User manual Dishwasher ZDT 430 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing programmes _ _ _ _ _ _ _ _ _ _ _ 8 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Set the water softener _ _ _ _ _ _ _ _ _ _ 10 Filling with dishwasher salt _ _ _ _ _ _ _ 12 Filling with rinse aid _ _ _ _ _ _ _ _ _ _ _ 13 Adjusting the dosage of rinse aid _ _ _ _ 13 Load cutlery and dishes _ _ _ _ _ _ _ _ _ 14 Use of detergent _ _ _ _ _ _ _ _ _ _ _ _ _ 17 Unloading the dishwasher _ _ _ _ _ _ _ _ 18 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ 18 Environmental concerns _ _ _ _ _ _ _ _ _ 20 What to do if... _ _ _ _ _ _ _ _ _ _ _ _ _ _ 20 Consumption values _ _ _ _ _ _ _ _ _ _ _ 22 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ 23 Hints for test institutes _ _ _ _ _ _ _ _ _ _ 23 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 24 Subject to change without notice 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. ried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. Always insist on genuine spare parts. General safety · Dishwasher detergents can cause chemical burns to eyes, mouth and throat. Could endanger life! Comply with the safety instructions of the dishwasher detergent manufacturer. · The water in your dishwasher is not for drinking. Detergent residues may still be present in your machine. · Ensure that the door of the dishwasher is always closed when it is not being loaded or unloaded. In this way you will avoid anybody tripping over the open door and hurting themselves. · Do not sit or stand on the open door. Correct use · This dishwasher is only intended for washing household utensils suitable for machine washing. · Do not put any solvents in the dishwasher. This could cause an explosion. · Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. · Only use products (detergent, salt and rinse aid) suitable for dishwashers. · Avoid opening the door whilst the appliance is in operation, hot steam may escape. · Do not take any dishes out of the dishwasher before the end of the dishwashing cycle. · After use, isolate the appliance from the power supply and turn off the water supply. · This product should be serviced only by an authorised service engineer, and only genuine spare parts should be used. · Under no circumstances should you attempt to repair the machine yourself. Repairs car- Child safety · This appliance is designed to be operated by adults. Don't allow children to use the dishwasher unsupervised. · Keep all packaging well away from children. There is risk of suffocation. · Keep all detergents in a safe place out of children's reach. · Keep children well away from the dishwasher when the door is open. 3 Installation · Check your dishwasher for any transport damage. Never connect a damaged machine. If your dishwasher is damaged contact your supplier. · All packaging must be removed before use. · Any electrical and plumbing work required to install this appliance must be carried out by a qualified and competent person. · For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. · Never use the dishwasher if the electrical supply cable and water hoses are damaged; or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible. Contact your local Service Force centre, in order to avoid hazard. · All sides of the dishwasher must never be drilled to prevent damage to hydraulic and electric components. WARNING! For electrical and water connection carefully follow the instructions given in specific paragraphs. Control panel 1 2 3 45 6 A B C 7 1. 2. 3. 4. 5. 6. 7. On/Off button Digital display Up and down programme selection buttons Half load button Delay start button Indicator lights Function buttons 4 Digital display In the digital display is indicated: ­ the level of hardness to which the water softener is set, ­ if the audible signals are activated/deactivated, ­ The number corresponding to the selected washing programme, ­ the approximate remaining time of the running programme, ­ the countdown of the delay start, ­ fault codes concerning malfunction of the appliance. In addition to the dishwashing programme selection and the half load option, the following functions can also be set with the help of these buttons. ­ the setting of the water softener, ­ the cancelling of a programme in progress, ­ deactivation/activation of the audible signals. Function buttons 5 Up and down programme selection buttons Using these two buttons you have an increasing or a decreasing order in the selection of the programme (see "Washing programmes" chart for the number of the programme). · Starting the washing programme: 1. Press the On/Off button. The indicator lights of the programme selection buttons start to flash and the number corresponding to the last performed washing programme will appear in the digital display. 2. To select a programme, press either one of the two programme selection buttons, until the number of chosen programme appears on the display. 3. Close the dishwasher's door, the programme will start automatically. · Cancel the washing programme in progress: 1. Open the dishwasher door. 2. Press the function buttons 2 and 3 simultaneously for about 2 seconds, the indicator lights of the programme selection buttons will start flashing. After about 2 seconds the indicator lights of the programme selection buttons will illuminate with a fixed light and 2 horizontal lines (- -) will appear in the digital display. 