MIXED FUEL COOKER ZCM 620 X INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance Important Safety Information You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 727727 Installation q This cooker must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant British Standards. q When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooker. Unstable or misshapen pans should not be used on the hob burners as unstable pans can cause an accident by tipping or spillage. Never leave the cooker unattended when cooking with oil and fats. This cooker should be kept clean at all times. A build-up of fats or foodstuffs could result in a fire. Never use plastic dishes in the oven or on the hob burners. Never line any part of the oven with aluminium foil. Always ensure that the oven vent which is located at the centre back of the hob is left unobstructed to ensure ventilation of the oven cavity. Perishable food, plastic items and areosols may be affected by heat and should not be stored above the cooker. · This cooker is heavy. Take care when moving it. q q Any gas installation must be carried out by a registered CORGI installer. Remove all packaging before using the cooker. Ensure that the gas and electrical supply complies with the type stated on the rating plate, located near the gas supply pipe. Do not attempt to modify the cooker in any way. q q q q q q Child Safety q This cooker is designed to be operated by adults. Do not allow children to play near or with the cooker. The cooker gets hot when it is in use. Children should be kept away until it has cooled. Children can also injure themselves by pulling pans or pots off the cooker. q q q q During Use q Service q This cooker is intended for domestic cooking only. It is not designed for commercial or industrial purposes. When in use a gas cooker will produce heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose. When using the cooker for a long period time, the ventilation should be improved, by opening a window or increasing the extractor speed. Do not use this cooker if it is in contact with water. Do not operate the cooker with wet hands. Ensure the control knobs are in the `OFF' position when not in use. This cooker should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used. q Environmental Information q After installation, please dispose of the packaging with due regard to safety and the environment. When disposing of an old appliance, make it unusable, by cutting off the cable. q q q q Keep this instruction book for future reference and ensure it is passed on to any new owner. 2 Contents For the User Important Safety Information .............. 2 Description of the Cooker .................... 4 Control Panel ...................................... 5 The Oven Cavity ..................................... 5 Accessories ............................................ 5 For the Installer Instructions for the Installer ............. 24 Important Safety Requirements ......... 25 Installation ........................................ 26 Electrical connections ....................... 28 Commissioning .................................. 29 Conversion from Natural Gas to LPG .. 30 Operation ............................................ 6 Controls .............................................. 6 Hob burners ........................................... 6 Electric Oven ......................................... 7 24 hour Clock and Timer ..................... 7 Before the First Use of the Cooker ..... 10 Using the Oven .................................. 10 Using the Conventional Oven ............ 12 Cooking Chart ...................................... 13 Using the Fan Oven ........................... 14 Cooking Chart ...................................... 15 Roasting Chart ..................................... 15 Defrosting ......................................... 17 Grilling .............................................. 18 Maintenance and Cleaning ................. 19 Cleaning the Oven ............................. 20 Something Not Working ..................... 22 Service and Spare Parts ..................... 23 Peace of Mind for 12 Months ............. 23 Oven Door Protection Device (Model ZCM 620 X) All our appliances comply with the European safety standards. Nevertheless, in order to ensure the highest safety level, and avoid small children to be exposed to the heat when the appliance is operated, it is possible to fit a special protection device to the oven door. This device can be purchased in our Service Force Centres, specifying the relevant code (35791) and the Product No. shown on the rating plate. Guide to Use the instructions The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions i Step by step instructions for an operation Hints and Tips This appliance is manufactured according to the following EEC directives: 73/23 EEC - 90/683 EEC - 93/68 EEC 89/336 EEC - 90/396 EEC, current edition. 3 Description of the Cooker Splash back Semi-Rapid burner Rapid burner Control panel A U T O TIMER Semi-rapid burner Auxiliary burner ZCG 6000 Shelf Oven door Storage drawer Fitting the Splash back A stainless steel splash back is supplied with the appliance. This is meant to be fitted on the rear edge of the cooker's hob. The splash back package is in the oven cavity. 1. Unpack the splash back and dispose of the packaging with due regard to safety and the environment. 2. Slide the two bayonets of the splash back into the relevant supports on the rear adge of the cooker's hob. 4 Control Panel 1 2 MAINS ON BACK LEFT FRONT LEFT FRONT RIGHT BACK RIGHT OVEN FUNCTION TEMPERATURE OVEN PROGRAMMER THERMOSTAT A U T O TIMER IGNITION 3 4 5 6 7 8 9 10 1. Cooker Operation Pilot Light 2. Oven Thermostat Pilot Light 3. Electric ignition push button 4. Back left burner control knob (semi-rapid) 5. Front left burner control knob (rapid) 6. Front right burner control knob (auxiliary) 7. Back right burner control knob (semi-rapid) 8. Oven function control knob 9. Oven thermostat control knob 10. 