchased in our Service Force Centres, specifying the relevant code ( 3 5 7 9 1 ) and the Product No. shown on the rating plate. Fitting instructions are provided with the kit package. MANUFACTURER: ELECTROLUX ZANUSSI S.p.A. Viale Bologna, 298 47100 FORLÌ (Italy) 2 For the user Using the oven Contents Important Safety Information Description of the Oven Electronic programmer When the oven is first installed Cooking with the multifunction oven Cooking Tables Cleaning and maintenance What happens if something goes wrong Technical Assistance and Spare Parts 2 3 4 5 7 7 8 10 12 12 For the Installer Technical data Installation 13 14 This appliance complies with the following E.E.C. Directives: * 73/23 - 90/683 (Low VoltageDirective); * 93/68 (General Directives); * 89/336 (Electromagnetical Compatibility Directive) and subsequent modifications. Description of the oven 7 8 9 10 11 6 12 5 4 3 2 1 18 Oven accessories 14 13 15 1 - 4. Shelf levels 5. Oven Light 6. Control panel 7. Electronic Programmer 8. Mains on Light 9. Thermostat Control Light 10.Oven Control Function Knob 11.Thermostat Control Knob 12.Grill 13.Oven Fan 14.Baking tray 15.Oven shelf 16.Dripping pan 17.Grease Filter 18.Rating Plate 16 17 3 Using the Oven Oven function control knob (Fig. 1) 0 de ton Oven switched off Oven Light - The oven light will be on without any cooking function Conventional cooking - The heat comes from both the top and bottom element, ensuring even heating inside the oven. Top heating element - The heat comes from the top of the oven only. ) ) Bottom heating element - The heat comes from the bottom of the oven only. Fan cooking - This allows you to roast or roast and bake simoultaneously using any shelf, without flavour transference. Inner grill element only - can be used for grilling small quantities. Double Grill - The full grill element will be on. Thermal Grilling - This function offers an alternative method of cooking food items, normally associated with conventional grilling. The grill element and the oven fan operate together, circulating hot air around the food. Defrost Setting - This setting is intended to assist in thawing of frozen food. Fig. 2 FO0769 0 Fig. 1 FO2756 50 MAX 100 our Thermostat control knob (Fig. 2) Turn the thermostat control knob clockwise to select temperatures between 50°C and 250°C (MAX). Oven control light This yellow light will come on when the oven function control knob is set on a function. Thermostat control light (°C) Once the oven temperature has been selected, the Themostat Control Light will come on and remain on until the oven has reached the correct setting; after that, it will go on and off with the thermostat, showing how the temperature is being maintained. The Cooling Fan for the Controls This oven is provided with a cooling fan, meant to keep the front panel, the knobs and the oven door handle cool. This fan may run on after the oven or grill is switched off, until a normal temperature is reached. All cookings must be carried out with the oven door closed 4 0 20 150 Electronic programmer 4 1. Push button for selecting a function 5 6 7 8 2. Decreasing control button 3. Increasing control button 4. Display 5. Cooking Duration pilot lamp 6. End of cooking pilot lamp 2 1 3 FO 2571 7. Minute minder pilot lamp 8. Time of day pilot lamp The oven will work only if the time of day has been set. However, the oven can also be operated without any programme. Setting the time of day When the power supply is switched on, or after a power failure, the Time of day pilot lamp will flash on the display. To set the correct time of day: 1. Press button or . 2. After the setting is carried out, wait for 5 seconds: the Time of day pilot lamp will go out and the display will show the set time. The appliance is ready for use. To reset the correct time of day: 1. Press button repeatedly to select the Time of day function. The relevant pilot lamp will start flashing. Then proceed as described above. The time of day can only be reset if no automatic function (cook duration or end of cooking ) has been set. Cooking Duration function This function allows the oven to automatically switch off at the end of a programmed cooking duration time. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button repeatedly to select the Cooking Duration function. The relevant pilot lamp will start flashing. Then, proceed as follows: To set the duration time: 1. Press button or . 2. After the setting is carried out, wait for 5 seconds: the "Cooking Duration" pilot lamp will come on and the display will revert to the time of day. 3. When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero. To switch off the acoustic alarm, press any button. NOTE: turning the acoustic alarm off will reset the oven to manual, and if the oven function and the thermostat knobs are not set to zero the oven will start to heat again. To cancel the duration time: 1. Press button repeatedly to select the Cooking Duration function. The relevant pilot lamp will flash and the display will show the remaining cooking time. 2. Press button until the display shows 0:00. After 5 seconds the pilot lamp will go out and the display will revert to the time of day. 5 With this function, you can set the oven to switch off automatically when a programmed end of cooking time is over. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button repeatedly to select the End of cooking function. The relevant pilot lamp will start flashing. Then, proceed as follows: To set the End of cooking time: 1. Press button or . 2. After the setting is carried out, wait for 5 seconds: the End of cooking pilot lamp will come on and the display will revert to the time of day. 3. When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero. To switch off the acoustic alarm, press any button. NOTE: turning the acoustic alarm off will reset the oven to manual, and if the oven function and the thermostat knobs are not set to zero the oven will start to heat again. To cancel the End of cooking time: 1. Press button repeatedly to select the End of cooking function. The relevant pilot lamp will flash and the display will show the programmed End of cooking time. 2. Press button until the display shows the current time of day. The programmer will beep and the pilot lamp will go out. End of cooking function Cooking duration time combined and End of cooking The functions Cooking duration and End of cooking time can be used simultaneously to set the oven to switch on and off automatically at a later time. 1. With the Cooking duration function (carry out the cooking duration setting as described in the relevant chapter) set the duration time. Then, press button : the display will show the programmed setting. 2. With the End of cooking time function (carry out the End of cooking setting as described in the relevant chapter) set the end of cooking time. The relevant pilot lamps will come on and the display will show the time of day. The oven will switch on and off according to the set programmes. Minute minder function The minute minder alarm will sound at the end of a timed period, but THE OVEN WILL REMAIN ON, if it is in use. To set the minute minder: 1. Press button repeatedly to select the Minute minder function. The relevant pilot lamp will start flashing. 2. Then, press button or (maximum: 2 hours, 30 minutes). 3. After the setting is carried out, wait for 5 seconds: the Minute minder pilot lamp will come on. 4. At the end of the timed period, the pilot lamp will start flashing and an acoustic alarm will be heard. To switch off the acoustic alarm, press any button. To cancel the minute minder: 1. Press button repeatedly to select the Minute minder function. The relevant pilot lamp will flash and the display will show the remaining time. 2. Press button until the display shows 0:00. After 5 seconds the pilot lamp will go out and the display will revert to the time of day. How to switch off the display 1. Press two or three programmer push buttons simoultaneously and keep them pressed for about 5 seconds. The display will switch off. 2. To switch on the display, press any button. The display can be switched off only if no other functions have been set. 6 When the oven is first installed Once the oven has been installed: a) set the thermostat knob to MAX; b) switch the oven function control knob to conventional cooking ( ); c) allow the oven to run empty for approximately 30 minutes; d) open a window for ventilation. During this time, an unpleasant odour may be emitted. This is absolutely normal, and is caused by residues of manufacturing. Once this operation is carried out, let the oven cool down, th ...