REFRIGERADORCONGELADOR FRIGORIFICOCONGELADOR FRIDGE-FREEZER ZRD 23 SC MANUAL DE INSTRUÇÕES LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET 2223 329-72 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. Door reversibility Before carrying out any operations, remove the plug from the power socket. To change the opening direction of the door, proceed as follows: 1. Remove the lower hinge (1) and the support foot (2). 2. Unscrew the front left support foot (3) and screw it into the corresponding position on the opposite side. 3. Unscrew the two screws which hide the fixing holes of the hinge on the left-hand side. 4. Detach the lower door from the central hinge (H). 5. Remove the central hinge and detach the upper door from the pin (G). Unscrew the pin (G) and screw it into the corresponding position on the opposite side. 6. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. 7. Re-assemble the lower hinge (1) and the support foot (2) on the opposite side. The doors can be aligned by adjusting the middle hinge. The middle hinge can be adjusted horizontally, with the help of a tool, after having slackened the two screws. H G General Safety · This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product. It is dangerous to alter the specifications or modify this product in any way. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. This appliance is heavy. Care should be taken when moving it Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. For freezers only (except built-in models): an ideal location is the cellar or basement. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. · · Service Centre, and always insist on genuine spare parts. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. · · · · · Use · The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. Warning: when the ambient temperature is not included within the range indicated for the class of this appliance, the following instructions must be observed: when the ambient temperature drops below the minimum level, the storage temperature in the freezer compartment cannot be guaranteed; therefore it is advisable to use the food stored as soon as possible. · · Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. Refer to relevant instructions. The inner lining of the appliance consists of channels through which the refrigerant passes. If these should be punctured this would damage the appliance beyond repair and cause food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. 3 · · · Warning: After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. 2 D715 PIED/M 1 · · I · Service/Repair · Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local · I I · · 12 21 Shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers. B A Installation · During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the instructions. Attention: keep ventilation openings clear of obstruction. · Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E.E.C. Directives: - 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. · If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. Disposal of old Appliances The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. · · CONTENTS Warnings Use Cleaning the interior Operation Temperature regulation Fresh food refrigeration Movable shelves Positioning the door shelves Freezing calendar Freezing fresh food Storage of frozen food Thawing Ice-cube production Hints Hints for refrigeration Hints for freezing 12 14 14 14 14 14 14 14 15 15 15 15 15 16 16 16 Hints for storage of frozen food Maintenance Periodic cleaning Periods of no operation Interior light Defrosting Customer service and spare parts Technical information Installation Location Shelf holders Electrical connection Rear spacers Changing the opening direction of the doors 16 17 17 17 17 17 18 19 19 19 20 20 20 21 Rear spacers The plastic bag containing all relevant documentation also contains two rear wall spacers to be fitted into special slots on the back of the appliance. Fit the spacers into the slots, taking care to ensure that the arrow (A) is positioned as shown in the figure. Next, turn them through 45° (arrow in vertical position) until they lock into place. 45° PR60 A 20 13 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. · · · · room temperature; how often the door is opened; the quantity of food stored; location of appliance. TECHNICAL INFORMATION Net Fridge Capacity lt. Net Freezer Capacity lt. Energy Consumption kWh/24h Energy Consumption kWh/year Freezing Capacity 24h Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Rising time 186 44 1,049 383 3 19 A medium setting is generally the most suitable. Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. To stop operation, simply turn the thermostat knob to position «O» Dimensions mm High Width Depth The technical infomation are situated in the rating plate on the internal left side of the appliance . 1400 550 600 Fresh food refrigeration To obtain the best performance: · · · do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A). Ideally, however, the appliance should not be positioned below overhanging wall units (B). Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. 100 mm Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. A 10 mm B 10 mm NP004 D040 Attention It must be possible to disconnect the applianc ...