24 hour clock and Programmer The Oven Cavity Grill element Oven Light Accessories Grill/roasting pan Grill trivet Removable handles Oven fan 5 Operation INSTALLATION Any gas installation must be carried out by a registered CORGI installer, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown. WHEN THE COOKER IS FIRST INSTALLED Once the cooker has been installed, it is important to remove any protective materials, which were put on in the factory. Controls Hob burners To light a burner, turn the relevant control knob anticlockwise to maximum position. At the same time push the electric ignition button which is marked with a little spark.. Then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the pan, causing the handle to overheat. i When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically. i As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table). Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. If the control knobs become difficult to turn, please contact your local Zanussi Service Centre. Burner minimum diameter 160 mm. 120 mm. 80 mm. maximum diameter 240 mm. 220 mm. 160 mm. Large (rapid) Medium (semi-rapid) Small (Auxiliary) 6 Electric Oven Oven Function Control Knob Oven Light - The oven light will be on without any cooking function Conventional cooking - The heat comes from both the top and bottom element, ensuring even heating inside the oven. Fan cooking - This allows you to roast or roast and bake simoultaneously using any shelf, without flavour transference. Grill - The heat comes only from the top element. OFF 0 OFF Thermostat Control Knob Turn the thermostat control knob clockwise to select temperatures between 50°C and 250°C (MAX). 100 50 24 hour Clock and Timer Minute minder Cooking duration End of cooking time Manual function Cookpot symbol - This will be displayed when a program is in operation. A U T O Cookpot symbol Auto symbol A U T O TIMER Auto symbol - This will be displayed when the oven has been programmed for automatic operation. Time setting knob - Turn it clockwise and hold it in the turned position to increase the time setting. Turn it anticlockwise and hold it in the turned position to decrease the time setting. The count-up or count-down speed increases the longer the knob is held in the turned position. Programming controls 20 Time setting 0 150 7 The electronic timer can indicate the time of day, operate as a minute minder and automatically operate the oven. Before the oven can be operated, the time of day must be set on the electronic timer. Please note that this is a 24 hour clock. For example, 2pm is shown as 14:00. In case of loss of power, all the settings (time of day, set program or program in operation), will be cancelled. When the power is restored, the numbers on the display will flash, and the timer has to be reset. TO SET THE TIME OF DAY TIMER Press button , and at the same time turn the time setting knob until the correct time of day is displayed. TO SET THE MINUTE MINDER Press button and at the same time turn the setting time knob until the duration time is displayed (maximum 23 hours, 59 minutes). Our diagram shows the timer set for 45 minutes. After a few seconds the time of day will show in the display. To check the number of minutes remaining, press the button. At the end of the timed period an alarm will sound. To switch off the alarm press button . TIMER MANUAL FUNCTION to set the oven for manual function. TIMER Press button 8 TO SET THE TIMER TO SWITCH OFF ONLY This is useful if you want to begin cooking immediately but have the oven switch off automatically. 1. Set the oven function control knob and the thermostat control knob on the required settings. 2. Place food in the oven. and, at the same time, turn the 3. Press button time setting knob until the required cooking duration is displayed. Our diagram shows the timer set for 30 minutes. At the end of the cooking time the oven will switch off, an alarm will sound. To switch off the alarm press button . Ensure the oven function control knob and the thermostat control knob are in the OFF position. TIMER TO SET THE TIMER TO SWITCH THE OVEN ON AND OFF 1. Ensure the clock is showing the right time of day. 2. Carry out steps 1, 2 and 3 as explained in "To set the timer to switch off only". and at the same time turn the 3. Press button time setting knob until the end cooking time is displayed. Our diagram shows the end cooking time set for 7.00 pm. 4. The oven will switch on and off automatically. The end of cooking will be marked by an acoustic alarm. To switch off the alarm press button . Ensure the oven function control knob and the thermostat control knob are in the OFF position. TIMER TO CANCEL A PROGRAMME Press button . Any set program or program in operation will be cancelled and the timer will revert to manual function. Ensure the oven function control knob and the thermostat control knob are in the OFF position. 9 Before the First Use of the Cooker Remove all packaging, both inside and outside the cooker, before using it. Before first use, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal. 1. Set the electronic programmer to manual function. 2. Switch the oven function control knob to coventional cooking . 3. Set the thermostat control knob to MAX. 4. Open a window for ventilation. 5. Allow the oven to run empty for approximately 45 minutes. 6. Half way through, reset the oven function control to fan cooking . This procedure should be repeated with the grill function for approximately 5-10 minutes. Using the Oven · Always cook with the oven door closed. · Stand clear when opening the drop down oven door. ...