ZyAIR G-405 802.11g Wireless Ethernet Adapter Quick Installation Guide Version 1.0 March 2004 Procedure to View a Product's Certification(s) 1. Go to www.zyxel.com 2. Select your product from the drop-down list box on the ZyXEL home page to go to that product's page. 3. Select the certification you wish to view from this page. 1. Installation Requirements Before installation, make sure you have the following requirements. · · A computer with an RJ-45 Ethernet port and a CD-ROM drive Windows 98 SE/Me/2000/XP (for the ZyAIR Wireless Navigator) 2. Rear Panel and Port Connections The antenna connector is located on the rear panel of the ZyAIR. Screw the antenna clockwise onto the antenna connector. Make sure the antenna is securely screwed onto the antenna connector. 2 LABEL RESET DESCRIPTION You only need to use this button if you've forgotten the ZyAIR's password or the IP address is not known. It returns the ZyAIR to the factory defaults. Refer to the User's Guide. Use an Ethernet cable to connect to a computer (with an Ethernet card) or Ethernet device. The port is autonegotiating (can connect at 10 or 100 Mbps) and autocrossover (automatically adjusts to the type of Ethernet cable you use (straight-through or crossover)). Connect one end of the included power adaptor to this power socket. LAN DC-IN Use only the included power adaptor. 3. Check the LED Display After you make the hardware connections, check the LEDs on the ZyAIR. LED PWR COLOR Green STATUS On Blinking Orange On Off DESCRIPTION The ZyAIR is receiving power. The ZyAIR is rebooting or not ready. Power to the ZyAIR is too low or there is a hardware failure. The ZyAIR is not receiving power. 3 LED LAN COLOR Green STATUS On Blinking Off DESCRIPTION The ZyAIR has a successful Ethernet connection. The LAN port is sending/receiving data. The ZyAIR does not have an Ethernet connection. The ZyAIR is connected to a WLAN device. The WLAN port is sending/receiving data. The ZyAIR is not connected to a WLAN device. WLAN Green On Blinking Off 4. ZyAIR Wireless Navigator Installation The ZyAIR Wireless Navigator allows you to locate and configure the ZyAIR from any computer on the network. The installation procedures are similar for all supported Microsoft Windows versions. 1. After you have made the hardware connections. Insert the installation CD into your computer and run setup.exe in the Installation CD. 2. Specify a username and/or your company name and click Next. 3. Click Next to accept the default file location or click Browse to select an alternate folder. 4. Accept the default or specify the program folder in which the ZyAIR Navigator resides. Click Next. 5. Restart your computer when prompted and click Finish. Refer to the User's Guide to configure the ZyAIR. 4 Troubleshooting PROBLEM The PWR LED is off/orange. CORRECTIVE ACTION Make sure you are using only the supplied power adaptor and the power adaptor is plugged into an appropriate power supply. Unplug the power adaptor and plug it in again. If the error persists, you may have a hardware problem. In this case, you should contact your vendor. The LAN LED is off. Check the cable connection to the ZyAIR's LAN port. Make sure your computer's network card is working properly. or C ertifica tions . F or more informa tion a bout your devices Decla ra tion of C onformity (DO C ) plea s e refer to www. z yxel. com 5 ...