REFRIGERADOR REFRIGERATOR FRIGORIFICO ZFC 235 CL LIBRO DE INSTRUCCIONES 2222 134-34 INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES This document was created with FrameMaker 4.0.4 CONTENTS Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Rear spacers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Power connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Cleaning the appliance's interior . . . . . . . . . . . . . . . . . . . . . . . .page Door reversal directions . . . . . . . . . . . . . . . . . . . . . . . . . . .page Fitting the door panel . . . . . . . . . . . . . . . . . . . . . . . . . . .page Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Start-up - Temperature regulation . . . . . . . . . . . . . . . . . . . . . . .page Food refrigeration . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Hints for correct use . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Movable wire shelves . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Positioning the door shelves . . . . . . . . . . . . . . . . . . . . . . . . .page Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Refrigeration of drinks . . . . . . . . . . . . . . . . . . . . . . . . . . .page Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Interior light bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page Servicing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 10 11 11 11 11 11 12 12 13 13 13 13 13 14 14 14 15 15 15 Warning! The appliance which you have just bought is supplied not only with the instruction manual, but also with a Warranty Card Certificate, on the back of which are written the relative conditions. Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre covering the area in which the appliance is to be installed. (See list of Zanussi network centres). We congratulate you on your choice. Read this instruction manual carefully and follow the recommendations it provides to benefit from years of excellent service. The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please contact your nearest Zanussi Service Centre immediately. The address and telephone number of this Centre can be easily found in the enclosed List or by looking in the telephone directory, under Zanussi. Our Zanussi Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. 540 Closed door 550 43 Appliance height: 1240 mm 545 D266 Open door 1080 583 D267 9 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. Refer to relevant instructions. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. The inner lining of the appliance consists of channels through which the refrigerant passes. If these should be punctured this would damage the appliance beyond repair and cause food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. See defrost instructions. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. This appliance is heavy. Care should be taken when moving it. Ice lollies can cause frost burns if consumed straight from the appliance. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials; it must nevertheless be disposed of in a proper manner, in accordance with regulations for protection of the environment. 10 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Fig. 2 Location Place the appliance as far away as possible from sources of heat, e.g. radiators, heaters, direct sunlight, etc.. The best results are achieved with a room temperature ranging from +18°C to +38°C (class ST) or from +18°C to +43°C (class T). The class of your appliance is shown on its rating plate. Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For more efficient operation of the appliance the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm (Fig. 1-A). The best solution is shown in Fig. 1-B (without overhanging kitchen furniture). The appliance sides may also be in contact with the kitchen furniture, provided that air can circulate freely round the back and top. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. Fig. 1 100 mm min. A 45° D060 Power connection Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable. Make sure the plug and the socket are compatible so that no adaptors need to be used. If necessary, replace the socket with a suitable one. The appliance MUST be connected to an efficient earth or ground tap. The supply-lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. This appliance complies with the relevant UNI standards and with E.E.C. Directive No. 87/308 of 02.06.87 relative to radio interference suppression. This appliance complies with the following E.E.C. Directives: - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. A B D194 Rear spacers In the plastic envelope containing the Operating Instructions are also included two wall spacers to be fitted into the special openings provided on the back of the appliance (Fig. 2). Push-fit the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in (arrow in vertical position). Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the finish. 11 Door reversal directions Before starting work, unplug the appliance. To reverse the opening direction of the door proceed as follows: Remove the lower hinge (3), the pin (1), the washer (4) and the screw (2); slide the door out from the pin (5), remove the pin and place it on the opposite side; unscrew the foot front left and place it on the opposite side; unscrew the two screws which mask the holes for fixing the hinge on the front left side; reassemble the door; refit the lower hinge (turning it 180°), the washer, the pin and the screw on the opposite side, as shown in the figure. remove the handle, after having removed the screw cover and refit it on the opposite side. The holes that are not used must be masked with the plastic plugs removed. Attention After completion of the door reversibility operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D162 D547 D548 Fig. 3 5 Fig. 3a 4 3 0 18 ¡ 1 2 Fig. 3b Fitting the door panel (for models equipped with door frame) To fit the door panel, proceed as follows: ­ remove the fixing screws and remove the frame side opposite the handle; ­ loosen, without removing them, all remaining screws fixing the door frame; ­ insert the panel from the side on which the frame has been removed and push it fully in; ­ refit the frame side and tighten all the screws. Note The panel size should be 1-2 mm smaller than the door; the maximum permissible panel thickness is 4 mm. 12 USE Start-up - Temperature regulation After plugging in the appliance, turn the thermostat knob, located at the top right of the fridge, clockwise to the required position (beyond position «O» - off). A medium setting is recommended. Temperature is kept constant automatically and can be increased by turning the knob to lower numbers, or reduced by turning it to higher numbers. Proper setting is achieved by bearing in mind that the temperature inside the fridge depends on the following factors: room temperature; number of times the door is opened; amount of food stored; location of the appliance. To turn the appliance off, set the thermostat knob to «O». At the lowest temperature setting, when the appliance is full and room temperature is high, the compressor may operate continuously and frost forms on the evaporator of the frezeer compartment. In this case, turn the knob to a less cold setting so that the evaporator can be automatically defrosted with a lower power consumption. D040 Hints for correct use Raw meat: wrap in polythene bags and place on top of the salad crisper and, for safety, only store in this way for one or two days at the most. Cooked foods, cold dishes, etc.: these should be covered and stored on the fridge shelves. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom salad crisper. Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Movable wire shelves Fig. 4 The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. ...