3. Switch off the machine by pressing the On/Off button or select a new washing programme (check that there is detergent in the detergent dispenser. The option must be linked to the selection of a washing programme. (See "Programme table" chart). When selected, the corresponding light illuminates. Load dishes in both baskets (lower and upper). When using the option reduce the dosage of detergent which is normally used for a complete load. Half load button 6 Delay start button This option allows the start of the programme to be delayed from 1 to 19 hours. After having selected the washing programme press the delay start button until the flashing number of the hours for the delay start will appear in the digital display. Close the dishwasher's door, the countdown starts automatically. The opening of the door will not modify or interrupt the countdown . Once the countdown has elapsed the washing programme will start automatically. Cancel the delay start in progress: To cancel a delay start in progress you have to reset the dishwasher; follow the same instructions given in "Cancel the washing programme in progress". IMPORTANT! Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to select the washing programme again. Indicator lights Salt refilling light Illuminates when special salt needs to be filled. It can remain illuminated several hours after the salt has been filled. Illuminates when rinse aid needs to be filled. Illuminates when the washing programme has ended. Rinse aid refilling light End of programme light Setting mode Press the On/Off button; if indicator lights of the programme selection buttons are illuminated and on the digital display are visible two horizontal lines the appliance is in setting mode. Always remember that when performing the following operations: ­ selecting a washing programme, ­ setting the water softener level, ­ activating/deactivating the audible signals, the appliance MUST be in setting mode. Press the On/Off button; If other button indicator lights are on and in the digital display is visible the number of a programme (1 - 2 - 3 etc..), this means that a washing programme has been set. In this case, to return to setting mode, the programme has to be cancelled (see instructions "Cancel a washing programme in progress"). 7 Audible signals Audible signals have been introduced to help indicate which operations the dishwasher is performing: ­ setting of the water softener, ­ end of the washing programme, ­ intervention of an alarm due to malfunction of the machine. Factory setting: audible signals activated It is possible to deactivate the audible signals. 2. Simultaneously press and hold function buttons B and C until the lights of function buttons A, B and C start flashing. 3. Press function button C, the lights of function buttons A and B turn off while the light of function button C goes on flashing. The digital display shows the current level. Audible signals deactivated Audible signals activated Deactivation/activation of the audible signals 1. Press the On/Off button. The dishwasher must be in setting mode. 4. To change the setting, press function button C again; the digital display will show the new setting. 5. 5. To memorize the operation, switch off the dishwasher by pressing the On/Off button. Washing programmes Programme 1 Rinse and hold No Half load Degree of soil Type of load Programme description 1 cold rinse (to avoid food scraps from sticking together). This programme does not require the use of detergent. Prewash Main wash 2 intermediate rinses Final rinse Drying Any. Partial load (to be completed later in the day). 2 Intensive 70° Yes 1) Heavy soil Crockery, cutlery, pots and pans 8 Programme 3 Auto 45° -70° No Half load Degree of soil Normal soil. Type of load Crockery and cutlery Programme description Prewash Main wash 1 or 2 intermediate rinses Final rinse Drying Main wash Final rinse Prewash Main wash 1 intermediate rinse Final rinse Drying Main wash 1 intermediate rinse Final rinse Drying 4 Quick 30 min. 65° 2) No Light soil Crockery and cutlery Crockery and cutlery 5 Bio 50° 3) Yes 4) Normal soil 6 Glass 45° No Normal soil Delicate crockery and glassware 1) When the Half load button is pressed, the prewash phase will be automatically excluded. In this case the detergent dose for the prewash phase is no longer necessary. 2) Ideal for washing a partially loaded dishwasher. This is perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. 3) Test programme for test institutes. 4) When the Half load button is pressed, the duration of the washing phase is reduced. "Auto" washing programme During the "Auto" washing programme the amount of soil on the dishes is determined by how cloudy the water is. If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash", "main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. For this reason the programme duration, water and energy consumption levels can vary within the stated range for "Auto" programme (see "Washing programmes chart"). During the "Auto" programme the temperature of the main wash water is also automatically adjusted between 45°C and 70°C depending on the amount of soil on the dishes. 9 First use Before using your dishwasher for the first time: · Ensure that the electrical and water connections comply with the installation instructions · Remove all packaging from inside the appliance · Set the water softener · Pour 1 litre of water inside the salt container and then fill with dishwasher salt · Fill the rinse aid dispenser Check whether these detergents are suitable for your water hardness. Follow the manufacturers instructions. ­ Set the water hardness to level 1. IMPORTANT! If the drying results are not satisfactory we recommend that you: 1. Fill up the rinse aid dispenser with rinse aid. 2. Set the rinse aid dosage to position 2. If you decide in future to use separated deterge ...